Transition metals, aqueous

In the fifth paper of this chapter on cathodes, an investigation of thin-film oxide-hydroxide electrodes containing Cr, Ni, and Co compounds was authored by N. Vlasenko et al. The thin-films were produced by electrochemical deposition from transition metal aqueous fluorine-containing electrolytes onto steel substrates. These thin-films were tested in Li coin cells. Electrochemical activity appears to scale with the amount of fluoride used in the deposition the larger concentration of fluoride in the bath, the greater the capacity. One Ni oxide-hydroxide film electrode showed greater than 175 mAh/g reversible capacity on the 50th cycle with excellent coulombic efficiency. 

Tin(ll) chloride, SnCl2, stannous chloride. M.p. 247 - C. While solid (Sn plus gaseous HCl), forms hydrates (SnCl2,2H20 is tin salt) from Sn and aqueous HCl. Acts as acceptor in complexes and forms complexes with transition metals. Used as a mordant. 

Manganese is the third most abundant transition metal, and is widely distributed in the earth s crust. The most important ore is pyrolusite, manganese(IV) oxide. Reduction of this ore by heating with aluminium gives an explosive reaction, and the oxide Mn304 must be used to obtain the metal. The latter is purified by distillation in vacuo just above its melting point (1517 K) the pure metal can also he obtained by electrolysis of aqueous manganese(II) sulphate. 

The complexes of copper(I) like those of silver(I) (p. 430), but unlike those of preceding transitions metals, tend to prefer a linear coordination of two ligands, i.e. X—Cu—X thus copper(I) chloride in aqueous ammonia gives the colourless [Cu(NH3)2] (readily oxidised in air to give blue [Cu (NH3)4(H20)2] copper(I) chloride in hydrochloric acid gives [CuClj], although [CuCl3] is also known. 

First, the use of water limits the choice of Lewis-acid catalysts. The most active Lewis acids such as BFj, TiQ4 and AlClj react violently with water and cannot be used However, bivalent transition metal ions and trivalent lanthanide ions have proven to be active catalysts in aqueous solution for other organic reactions and are anticipated to be good candidates for the catalysis of aqueous Diels-Alder reactions. 

The aromatic shifts that are induced by 5.1c, 5.If and S.lg on the H-NMR spectrum of SDS, CTAB and Zn(DS)2 have been determined. Zn(DS)2 is used as a model system for Cu(DS)2, which is paramagnetic. The cjkcs and counterion binding for Cu(DS)2 and Zn(DS)2 are similar and it has been demonstrated in Chapter 2 that Zn(II) ions are also capable of coordinating to 5.1, albeit somewhat less efficiently than copper ions. Figure 5.7 shows the results of the shift measurements. For comparison purposes also the data for chalcone (5.4) have been added. This compound has almost no tendency to coordinate to transition-metal ions in aqueous solutions. From Figure 5.7 a number of conclusions can be drawn. (1) The shifts induced by 5.1c on the NMR signals of SDS and CTAB... 

Peroxohydrates are usually made by simple crystallization from solutions of salts or other compounds in aqueous hydrogen peroxide. They are fairly stable under ambient conditions, but traces of transition metals catalyze the Hberation of oxygen from the hydrogen peroxide. Early work on peroxohydrates has been reviewed (92). 

Chemical, or abiotic, transformations are an important fate of many pesticides. Such transformations are ubiquitous, occurring in either aqueous solution or sorbed to surfaces. Rates can vary dramatically depending on the reaction mechanism, chemical stmcture, and relative concentrations of such catalysts as protons, hydroxyl ions, transition metals, and clay particles. Chemical transformations can be genetically classified as hydrolytic, photolytic, or redox reactions (transfer of electrons). 

Zincon disodium salt (o-[l-(2-bydroxy-5-sulfo)-3-pbenyl-5-formazono]-benzoic acid di-Na salt) [135-52-4, 56484-13-0] M 484.4, m -250-260 (dec). Zincon soln is prepared by dissolving 0.13g of the powder in aqueous N NaOH (2mL diluted to lOOmL with H2O). This gives a deep red colour which is stable for one week. It is a good reagent for zinc ions but also forms stable complexes with transition metal ions. [UV-VIS Bush and Yoe Anal Chem 26 1345 1954 Hunter and Roberts J Chem Soc 820 1941 Platte and Marcy Anal Chem 31 1226 1959] The free acid has been recrystd from dilute H2SO4. [Fichter and Scheiss Chem Ber 33 751 1900.]... 

One of the most dramatic developments in the chemistry of N2 during the past 30 years was the discovery by A. D. Allen and C. V. Senoff in 1965 that dinitrogen complexes such as [Ru(NH3)5(N2)1 could readily be prepared from aqueous RUCI3 using hydrazine hydrate in aqueous solution. Since that time virtually all transition metals have been found to give dinitrogen complexes and several hundred such compounds are now characterized.Three general preparative methods are available ... 

Lower oxidation states are rather sparsely represented for Zr and Hf. Even for Ti they are readily oxidized to +4 but they are undoubtedly well defined and, whatever arguments may be advanced against applying the description to Sc, there is no doubt that Ti is a transition metal . In aqueous solution Ti can be prepared by reduction of Ti, either with Zn and dilute acid or electrolytically, and it exists in dilute acids as the violet, octahedral [Ti(H20)6] + ion (p. 970). Although this is subject to a certain amount of hydrolysis, normal salts such as halides and sulfates can be separated. Zr and are known mainly as the trihalides or their derivatives and have no aqueous chemistry since they reduce water. Table 21.2 (p. 960) gives the oxidation states and stereochemistries found in the complexes of Ti, Zr and Hf along with illustrative examples. (See also pp. 1281-2.)... 

The distinction between the first member of the group and the two heavier members, which was seen to be so sharp in the early groups of transition metals, is much less obvious here. The only unsubstituted, discrete oxoanions of the heavier pair of metals are the tetrahedral [Ru 04] and [Ru 04]. This behaviour is akin to that of iron or, even more, to that of manganese, whereas in the osmium analogues the metal always increases its coordination number by the attachment of extra OH ions. If RUO4 is dissolved in cold dilute KOH, or aqueous K2RUO4 is oxidized by chlorine, virtually black crystals of K[Ru 04] ( permthenate ) are deposited. These are unstable unless dried and are reduced by water, especially if alkaline, to the orange... 

The coordination chemistry of Zn" and Cd", although much less extensive than for preceding transition metals, is still appreciable. Neither element forms stable fluoro complexes but, with the other halides, they form the complex anions [MX3] and [MX4] , those of Cd" being moderately stable in aqueous solution. "" By using the large cation [Co(NH3)6] + it is also possible to isolate the trigonal bipyramidal [CdCls] "... 

Pyridine bases are well known as ligands in complexes of transition metals, and it might well be anticipated that the equilibrium constants for the formation of such complexes, which are likely to be closely related to the base strength, would follow the Hammett equation. Surprisingly, only very few quantitative studies of such equilibria seem to have been reported, and these only for very short series of compounds. Thus, Murmann and Basolo have reported the formation constants, in aqueous solution at 25°, of the silver(I) complexes... 

Yosida et al. [41] found that p-t< rr-butylcalix[6]ar-ene can extract Cu from the alkaline-ammonia solution to the organic solvent. Nagasaki and Shinkai [42] described the synthesis of carboxyl, derivatives of calix-[n]arenes ( = 4 and 6) and their selective extraction capacity of transition metal cations from aqueous phase to the organic phase. Gutsche and Nam [43] have synthesized various substituted calix[n]arenes and examined the complexes of the p-bromo benzene sulfonate of p-(2-aminoethyl)calix[4]arene with Ni, Cu , Co-, and Fe. ... 

Recently, Deligoz and Yilmaz [51] prepared three polymeric calix[4]arenes, which were synthesized by reacting chloromethylated polystyrene with 25,26,27-tribenzoyloxy-28-hydroxy calix[4]arene (2a, 3a) and po-lyacryloyl chloride with 25,26,27,28-tetraacetoxy ca-lix[4]arene (4a). After alkaline hydrolysis of the polymers, they were utilized for selective extraction of transition metal cations from aqueous phase to organic phase. 

Deligoz and Yilmaz [52] reported that the selective liquid-liquid extraction of various alkali and transition metal cations from the aqueous phase to the organic phase as carried out by using p-tert-h iy calix[4]arene (1), p-tert-b x. y calix[6]arene (2), tetra-ethyl-p-tm-butylcalix[4]arene-tetra-acetate (3), tetra-methyl-p-/< /-/-butyl calix[4]arene-tetraketone (4), calix[n]arenes ( = 4 and 6) bearing oxime groups on the lower rim (5 and 6) and a polymeric calix(4]arene (8). It was found that compounds 5 and 6 showed selectivity towards Ag, Hg, Hg, Cu, and Cr and the order of the ex-tractability was Hg > Hg > Ag > Cu > Cr. The polymeric calix[4]arene (8) was selective for Ag, Hg, and Hg , unlike its monomeric analog. 

The complex cyanides of transition metals, especially the iron group, are very stable in aqueous solution. Their high co-ordination numbers mean the metal core of the complex is effectively shielded, and the metal-cyanide bonds, which share electrons with unfilled inner orbitals of the metal, may have a much more covalent character. Single electron transfer to the ferri-cyanide ion as a whole is easy (reducing it to ferrocyanide, with no alteration of co-ordination), but further reduction does not occur. 

Cherges of transition metal cetions commonly found in aqueous solution. 

Color. Many solid compounds of the transition metals and their aqueous solutions are colored. This color indicates light is absorbed in... 

Both silylmagnesium and silylaluminium species add to terminal alkynes in the presence of a transition-metal catalyst with high regio- and stereoselectivity. For example, platinum-catalysed silamagnesiation (3) followed by aqueous quenching provides exclusively ( )-l-silylalk-l-enes. 

---