Titanium , catalytic activity

Titanium Silicates. A number of titanium siUcate minerals are known (160) examples are Hsted in Table 19. In most cases, it is convenient to classify these on the basis of the connectivity of the SiO building blocks, eg, isolated tetrahedra, chains, and rings, that are typical of siUcates in general. In some cases, the SiO units may be replaced, even if only to a limited extent by TiO. For example, up to 6% of the SiO in the garnet schorlomite can be replaced by TiO. In general, replacement of SiO by TiO bull ding blocks increases the refractive indices of these minerals. Ti has also replaced Si in the framework of various zeofltes. In addition, the catalytic activity of both titanium-substituted ZSM-5 (TS-1) and ZSM-11 (TS-2) has received attention (161), eg, the selective oxidation of phenol, with hydrogen peroxide, to hydroquinone and catechol over TS-1 has been operated at the 10,000 t/yr scale in Italy (162). 

Another chiral titanium reagent, 11, was developed by Corey et al. [17] (Scheme 1.24). The catalyst was prepared from chiral ris-N-sulfonyl-2-amino-l-indanol and titanium tetraisopropoxide with removal of 2-propanol, followed by treatment with one equivalent of SiCl4, to give the catalytically-active yellow solid. This catalyst is thought not to be a simple monomer, but rather an aggregated species, as suggested by NMR study. Catalyst 11 promotes the Diels-Alder reaction of a-bro-moacrolein with cyclopentadiene or isoprene. 

We employed malononitrile and l-crotonoyl-3,5-dimethylpyrazole as donor and acceptor molecules, respectively. We have found that this reaction at room temperature in chloroform can be effectively catalyzed by the J ,J -DBFOX/Ph-nick-el(II) and -zinc(II) complexes in the absence of Lewis bases leading to l-(4,4-dicya-no-3-methylbutanoyl)-3,5-dimethylpyrazole in a good chemical yield and enantio-selectivity (Scheme 7.47). However, copper(II), iron(II), and titanium complexes were not effective at all, either the catalytic activity or the enantioselectivity being not sufficient. With the J ,J -DBFOX/Ph-nickel(II) aqua complex in hand as the most reactive catalyst, we then investigated the double activation method by using this catalyst. 

A model for the catalytically active species in the Sharpless epoxidation reaction is formulated as a dimer 3, where two titanium centers are linked by two chiral tartrate bridges. At each titanium center two isopropoxide groups of the original tetraisopropoxytitanium-(IV) have been replaced by the chiral tartrate ligand ... 

The reaction is limited to allylic alcohols other types of alkenes do not or not efficiently enough bind to the titanium. The catalytically active chiral species can be regenerated by reaction with excess allylic alcohol and oxidant however the titanium reagent is often employed in equimolar amount. 

Milling in a ball-mill (10, 149). In the activation of TiCl2 by ballmilling the average oxidation number of the titanium ions was changed however there was no dependence evident between the catalytic activity and the content of Ti(II) in the catalyst the proportional dependence of the activity on the specific surface was not observed either (10). 

By quenching the polymerization with C1402 or Cl40 the determination of the number of propagation rate constants was found to be also possible for the two-component catalytic system TiCl2 + AlEt2Cl 158, 159). In contrast to alcohols, carbon dioxide and carbon monoxide under polymerization conditions react only with titanium-carbon active bonds and do not react with inactive aluminum-polymer bonds. 

The dissociation of coordinatively sufficient organometallic complexes in solution. For instance, for the system based on cyclopentadienyl complexes of titanium the active centers of catalytic polymerization (C Hj) -TiR]+ are caused by the following process (178, 179) ... 

Many references relate to polyesterifications catalyzed by tetraalkoxy - particularly te-trabutoxy - titaniums, and the catalytic activity of these compounds is daimed in many... 

All these observations show that the catalytic activity of tetrabutoxytitanium depends on the composition of the medium used. When alcohol is used in excess, the catalyst is in a favourable neighbourhood since titanium can be complexed by two alcohol molecules. 

Several aluminum- and titanium-based compounds have been supported on silica and alumina [53]. Although silica and alumina themselves catalyze cycloaddition reactions, their catalytic activity is greatly increased when they complex a Lewis acid. Some of these catalysts are among the most active described to date for heterogeneous catalysis of the Diels-Alder reactions of carbonyl-containing dienophiles. The Si02-Et2AlCl catalyst is the most efficient and can be... 

The guanidinate-supported titanium imido complex [Me2NC(NPr02l2Ti = NAr (Ar = 2,6-Me2C6H3) (cf. Section IILB.2) was reported to be an effective catalyst for the hydroamination of alkynes. The catalytic activity of bulky amidinato bis(alkyl) complexes of scandium and yttrium (cf. Section III.B.l) in the intramolecular hydroamination/cyclization of 2,2-dimethyl-4-pentenylamine has been investigated and compared to the activity of the corresponding cationic mono(alkyl) derivatives. 

Amidinate complexes of copper(I) and copper(II) have been found to catalyze the polymerization of carbodiimides. The copper catalysts are highly active even under air and oxygen. It was shown that the catalytic activity of an air-stable copper(II) amidinato complex is almost equal to that of reported air-sensitive titanium(IV) amidinate initiators. Scheme 225 illustrates the proposed reaction mechanism. ... 

As shown in Table IV, the highest catalytic activity of metal halides used as Lewis acid for the alkylation reaction of ferrocene with 2 was observed in methylene chloride solvent. Among Lewis acids such as aluminum chloride, aluminum bromide, and Group 4 transition metal chlorides (TiCl4, ZrCU, HfCU), catalytic efficiency for the alkylation decrea.ses in the following order hafnium chloride > zirconium chloride > aluminum chloride > aluminum bromide. Titanium chloride... 

Synthesis, eharacterization and catalytic activity of titanium containing mesoporous materials with TS-1 wall structure... 

Titanium containing hexagonal mesoporous materials were synthesized by the modified hydrothermal synthesis method. The synthesized Ti-MCM-41 has hi y ordered hexa rud structure. Ti-MCM-41 was transformed into TS-l/MCM-41 by using the dry gel conversion process. For the synthesis of Ti-MCM-41 with TS-1(TS-1/MCM-41) structure TPAOH was used as the template. The synthesized TS-l/MCM-41 has hexagonal mesopores when the DGC process was carried out for less than 3 6 h. The catalytic activity of synthesized TS-l/MCM-41 catalysts was measured by the epoxidation of 1-hexene and cyclohexene. For the comparison of the catalytic activity, TS-1 and Ti-MCM-41 samples were also applied to the epoxidation reaction under the same reaction conditions. Both the conversion of olefins and selectivity to epoxide over TS-l/MCM-41 are found hi er flian those of other catalysts. 

Battery applications Titanium containing y-Mn02 (TM) hollow spheres synthesis and catalytic activities in Li-air batteries [123] Orthorhombic LiMn02 nanorods for lithium ion battery application [124] Electrochemical characterization of MnOOH-carbon nanocomposite cathodes for metal—air batteries [125] Electrocatalytic activity of nanosized manganite [126]... 

While it is beyond the scope of this chapter to cover the asymmetric hydrosilylation of ketones and imines in any detail, a number of the more catalytically active ML combinations will be mentioned here. A full review of the area has recently appeared.138 Asymmetric hydrosilylation of carbonyl groups is usually performed with rhodium or titanium catalysts bearing chelating N- or P-based ligands. Representative results for some of the most active Rh/L combinations (Scheme 32) for addition of Si H to acetophenone are given in Table 11. 

Heat-flow calorimetry may be used also to detect the surface modifications which occur very frequently when a freshly prepared catalyst contacts the reaction mixture. Reduction of titanium oxide at 450°C by carbon monoxide for 15 hr, for instance, enhances the catalytic activity of the solid for the oxidation of carbon monoxide at 450°C (84) and creates very active sites with respect to oxygen. The differential heats of adsorption of oxygen at 450°C on the surface of reduced titanium dioxide (anatase) have been measured with a high-temperature Calvet calorimeter (67). The results of two separate experiments on different samples are presented on Fig. 34 in order to show the reproducibility of the determination of differential heats and of the sample preparation. 

---