Equilibrium constants thermodynamic

The true thermodynamic equilibrium constant is a function of activity rather than concentration. The activity of a species, a, is defined as the product of its molar concentration, [A], and a solution-dependent activity coefficient, Ya. 

The true thermodynamic equilibrium constant, Ksp, for the solubility of AglOa, therefore, is... 

Several features of equation 6.50 deserve mention. First, as the ionic strength approaches zero, the activity coefficient approaches a value of one. Thus, in a solution where the ionic strength is zero, an ion s activity and concentration are identical. We can take advantage of this fact to determine a reaction s thermodynamic equilibrium constant. The equilibrium constant based on concentrations is measured for several increasingly smaller ionic strengths and the results extrapolated... 

A quantitative solution to an equilibrium problem may give an answer that does not agree with the value measured experimentally. This result occurs when the equilibrium constant based on concentrations is matrix-dependent. The true, thermodynamic equilibrium constant is based on the activities, a, of the reactants and products. A species activity is related to its molar concentration by an activity coefficient, where a = Yi[ ] Activity coefficients often can be calculated, making possible a more rigorous treatment of equilibria. 

In this experiment the equilibrium constant for the dissociation of bromocresol green is measured at several ionic strengths. Results are extrapolated to zero ionic strength to find the thermodynamic equilibrium constant. Equilibrium Constants for Calcium lodate Solubility and Iodic Acid Dissociation. In J. A. Bell, ed. Chemical Principles in Practice. Addison-Wesley Reading, MA, 1967. 

From a general point of view, the tautomeric studies can be divided into 12 areas (Figure 20) depending on the migrating entity (proton or other groups, alkyl, acyl, metals. ..), the physical state of the study (solid, solution or gas phase) and the thermodynamic (equilibrium constants) or the kinetic (isomerization rates) approach. 

Equations (9.7) and (9.8) define K, the equilibrium constant for the reaction.b It is sometimes referred to as the thermodynamic equilibrium constant. As we shall see, this ratio of activities can be related to ratios of pressure or concentration which, themselves, are sometimes called equilibrium constants. But K, as defined in equations (9.7) and (9.8), is the fundamental form that is directly related to the free energy change of the reaction. 

It is important to note that, for any given temperature, the [thermodynamic] equilibrium constant is directly related to the standard change in free energy. Since, at any given temperature, the free energy in the standard state for each reactant and product, G°, is independent of the pressure, it follows that the standard change in free energy for the reaction, AfG°, is independent of the pressure.g Therefore, at constant temperature, the equilibrium constant K. .. is also independent of the pressure. That is,... 

The ambiguity results from the failure to recognize that the Rossini statement applies to the thermodynamic equilibrium constant, As we have already noted, the other forms that we have derived do depend upon the pressure. For example, for a gas phase reaction, Kp is related to K by equation (9.11)... 

Figure 9.1 is a graph of equation (9.52) showing how K varies with pressure at 298.15 K. We see that it increases by a factor of approximately 2 as the pressure increases by a factor of 1000. The increase is due to the change in the activity of the water rather than to a change in the thermodynamic equilibrium constant with pressure. 

The reactant mixture may be so nonideal that Equation (7.28) is inadequate. The rigorous thermodynamic approach is to replace the concentrations in Equation (7.28) with chemical activities. This leads to the thermodynamic equilibrium constant. 

As previously noted, the equilibrium constant is independent of pressure as is AG. Equation (7.33) applies to ideal solutions of incompressible materials and has no pressure dependence. Equation (7.31) applies to ideal gas mixtures and has the explicit pressure dependence of the F/Fq term when there is a change in the number of moles upon reaction, v / 0. The temperature dependence of the thermodynamic equilibrium constant is given by... 

For nonideal solutions, the thermodynamic equilibrium constant, as given by Equation (7.29), is fundamental and Ei mettc should be reconciled to it even though the exponents in Equation (7.28) may be different than the stoichiometric coefficients. As a practical matter, the equilibrium composition of nonideal solutions is usually found by running reactions to completion rather than by thermodynamic calculations, but they can also be predicted using generalized correlations. 

FIGURE 7.5 Thermodynamic equilibrium constant for gas-phase reactions. (From Smith, J. M. and Van Ness, H. C., Introduction to Chemical Engineering Thermodynamics, 4th Ed., McGraw-Hill, New York, 1986.)... 

Suppose the numerical value of the thermodynamic equilibrium constant is known, say from the free energy of formation. Then Equation (7.40) is substituted into Equation (7.31) and the result is solved for s. 

Examples 7.12 and 7.13 treated the case where the kinetic equilibrium constant had been determined experimentally. The next two examples illustrate the case where the thermodynamic equilibrium constant is estimated from tabulated data. 

The kinetic equilibrium constant is estimated from the thermodynamic equilibrium constant using Equation (7.36). The reaction rate is calculated and compositions are marched ahead by one time step. The energy balance is then used to march enthalpy ahead by one step. The energy balance in Chapter 5 used a mass basis for heat capacities and enthalpies. A molar basis is more suitable for the current problem. The molar counterpart of Equation (5.18) is... 

Thermodynamic equilibrium constant calculated as in Example 7.15 KO = Exp(-DeltaGRO/Rg/TO)... 

Consequences of the Snyder and Soczewinski model are manifold, and their praetieal importance is very signifieant. The most speetaeular conclusions of this model are (1) a possibility to quantify adsorbents ehromatographic activity and (2) a possibility to dehne and quantify chromatographic polarity of solvents (known as the solvents elution strength). These two conclusions could only be drawn on the assumption as to the displacement mechanism of solute retention. An obvious necessity was to quantify the effect of displacement, which resulted in the following relationship for the thermodynamic equilibrium constant of adsorption, K,, in the case of an active chromatographic adsorbent and of the monocomponent eluent ... 

We omit concentrations of pure solids and pure liquids from equilibrium constant expressions because their activity is taken to be 1 and the thermodynamic equilibrium constant involves activities, rather than concentrations. 

Pressures of gases and molarities of solutes in aqueous solution appear in thermodynamic equilibrium constant expressions. Pure solids and liquids (including solvents) do not appear. 

In writing the thermodynamic equilibrium constant, recall that neither pure solids (PbS(s) and S(s)) nor pure liquids (H20(1)) appear in the thermodynamic equilibrium constant expression. Note also that we have written H+(aq) here for brevity even though we understand that H30+(aq) is the acidic species in aqueous solution. 

C) eq is the symbol for the thermodynamic equilibrium constant in this expression gases are represented by pressures and solutes in aqueous solution by molarities. 

In this expression, the square brackets refer to the activity of the component although it is more convenient to use its concentration. This approximation is generally satisfactory, except at very high concentrations, and is particularly suitable for analytical use. Where it is necessary to distinguish between the constant obtained using concentrations and the true thermodynamic equilibrium constant Ka the former may be termed the equilibrium quotient and assigned the symbol Q. The exact relation between Ke and Q has been the subject of much investigation and speculation. In this... 

The conditional equilibrium constant may be defined in terms of the true thermodynamic equilibrium constant KML and the appropriate values of a. 

Under these conditions, the formation rate constant, k, can be estimated from the product of the outer sphere stability constant, Kos, and the water loss rate constant, h2o, (equation (28) Table 2). The outer sphere stability constant can be estimated from the free energy of electrostatic interaction between M(H20)q+ and L and the ionic strength of the medium [5,164,172,173]. Consequently, Kos does not depend on the chemical nature of the ligand. A similar mechanism will also apply to a coordination complex with polydentate ligands, if the rate-limiting step is the formation of the first metal-ligand bond [5]. Values for the dissociation rate constants, k, are usually estimated from the thermodynamic equilibrium constant, using calculated values of kf ... 

---