Tetrahydrofuran diastereoselective addition

The substrate-controlled diastereoselective addition of lithiated alkoxyallenes to chiral nitrones such as 123, 125 and 126 (Scheme 8.32) furnish allenylhydroxyl-amines as unstable products, which immediately cydize to give enantiopure mono-orbicyclic 1,2-oxazines (Eqs 8.25 and 8.26) [72, 76]. Starting with (R)-glyceraldehyde-derived nitrone 123, cydization products 124 were formed with excellent syn selectivity in tetrahydrofuran as solvent, whereas precomplexation of nitrone 123 with... 

S)-2-Amino-3-methylbutanol [(S)-valinol] derived oxazolidinones, i.e., (S)-3-acyl-4-iso-propyl-2-oxazolidinones 1, have been used extensively for the preparation of a-alkylated acids, aldehydes and alcohols. The enolates are formed by deprotonation with lithium diisopropyl-amide or sodium hexamethyldisilazanide at low temperature in tetrahydrofuran. Subsequent addition of a haloalkane gives alkylation, which occurs from the Si-face2. The diastereoselectivities are usually good (>90 10), and the products are usually purified by flash chromatography and/or recrystallization (see Table 10). Additional examples of alkylation of 1 have been published5 l0 12- 20 22-29 39.44.-47,49.57.70-78... 

Diastereoselective addition of chiral (E)-crotylsilanes to RCHO tetrahydrofurans.1 BFj etherate is the most efficient Lewis acid promotor for diastereoselective addition of a-substituted /3-silyl-(E)-crotylsilancs (1) to a- and /3-benzyloxy aldehydes to form... 

In addition to the boron trifluoride-diethyl ether complex, chlorotrimcthylsilanc also shows a rate accelerating effect on cuprate addition reactions this effect emerges only if tetrahydrofuran is used as the reaction solvent. No significant difference in rate and diastereoselectivity is observed in diethyl ether as reaction solvent when addition of the cuprate, prepared from butyllithium and copper(I) bromide-dimethylsulfide complex, is performed in the presence or absence of chlorotrimethylsilane17. If, however, the reaction is performed in tetrahydrofuran, the reaction rate is accelerated in the presence of chlorotrimethylsilane and the diastereofacial selectivity increases to a ratio of 88 12 17. In contrast to the reaction in diethyl ether, the O-silylated product is predominantly formed in tetrahydrofuran. The alcohol product is only formed to a low extent and showed a diastereomeric ratio of 55 45, which is similar to the result obtained in the absence of chlorotrimethylsilane. This discrepancy indicates that the selective pathway leading to the O-silylated product is totally different and several times faster than the unselective pathway" which leads to the unsilylated alcohol adduct. A slight further increase in the Cram selectivity was achieved when 18-crown-6 was used in order to increase the steric bulk of the reagent. 

The addition of vinylmagnesium bromide to methyl (S)-3-benzyloxy-4-oxobutanoate (5) in tetrahydrofuran proceeded with a slight preference for the nonchelation-controlled reaction product (40 60)5°. A reversal of the diastereoselectivity (80 20) could be observed when the Grignard reagent, as a solution in tetrahydrofuran, was added to a dichloromethane solution of the aldehyde which had been precomplexed with one equivalent of magnesium bromide. The almost exclusive formation of the chelation-controlled reaction product 6 was achieved when tetrahydrofuran was completely substituted by dichloromethane the presence of tetrahydrofuran interferes with the formation of the chelate complex, which is a prerequisite for high chelation-controlled diastereoselection. 

Addition of alkynes to a-alkoxy aldehydes is most favorably performed with the corresponding zinc reagents (Table 12)46. As with Grignard reagents, the chelation-controlled addition of zinc alkynes proceeds with higher diastereoselectivity when diethyl ether rather than tetrahydrofuran is used as reaction solvent. 

The nucleophilic addition of Grignard reagents to a-epoxy ketones 44 proceeds with remarkably high diastereoselectivity70. The chelation-controlled reaction products are obtained in ratios >99 1 when tetrahydrofuran or tetrahydrofuran/hexamethylphosphoric triamide is used as reaction solvent. The increased diastereoselectivity in the presence of hexamethylphos-phoric triamide is unusual as it is known from addition reactions to a-alkoxy aldehydes that co-solvents with chelating ability compete with the substrate for the nucleophile counterion, thus reducing the proportion of the chelation-controlled reaction product (vide infra). 

With respect to the nucleophilic addition of organocopper reagents, a sharp contrast between the rigid isopropylidene glyceraldehyde and its open-chained analog, 2,3-bis(benzyloxy)propanal. was observed (compare Tables 15 and 16). With the isopropylidene-protected aldehyde a high syn diastereoselectivity could only be obtained when tetrahydrofuran was used as reaction solvent, and the diastereoselectivity dropped considerably in diethyl ether. In contrast, the latter solvent allows excellent syn selectivities in additions to the dibenzyl-protected glyceraldehyde81. On the other hand, tetrahydrofuran yields better results than diethyl ether in the... 

Good to excellent diastereoselectivities have been reported when 2-(trimethylsilyl)thiazole (3), an effective equivalent of an aldehyde group, is used as nucleophile24,27. Thus, addition to TV-Boc-protected amino aldehydes in dichloromethane at — 30 C afforded mixtures of amino alcohols in comparatively good yields with reasonable syn selectivity. However, the stereoselectivity decreased substantially when the reaction was carried out in tetrahydrofuran at 25 °C. 

Although lithium aldolates generally display a rather moderate preference for the u/f/z-isomer4, considerable degrees of diastereoselectivity have been observed in the reversible addition of doubly deprotonated carboxylic acids to aldehydes20. For example, the syn- and uw/z-alkox-ides, which form in a ratio of 1.9 1 in the kinctically controlled aldol addition, equilibrate in tetrahydrofuran at 25 C after several hours to a 1 49 mixture in favor of the anti-product20. 

The present method is practical and efficient as it employs readily available enantioenriched propargylic alcohols as precursors to the allenylindium reagents. With achiral aldehydes the diastereoselectivity is high for branched aldehydes, moderate for unbranched aldehydes, and low for benzaldehyde (Table I). With cHral a-methyl aldehydes the additions proceed under effective reagent control to afford anti adducts of high ee and with excellent diastereoselectivity (eq. 1 and 2). Comparable results were obtained with 3 1 dimethyl sulfoxide-tetrahydrofuran (DMSO-THF) as the solvent. 

Diastereoselective ring opening of mono- and bicyclic anhydrides with sodium (S)-4-isopropyl-2-thioxothiazolidinide is an attractive alternative 10°. Aminolyses are carried out in tetrahydrofuran at low temperatures in a 1 1 molar ratio in the absence or presence of additives such as HMPA, TMEDA or DMSO. High yield and diastereoselectivity are recorded in the case of 4-cyclohexene-1,2-dicarboxylic anhydride. /... 

Permanganese is a common oxidative reagent, the application of which to the asymmetric oxidative cyclization of 1,5-dienes has been reported by Brown (Scheme 3.14). The addition of acetic acid is quite important for the reaction to proceed, and highly functionalized tetrahydrofurans are obtained in a range of 58 to 75% ee, in diastereoselective manner [35]. Another oxidative transformation using KMn04 with a chiral ammonium salt has been investigated. Scheme 3.15 illustrates the asymmetric dihydroxylation of electron-deficient olefins to chiral diols in the... 

The conjugate addition of the radical generated from i-PrI by BnsSnH (2.43) to a,P-unsaturated ketone 2.56 takes place diastereoselectively in the presence of Lewis acid such as Yb(OTf)3 to give addition products 2.57 and 2.58 in CH2CI2 and THF (tetrahydrofuran in 4 1 ratio). 

---