Sulfuric acid structure

Cu-UPD on Au(m) in sulfuric acid-structural aspects The UPD of Cu on Au(lll) in sulfuric acid electrolyte has been studied using (1) classical... 

A new dimension to acid-base systems has been developed with the use of zeolites. As illustrated in Fig. XVIII-21, the alumino-silicate faujasite has an open structure of interconnected cavities. By exchanging for alkali metal (or NH4 and then driving off ammonia), acid zeolites can be obtained whose acidity is comparable to that of sulfuric acid and having excellent catalytic properties (see Section XVIII-9D). Using spectral shifts, zeolites can be put on a relative acidity scale [195]. An important added feature is that the size of the channels and cavities, which can be controlled, gives selectivity in that only... 

Toney M F, Howard J N, Richer J, Borges G L, Gordon J G, Melroy O R, Yee D and Sorenson L B 1995 Electrochemical deposition of copper on a gold electrode in sulfuric acid Resolution of the interfacial structure Phys. Rev. Lett. 75 4472-5... 

Write a structural formula for the compound formed on elec trophilic addition of sulfuric acid to cyclohexene (step 1 in the two step transfer mation shown in the preceding equation)... 

On being heated with sulfur trioxide in sulfuric acid 124 5 tetramethylbenzene was converted to a product of molecular formula C10H14O3S m 94% yield Suggest a reasonable structure for this product... 

Treatment of biphenyl (see Section 11 7 to remind yourself of its structure) with a mixture of nitric acid and sulfuric acid gave two principal products both having the molecular formula C12H9NO2 What are these two products ... 

When benzene is prepared from coal tar it is contaminated thiophene from which it cannot be separated by distillation because of very similar boiling points Shaking a mixture of benzene and thiophene with sulfuric acid causes sulfonation of the thiophene ring but leaves benzene untouched The sulfonation product of thiophene dissolves m the sulfuric acid layer from which the benzene layer is separated the benzene layer is then washed with water and distilled Give the structure of the sulfonation product of thiophene... 

Treatment of the alcohol whose structure is shown here with sulfuric acid gave as the major organic product a tncychc hydrocarbon of molecular formula CigHig Suggest a reasonable struc ture for this hydrocarbon... 

Nitration of a series of methyl-1,2-benzisoxazoles was studied by Tahkar and Bhawal using fuming nitric acid and sulfuric acid in acetic acid at 100 °C. 3-Methyl-1,2-benzisoxazole gave a mixture of 5-nitro- and 5,7-dinitro-3-methyl-l,2-benzisoxazole, with the 5-nitro isomer predominant. The product obtained from 3,5-dimethyl-1,2-benzisoxazole was the 4-nitro derivative and not the 7-nitro compound as proposed by Lindemann (26LA(449)63). The synthesis of the 7-nitro compound by an alternative method was used as structural proof. Two products were obtained from 3,6-dimethyl-l,2-benzisoxazole and these were the 5-nitro and 5,7-dinitro derivatives. 3,7-Dimethyl-l,2-benzisoxazole was converted into the 5-nitro derivative (Scheme 25) (77lJC(B)l06l). 

The effect of impurities in either structural material or corrosive material is so marked (while at the same time it may be either accelerating or decelerating) that for rehable results the actual materials which it is proposed to use should be tested and not types of these materials. In other words, it is much more desirable to test the actual plant solution and the actual metal or nonmetal than to rely upon a duphcation of either. Since as little as 0.01 percent of certain organic compounds will reduce the rate of solution of steel in sulfuric acid 99.5 percent and 0.05 percent bismuth in lead will increase the rate of corrosion over 1000 percent under certain conditions, it can be seen how difficult it would be to attempt to duplicate here all the significant constituents. 

Gearhart, J. M., and Schlesinger, R. B. (1989). Sulfuric acid-induced changes in the physiology and structure of the tracheobronchial airways. Environ. Health Perspect. 79, 127-137. 

Nitric oxide is the simplest thermally stable odd-electron molecule known and, accordingly, its electronic structure and reaction chemistry have been very extensively studied. The compound is an intermediate in the production of nitric acid and is prepared industrially by the catalytic oxidation of ammonia (p. 466). On the laboratory scale it can be synthesized from aqueous solution by the mild reduction of acidified nitrites with iodide or ferrocyanide or by the disproportionation of nitrous acid in the presence of dilute sulfuric acid ... 

Sulfamide, (H2N)2S02, can be made by ammonolysis of SO3 or O2SCI2. It is a colourless crystalline material, mp 93°, which begins to decompose above this temperature. It is soluble in water to give a neutral non-electrolytic solution but in boiling water it decomposes to ammonia and sulfuric acid. The structure (Fig. 15.50c)... 

Both cis and tran -cyclohexene have been synthesized, but only one of them can be isolated. Electrophilic addition of ROH to one isomer occurs spontaneously, while addition to the other isomer occurs only in the presence of a strong acid, such as sulfuric acid. Calculate the energy of protonation for each isomer cyclohexene protonated cyclohexene, trans-cyclohexene protonated trans-cyclohexene), and identify the more reactive isomer. Also examine electrostatic potential maps. Suggest an explanation to account for both the reactivity difference and the structural changes. (See also Chapter 7, Problem 5.)... 

The correct structure of the condensation product of 2-thiocyano-thiophene and chloral in the presence of sulfuric acid is (173). ... 

---