Steam advantage

One advantage of anaerobic reactions is that the methane produced can be a useful source of energy. This can be fed to steam boilers or burnt in a heat engine to produce power. 

Beside all technical reasons the big advantage of a pneumatic test is, that the steam drums can remain within the line because first we have no additional load for the bearing and only small adjustments (for the connection with the pressurisation unit and the tightening of the man ways for the applied low temperature gas test) have to be done to make the drum ready for a pneumatic loading. The pressurised air is available in every paper mill and even if the maximum pressure does not fit, the use of a compressor or pressure bottles produce no problems. 

During a hydrotest the additional weight of the water superimposes the normal operational stress by steam pressure. The big advantage of the pneumatic test is now, that it is the best imitation of the normal service condition. 

Place 45 g. (43 ml.) of benzal chloride (Section IV,22), 250 ml. of water and 75 g. of precipitated calcium carbonate (1) in a 500 ml. round-bottomed flask fltted with a reflux condenser, and heat the mixture for 4 hours in an oil bath maintained at 130°. It is advantageous to pass a current of carbon dioxide through the apparatus. Filter off the calcium salts, and distil the filtrate in steam (Fig. II, 40, 1) until no more oil passes over (2). Separate the benzaldehyde from the steam distillate by two extractions with small volumes of ether, distil off most of the ether on a water bath, and transfer the residual benzaldehyde to a wide-mouthed bottle or flask. Add excess of a concentrated solution of sodium bisulphite in portions with stirring or shaking stopper the vessel and shake vigorously until the odour of benzaldehyde can no longer be detected. Filter the paste of the benzaldehyde bisulphite compound at the pump... 

Vortex-shedding flow meters typically provide 1% of flow rate accuracy over wide ranges on Hquid, gas, and steam service. Sizes are available from 25 to 200 mm. The advantages of no moving parts and linear digital output have resulted in wide usage in the measurement of steam, water, and other low viscosity Hquids. 

This reaction is first conducted on a chromium-promoted iron oxide catalyst in the high temperature shift (HTS) reactor at about 370°C at the inlet. This catalyst is usually in the form of 6 x 6-mm or 9.5 x 9.5-mm tablets, SV about 4000 h . Converted gases are cooled outside of the HTS by producing steam or heating boiler feed water and are sent to the low temperature shift (LTS) converter at about 200—215°C to complete the water gas shift reaction. The LTS catalyst is a copper—zinc oxide catalyst supported on alumina. CO content of the effluent gas is usually 0.1—0.25% on a dry gas basis and has a 14°C approach to equihbrium, ie, an equihbrium temperature 14°C higher than actual, and SV about 4000 h . Operating at as low a temperature as possible is advantageous because of the more favorable equihbrium constants. The product gas from this section contains about 77% H2, 18% CO2, 0.30% CO, and 4.7% CH. ... 

Grains. Grains are usually prereduced powders. The quantities of sodium sulfide, hydrosulfide, and mineral salts are adjusted to give a grainy product when the paste slurry is dried on a steam-heated dmm dryer. Grains offer the advantage of not being dusty. 

---