Source/drain implant process

Fig. 9. Fabrication sequence for an oxide-isolated -weU CMOS process, where is boron and X is arsenic. See text, (a) Formation of blanket pod oxide and Si N layer resist patterning (mask 1) ion implantation of channel stoppers (chanstop) (steps 1—3). (b) Growth of isolation field oxide removal of resist, Si N, and pod oxide growth of thin (<200 nm) Si02 gate oxide layer (steps 4—6). (c) Deposition and patterning of polysihcon gate formation of -source and drain (steps 7,8). (d) Deposition of thick Si02 blanket layer etch to form contact windows down to source, drain, and gate (step 9). (e) Metallisation of contact windows with W blanket deposition of Al patterning of metal (steps 10,11). The deposition of intermetal dielectric or final...

Conventional electronic devices are made on silicon wafers. The fabrication of a silicon MISFET starts with the diffusion (or implantation) of the source and drain, followed by the growing of the insulating layer, usually thermally grown silicon oxide, and ends with the deposition of the metal electrodes. In TFTs, the semiconductor is not a bulk material, but a thin film, so that the device presents an inverted architecture. It is built on an appropriate substrate and the deposition of the semiconductor constitutes the last step of the process. TFT structures can be divided into two families (Fig. 14-12). In coplanar devices, all layers are on the same side of the semiconductor. Conversely, in staggered structures gate and source-drain stand on opposing sides of the semiconductor layer. 

MOSFETT s, and silicon oxide is deposited. The source/drain positions where electrical contact is to be made to the MOSFETs are defined, using the oxide-removal mask and an etch process. For shallow trench isolation, anisotropic silicon etch, thermal oxidation, oxide fill and chemical mechanical leveling are the processes employed. For shallow source/drains formation, ion implantation techniques are still be used. For raised source/drains (as shown in the above diagram) cobalt silicide is being used instead of Ti/TLN silicides. Cobalt metal is deposited and reacted by a rapid thermal treatment to form the silicide. Capacitors were made in 1997 from various oxides and nitrides. The use of tantalmn pentoxide in 1999 has proven superior. Platinum is used as the plate material. 

Fig. 14.6. Application of ion implantations in advanced CMOS structure at several stages of the process, (a) Ion implants for retrograde well formation, punch-through-stop, and threshold voltage adjust (b) shallow source/drain (S/D) implant and (c) halo implant...

The purpose of this research was to determine the feasibility of incorporating CPI into field-effect transistors. Due to time limitations and availability of various equipment, source and drains were formed by thermal diffusion rather than by ion implantation as proposed in the preceded discussion. As a result of this slight change in process sequence, metal-gate FETs could be fabricated as a control for the CPI devices. In addition, a non-photosensitive PI was used thus requiring extra photoresist deposition and patterning steps. 

---