Solvent principles

Continuous Countercurrent Multistage Fractional Extraction. The industrial process utilizing the double-solvent principles is continuous and is carried out according to the flowsheet of Fig. 7.18 (2, 15). The feed, consisting principally of a mixture of B and C to be separated, is introduced into the central portion of a cascade of stages, 1 to 1. To facilitate... 

In principle, extractive distillation is more useful than azeotropic distillation because the process does not depend on the accident of azeotrope formation, and thus a greater choice of mass-separating agent is, in principle, possible. In general, the solvent should have a chemical structure similar to that of the less volatile of the two components. It will then tend to form a near-ideal mixture with the less volatile component and a nonideal mixture with the more volatile component. This has the effect of increasing the volatility of the more volatile component. 

Film pressure is often measured directly by means of a film balance. The principle of the method involves the direct measurement of the horizontal force on a float separating the film from clean solvent surface. The film balance has been considerably refined since the crude model used by Langmuir and in many... 

In principle, then, small crystals should show a higher solubility in a given solvent than should large ones. A corollary is that a mass of small crystals should eventually recrystallize to a single crystal (see Ostwald ripening. Section IX-4). 

As described at the end of section Al.6.1. in nonlinear spectroscopy a polarization is created in the material which depends in a nonlinear way on the strength of the electric field. As we shall now see, the microscopic description of this nonlinear polarization involves multiple interactions of the material with the electric field. The multiple interactions in principle contain infomiation on both the ground electronic state and excited electronic state dynamics, and for a molecule in the presence of solvent, infomiation on the molecule-solvent interactions. Excellent general introductions to nonlinear spectroscopy may be found in [35, 36 and 37]. Raman spectroscopy, described at the end of the previous section, is also a nonlinear spectroscopy, in the sense that it involves more than one interaction of light with the material, but it is a pathological example since the second interaction is tlirough spontaneous emission and therefore not proportional to a driving field... 

In principle, simulation teclmiques can be used, and Monte Carlo simulations of the primitive model of electrolyte solutions have appeared since the 1960s. Results for the osmotic coefficients are given for comparison in table A2.4.4 together with results from the MSA, PY and HNC approaches. The primitive model is clearly deficient for values of r. close to the closest distance of approach of the ions. Many years ago, Gurney [H] noted that when two ions are close enough together for their solvation sheaths to overlap, some solvent molecules become freed from ionic attraction and are effectively returned to the bulk [12]. 

The are essentially adjustable parameters and, clearly, unless some of the parameters in A2.4.70 are fixed by physical argument, then calculations using this model will show an improved fit for purely algebraic reasons. In principle, the radii can be fixed by using tables of ionic radii calculations of this type, in which just the A are adjustable, have been carried out by Friedman and co-workers using the HNC approach [12]. Further rermements were also discussed by Friedman [F3], who pointed out that an additional temi is required to account for the fact that each ion is actually m a cavity of low dielectric constant, e, compared to that of the bulk solvent, e. A real difficulty discussed by Friedman is that of making the potential continuous, since the discontinuous potentials above may lead to artefacts. Friedman [F3] addressed this issue and derived... 

The same principles apply to couplings from spins with/> 1/2, where these are not seriously affected by relaxation. Figure Bl.l 1.4 illustrates a connnon case. The solvent resonance at 30 ppm is a 1 3 6 7 6 3 1... 

The problems already mentioned at the solvent/vacuum boundary, which always exists regardless of the size of the box of water molecules, led to the definition of so-called periodic boundaries. They can be compared with the unit cell definition of a crystalline system. The unit cell also forms an "endless system without boundaries" when repeated in the three directions of space. Unfortunately, when simulating hquids the situation is not as simple as for a regular crystal, because molecules can diffuse and are in principle able to leave the unit cell. 

Nebulizers are used to introduce analyte solutions as an aerosol spray into a mass spectrometer. For use with plasma torches, it is necessary to produce a fine spray and to remove as much solvent as possible before the aerosol reaches the flame of the torch. Various designs of nebulizer are available, but most work on the principle of interacting gas and liquid streams or the use of ultrasonic devices to cause droplet formation. For nebulization applications in thermospray, APCI, and electrospray, see Chapters 8 and 11. 

Steps such as the substitution of low sulfur fuels or nonvolatile solvents, change of taw materials, lowering of operation temperatures to reduce NO formation or vo1ati1i2ation of process material, and instaHion of weU-designed hoods (31—37) at emission points to effectively reduce the air quantity needed for pollutant capture are illustrations of the above principles. 

A process developed in Israel (263) uses solvent extraction using a higher alcohol or other solvating solvent. This removes phosphoric acid and some hydrochloric acid from the system driving the equiHbrium of equation 42 to the right. The same principle can be appHed in other salt—acid reactions of the form... 

Other perturbations have been demonstrated. The pressure,, jump, similar to the T-jump in principle, is attractive for organic reactions where Joule heating may be impractical both because of the solvent being used and because concentrations might have to be measured by conductivity. Large (10 —10 kPa) pressures are needed to perturb equiUbrium constants. One approach involves pressurizing a Hquid solution until a membrane mptures and drops the pressure to ambient. Electric field perturbations affect some reactions and have also been used (2), but infrequentiy. 

Spray Drying. Spray-dry encapsulation processes (Fig. 7) consist of spraying an intimate mixture of core and shell material into a heated chamber where rapid desolvation occurs to thereby produce microcapsules (24,25). The first step in such processes is to form a concentrated solution of the carrier or shell material in the solvent from which spray drying is to be done. Any water- or solvent-soluble film-forming shell material can, in principle, be used. Water-soluble polymers such as gum arable, modified starch, and hydrolyzed gelatin are used most often. Solutions of these shell materials at 50 wt % soHds have sufficiently low viscosities that they stiU can be atomized without difficulty. It is not unusual to blend gum arable and modified starch with maltodextrins, sucrose, or sorbitol. 

G. M. Ritcey and A. W. Ashbtook, Solvent Extraction—Principles and Applications to Process Metallurgy, Part I and II, Elsevier, Amsterdam, the... 

The principle of solvent extraction in refining is as follows when a dilute aqueous metal solution is contacted with a suitable extractant, often an amine or oxime, dissolved in a water-immiscible organic solvent, the metal ion is complexed by the extractant and becomes preferentially soluble in the organic phase. The organic and aqueous phases are then separated. By adding another aqueous component, the metal ions can be stripped back into the aqueous phase and hence recovered. Upon the identification of suitable extractants, and using a multistage process, solvent extraction can be used to extract individual metals from a mixture. 

---