Society of the Plastics Industry Inc

Testing and Standards. Requirements for extmsion and mol ding grades are cited in ASTM specifications (79) and in Federal specification LP-389A of May 1964 (80). For fabricated shapes, FEP film and sheet are covered by Aeronautical Material Specifications (AMS) 3647 and LP-523 (81). Besides the specifications covered by the Fluorocarbons Division of the Society of the Plastics Industry, Inc. (82), other specifications are Hsted in Reference 83. 

Suggested Relative Hasard Classification of Organic Peroxides, Technical PubHcation, Organic Peroxide Producers Safety Division, The Society of the Plastics Industry, Inc., New York, 1992. 

Environmental Profile Facts Nbout the S afety of PNC Ndditives, rev. buU. The Viayl Institute, a Division of The Society of The Plastics Industry, Inc., Morristown, N.J., July 1993. 

S. Z. Lu, 35th Annu. Tech. Conf. Reinforced Plastic/ Composite Institute, The Society of the Plastic Industry Inc., (1980). 

Plastics engineering handbook of the society of the plastics industry, inc. , 5th edition, Michael L. Berins (Editor) Chapman Hall (Kluwer Academic Publishers) (1991) ISBN 0412991810. Since 1947, the most comprehensive reference available on plastics processing methods,... 

The size of flight radii on the screw channel is important for the proper performance of a single-screw extruder. The specifications of the flight radii are commonly made using a combination of personal experience and guidelines [16] from the Society of the Plastics Industry, Inc. (SPl). These guidelines state unless otherwise specified the root radius will not be less than one-half of the flight depth up to... 

Recommended Dimensional Guideline for Single Screws, The Society of the Plastics Industry, Inc. 

Fluoropolymer Manufacturers Group. Detecting and quantifying low levels of fluoropolymer polymerization aids - a guidance document. Society of the Plastic Industry, Inc., Washington, DC, 2003. 

Farrissey, W.J., and Rausch, K.W. Jr., 31st Annual Technical Conference, (1976), Reinforced Plastics/Composites Institute, The Society of the Plastic Industry, Inc., Section 21-F. 

---