Single active-electron approximation

Within the independent electron and single active electron approximations, the symmetries of the contributing photoelectron partial waves will be determined by the symmetry of the orbital(s) from which ionization occurs, and so the PAD will directly reflect the evolution of the molecular orbital configuration. Example calculations demonstrating this are shown in Fig. 3 for a model Civ molecule, where a clear difference in the PAD is observed according to whether ionization occurs from an a or an ai symmetry orbital [55] (discussed in more detail below). 

The correction to the relaxing density matrix can be obtained without coupling it to the differential equations for the Hamiltonian equations, and therefore does not require solving coupled equations for slow and fast functions. This procedure has been successfully applied to several collisional phenomena involving both one and several active electrons, where a single TDHF state was suitable, and was observed to show excellent numerical behavior. A simple and yet useful procedure employs the first order correction F (f) = A (f) and an adaptive step size for the quadrature and propagation. The density matrix is then approximated in each interval by... 

In practice, each CSF is a Slater determinant of molecular orbitals, which are divided into three types inactive (doubly occupied), virtual (unoccupied), and active (variable occupancy). The active orbitals are used to build up the various CSFs, and so introduce flexibility into the wave function by including configurations that can describe different situations. Approximate electronic-state wave functions are then provided by the eigenfunctions of the electronic Flamiltonian in the CSF basis. This contrasts to standard FIF theory in which only a single determinant is used, without active orbitals. The use of CSFs, gives the MCSCF wave function a structure that can be interpreted using chemical pictures of electronic configurations [229]. An interpretation in terms of valence bond sti uctures has also been developed, which is very useful for description of a chemical process (see the appendix in [230] and references cited therein). 

Amorphous Silicon. Amorphous alloys made of thin films of hydrogenated siUcon (a-Si H) are an alternative to crystalline siUcon devices. Amorphous siUcon ahoy devices have demonstrated smah-area laboratory device efficiencies above 13%, but a-Si H materials exhibit an inherent dynamic effect cahed the Staebler-Wronski effect in which electron—hole recombination, via photogeneration or junction currents, creates electricahy active defects that reduce the light-to-electricity efficiency of a-Si H devices. Quasi-steady-state efficiencies are typicahy reached outdoors after a few weeks of exposure as photoinduced defect generation is balanced by thermally activated defect annihilation. Commercial single-junction devices have initial efficiencies of ca 7.5%, photoinduced losses of ca 20 rel %, and stabilized efficiencies of ca 6%. These stabilized efficiencies are approximately half those of commercial crystalline shicon PV modules. In the future, initial module efficiencies up to 12.5% and photoinduced losses of ca 10 rel % are projected, suggesting stabilized module aperture-area efficiencies above 11%. 

Figure 2. Theoretical prediction for the temperature dependence of the electron transfer rate for activated and for activationless processes. Solid lines are calculated for a continuum of vibrational modes dotted lines represent the single-mode approximation (6, 8). Upper curve AE, —2000 cm 1 P, 20 and S, 20. Lower curves AE, —800 cm"1 P, 8 and S, 20.

---