Silyl enol ethers diastereoselective aldol additions

The reactions proceeded efficiently under mild conditions in short time. The silyl enol ethers reacted with the activated acetals or aldehydes at -78 °C to give predominant erythro- or threo-products [136, 137] respectively. In the same manner, the aldol reaction of thioacetals, catalyzed by an equimolar amount of catalyst, resulted in <-ketosulfides [139] with high diastereoselectivity. In the course of this investigation, the interaction of silyl enol ethers with a,]3-unsaturated ketones, promoted by the trityl perchlorate, was shown to proceed regioselec-tively through 1,2- [141] or 1,4-addition [138]. The application of the trityl salt as a Lewis acid catalyst was spread to the synthesis of ]3-aminoesters [142] from the ketene silyl acetals and imines resulting in high stereoselective outcome. 

First, chemoselective (Chapter 24) conjugate addition of the silyl ketene acetal on the enone is preferred to direct aldol reaction with the aldehyde. Then an aldol reaction of the intermediate silyl enol ether on the benzaldehyde follows. The stereoselectivity results, firstly, from attack of benzalde-hyde on the less hindered face of the intermediate silyl enol ether, which sets the two side chains trans on the cyclohexanone, and, secondly, from the intrinsic diastereoselectivity of the aldol reaction (this is treated in some detail in Chapter 34). This is a summary mechanism. 

A kinetic study of the Ph2BOH-catalysed reactions of several aldehydes with 2 revealed that the rate of the disappearance of 2 followed first-order kinetics and was independent from the reactivity of the aldehydes used. Taking into account this result, we have proposed the reaction mechanism in which a silyl enol ether is transformed to the corresponding diphenylboryl enolate before the aldol addition step takes place (Scheme 13.1). The high diastereoselectivity is consistent with the mechanism, in which the aldol step proceeds via a chair-like six-membered transition state. The opposite diastereoselectivity in the reaction with the geometrical isomers of the thioketene silyl acetal shown in Table 13.3 also supports the mechanism via the boron enolate, because this trend was also observed in the classical boron enolate-mediated reactions in dry organic solvents. Although we have not yet observed the boron enolates directly under the reaction conditions, this mechanism can explain all of the experimental data obtained and is considered as the most reasonable one. As far as we know, this is the first example of... 

The Mukaiyama aldol reaction of carbonyl substrates with silyl enol ethers is the most widely accepted of Lewis acid-promoted reactions. Many Lewis acids for the reaction have been developed and used enantioselectively and diastereoselectively. In 1980, catalytic amounts of la were found by Noyori et al. to effect aldol-type condensation between acetals and a variety of silyl enol ethers with high stereoselectivity [2c,20]. Unfortunately, la has poor Lewis acidity for activation of aldehydes in Mukaiyama s original aldol reaction [21]. Hanaoka et al. showed the scope and limitation of 11-cat-alyzed Mukaiyama aldol reaction, by varying the alkyl groups on the silicon atom of silyl enol ethers [22]. Several efforts have been since been made to increase the reactivity and/or the Lewis acidity of silicon. One way to enhance the catalyst activity is to use an additional Lewis acid. 

Diastereoselective Aldol Additions of Chiral Silyl Ketene Acetals and Chiral Silyl Enol Ethers... 

In order to reverse the diastereoselectivity in the aldol reaction, the Lewis acid-catalyzed silyl enol ether addition (73) (Mukaiyama aldol reaction) was examined. Since the Mukaiyama aldol reaction is assumed to be proceeded via an acyclic transition state, a chelation controled aldol reaction of the a-alkoxy aldehyde should be possible (74). In the presence of TiCU, the silyl enol ether derived from 14 was reacted with aldehyde 13, followed by desilylation to afford the desired anti-Felkin product 122a as a single adduct (Scheme 21). Based on precedents for chelation-controlled Mukaiyama aldol reaction (74), the exceptional high selectivity in this reaction would be accounted for by chelation of TiCl4 with the C23-methoxy group of the aldehyde 13 (eq. 13). On the other hand, when the lithium enolate derived from 14 was treated with the aldehyde 13, followed by desilylation, it gave a 1 4 ratio of the two epimers in favour of the undesired (22S)-aldol product... 

Significant advances in the development of a catalytic asymmetric variant of the aldol reaction have been developed recently. Both enantiomericaUy pure Lewis acids and Lewis bases have been applied to the addition of silyl enol ethers to aldehydes and ketones and highly diastereoselective and enantioselec-tive additions have been achieved. Often, the mode of diastereoselectivity can be rationalised from a consideration of the relevant open or closed transition states. 

The aldol reaction and related processes have been of considerable importance in organic synthesis. The control of syn/anti diastereoselectivity, enantioselectivity and chemoselectivity has now reached impressive levels. The use of catalysts is a relatively recent addition to the story of the aldol reaction. One of the most common approaches to the development of a catalytic asymmetric aldol reaction is based on the use of enantiomerically pure Lewis acids in the reaction of silyl enol ethers with aldehydes and ketones (the Mukaiyama reaction) and variants of this process have been developed for the synthesis of both syn and anti aldol adducts. A typical catalytic cycle is represented in Figure 7.1, where aldehyde (7.01) coordinates to the catalytic Lewis acid, which encourages addition of the silyl enol ether (7.02). Release of the Lewis acid affords the aldol product, often as the silyl ether (7.03). 

Asymmetric aldol reactions. The chiral N-propionyloxazolidinone (1), prepared in several steps from (lR)-(—)-camphorquinone, undergoes highly diastereoselective aldol reactions with the additional advantage of high crystallinity for improving the optical purities of crude aldols. Either the lithium enolate or the titanium enolate, prepared by transmetalation with ClTi(0-(-Pr)3, reacts with aldehydes to form syn-adducts with diastereomeric purities of 98-99% after one crystallization. The observed facial selectivity is consistent with metal chelation of intermediate (Z)-enolates (supported by an X-ray crystal structure of the trapped silyl enol ether). The lithium enolate also exhibits... 

Trimethylsilyloxyfuran 338 has shown promise as a masked butenolide fragment To fuUy exploit these qualities, the threo versus erythro (339 vs 340) diastereoselectivity in aldol-type additions has to be controlled. In fact it has been shown that this is easily achieved by appropriate reaction conditions. Applying Mukaiyama conditions (i.e., using the silyl enol ether as the donor in the presence of a Lewis acid such as TESOTf to generate oxonium species) leads to threo preference for 339, presumably via an open transition state, whereas desilylation with TBAF generates the erythro-diastereomer 340, this time via a closed Diels-Alder (or Zimmerman-Traxler)-like transition state. In both cases, chelating effects can be ruled out... 

Silver(I) complexes with Tol-BINAP (270) were used by Yamamoto and coworkers for mediating diastereoselective and enantioselective Mukaiyama aldol additions. According to the authors conclusion, the mechanism does not involve transmetallation to silver enolates but follows the usual carbonyl group activation [135]. Hoveyda and coworkers used silver(II) fluoride in the presence of a dipeptide-type ligand for enantioselective additions of silyl enol ethers to a-keto esters [136]. The reaction of 2-trimethylsilyloxyfuran with aromatic and aliphatic aldehydes was catalyzed with chromium salen complex in the presence of protic additives like isopropanol [137]. Various protocols of enantioselective Mukaiyama aldol reactions that use water as cosolvent have been elaborated ... 

---