Sensitivity, concentration pressure

Detector Sensitivity, or Minimum Detectable Concentration Pressure Sensitivity Flow Sensitivity Temperature Sensitivity... 

In summary, gas-phase reactions between aldehydes and NOj occur readily and with strong exothermicity. The rate of reaction is largely dependent on the alde-hyde/N02 mixture ratio, and is increased with increasing NO2 concentration for aldehyde-rich mixtures. On the other hand, no appreciable gas-phase reactions involving NO are likely to occur below 1200 K. The overall chemical reaction involving NO appears to be third order, which impUes that it is sensitive to pressure. The reactions discussed above are important in understanding the gas-phase reaction mechanisms of nitropolymer propellants. 

Supported Au catalysts have been extensively studied because of their unique activities for the low temperature oxidation of CO and epoxidation of propylene (1-5). The activity and selectivity of Au catalysts have been found to be very sensitive to the methods of catalyst preparation (i.e., choice of precursors and support materials, impregnation versus precipitation, calcination temperature, and reduction conditions) as well as reaction conditions (temperature, reactant concentration, pressure). (6-8) High CO oxidation activity was observed on Au crystallites with 2-4 nm in diameter supported on oxides prepared from precipitation-deposition. (9) A number of studies have revealed that Au° and Au" play an important role in the low temperature CO oxidation. (3,10) While Au° is essential for the catalyst activity, the Au° alone is not active for the reaction. The mechanism of CO oxidation on supported Au continues to be a subject of extensive interest to the catalysis community. 

It is well known that the properties of supercritical fluids are sensitive to pressure, and thus pressure may drastically influence the catalytic activity or the product selectivity when a reaction takes place in supercritical conditions. The favorable pressure for the Wacker oxidation of styrene is around 16 MPa of total pressure including 3 MPa 02, at which the selectivity toward acetophenone reaches 92 %, while under a total pressure of 9 MPa, the selectivity for acetophenone is lower (86 %). However, C02 with a higher pressure of over 20 MPa might retard the interaction between the substrate and the catalyst, and might cause a low concentration of substrate in the vicinity of the catalyst, thus resulting in a relatively low yield [38]. 

The electret ion chamber for radon measurement or E-PERM (commercial name) can be used to determine the long-term average Rn concentration over periods of one week to months, depending on the levels. The electret system, as any other ionization chamber, is sensitive to pressure variations, and corrections for this effect should be made. A major disadvantage is that the electret will also respond to radiation from external sources. When used in gamma radiation fields (in many situations) a duplicate set of monitors have to be exposed to be able to correct for the effect of the external gamma radiation on the radon measurement. 

As AWp is negative, a rise in temperature will cause [A(,] to increase, thus at 405 K, methyl methacrylate has a value of [M ] = 0.5 mol dm , whereas a-methylstyrene will not polymerize at all. Ceiling temperatures then refer to a given monomer concentration, and it is more convenient to refer it to a standard state. This can either be referred to pure liquid monomer or a concentration of 1 mol dm typical examples for pure liquid monomers are given in Table 3.6. Whereas the ceifing temperature alters with monomer concentration, it is also sensitive to pressure. As AH and AS are both negative, an increase in is obtained if -AS can be decreased. 

Water is decomposed by all types of high-energy radiations to give hydrogen, hydrogen peroxide, and oxygen [31]. If the decomposition products are confined in solution, a radiation-induced back reaction will occur and, eventually, steady-state concentrations (pressures) of products will be attained. The rate of decomposition, the rate of the back reaction, and hence the steady-state concentrations are sensitive to the conditions of the system, such as the nature of the radiation, the type and concentration of solutes present, and the temperature. In particular, the addition of hydrogen suppresses the decomposition of pure water. 

The most often used subphase is water. Mercury and otlier liquids [12], such as glycerol, have also occasionally been used [13,14]. The water has to be of ultrapure quality. The pH value of tire subphase has to be adjusted and must be controlled, as well as tire ion concentration. Different amphiphiles are differently sensitive to tliese parameters. In general it takes some time until tire whole system is in equilibrium and tire final values of pressure and otlier variables are reached. Organic contaminants cannot always be removed completely. Such contaminants, as well as ions, can have a hannful influence on tire film preparation. In general, all chemicals and materials used in tire film preparation have to be extremely pure and clean. 

Isoflurane is a respiratory depressant (71). At concentrations which are associated with surgical levels of anesthesia, there is Htde or no depression of myocardial function. In experimental animals, isoflurane is the safest of the oral clinical agents (72). Cardiac output is maintained despite a decrease in stroke volume. This is usually because of an increase in heart rate. The decrease in blood pressure can be used to produce "deHberate hypotension" necessary for some intracranial procedures (73). This agent produces less sensitization of the human heart to epinephrine relative to the other inhaled anesthetics. Isoflurane potentiates the action of neuromuscular blockers and when used alone can produce sufficient muscle relaxation (74). Of all the inhaled agents currently in use, isoflurane is metabolized to the least extent (75). Unlike halothane, isoflurane does not appear to produce Hver injury and unlike methoxyflurane, isoflurane is not associated with renal toxicity. 

Desflurane is less potent than the other fluorinated anesthetics having MAC values of 5.7 to 8.9% in animals (76,85), and 6% to 7.25% in surgical patients. The respiratory effects are similar to isoflurane. Heart rate is somewhat increased and blood pressure decreased with increasing concentrations. Cardiac output remains fairly stable. Desflurane does not sensitize the myocardium to epinephrine relative to isoflurane (86). EEG effects are similar to isoflurane and muscle relaxation is satisfactory (87). Desflurane is not metabolized to any significant extent (88,89) as levels of fluoride ion in the semm and urine are not increased even after prolonged exposure. Desflurane appears to offer advantages over sevoflurane and other inhaled anesthetics because of its limited solubiHty in blood and other tissues. It is the least metabolized of current agents. 

---