Copolymer semicrystalline

Vinyhdene chloride copolymers are available as resins for extmsion, latices for coating, and resins for solvent coating. Comonomer levels range from 5 to 20 wt %. Common comonomers are vinyl chloride, acrylonitrile, and alkyl acrylates. The permeability of the polymer is a function of type and amount of comonomer. As the comonomer fraction of these semicrystalline copolymers is increased, the melting temperature decreases and the permeability increases. The permeability of vinylidene chloride homopolymer has not been measured. 

Drbscher, M. Solid State Extrusion of Semicrystalline Copolymers. Vol. 47, pp. 120-138. 

Drobnik, J. and Rypalek, F. Soluble Synthetic Polymers in Biological Systems. Vol. 57, pp. 1-50. Droscher, M. Solid State Extrusion of Semicrystalline Copolymers. Vol. 47, pp. 120-138. 

The chain scission and weight loss of a semicrystalline copolymer with 8 mol % e-decalactone was almost identical to that of PCL and was clearly nonenzymatic. When the proportion of e-decalactone was... 

As mentioned in Section 2.3,3, because SC IT is the most general theory for the ordering of block copolymers to date, a brief outline is given here. The simplest case of a diblock copolymer melt is considered, following Matsen and Schick (1994). The extension to other melts of other architectures, solutions, blends or semicrystalline copolymers is discussed in the appropriate chapter. 

The nylons used as modifiers for epoxy adhesives are soluble, semicrystalline copolymers made from conventional nylon monomers.7 These resins can be dissolved in alcohols and other solvents, and they can be melted below their decomposition temperature. A preferred solvent mixture is ethanol plus up to 20% water. A commercial example of an adhesive-grade nylon is Dupont s Zytel 61. Conventional crystalline nylon polymers, such as nylon 6 or nylon 66, would be incompatible with epoxy resins. 

Legrand et al. [100] reported F wideline NMR measurements on a 70/30 mol% VDF-TrFE random copolymer, made in order to study molecular motion both below and above the ferroelectric transition temperature, Tc. The samples consisted of semicrystalline copolymer films of 0.51 mm thickness, with biaxial orientation of the crystalline axis. The samples were rolled (without poling) at 70°C, with a draw ratio of 300%. The F resonance was chosen, rather than the proton resonance, because the abundance ratio of F to nuclei is 1.4. In addition, the F free-induction decay (FID) lasts longer than that of the proton, which decreases the influence of spectrometer deadtime. FID analyses were made assuming a simple superposition of two... 

Hydrolyzed ethylene—vinyl acetate copolymers [24937-78-8]> commonly known as ethylene—vinyl alcohol (EVOH) copolymers [25067-34-9], are usually used as extrusion resins, although some may be used in solvent-coating applications. As the ethylene fraction of these semicrystalline copolymers increases, the melting temperature decreases, the permeabilities increase, and the sensitivity to humidity decreases. The permeabilities as a function of polymer composition and humidity are shown in Figure 2. Vinyl alcohol homopolymer [9002-89-5] has a very low oxygen permeability in dry conditions however, the polymer is water-soluble. Trade names for these barrier polymers include Eval, Soamol, Selar OH, and Qarene. Table 6 lists the compositions... 

---