Schematic diagram of experimental

Fig. 2.9 Schematic diagram of experimental set-up 1 inlet tank, 2 pump, 3 control valve, 4 temperature and pressure measurement ports, 5 sample of porous medium, 6 top of test section, 7 housing, 8 copper rod, 9 heater, 10 insulation, 11 exit tank, 12 electronic scales. Reprinted from Hetsroni et al. (2006a) with permission...

Fig. 1. Schematic diagram of experimental apparatus 3. Results and discussion...

Fig. 1 Schematic diagram of experimental apparatus Co.) and carbon particle size analyzer(LS230, COULTER Co.).

Fig. 4. Schematic diagram of experimental arrangement for pulsed ultrasonic absorption measurements. According to Ref. [29]...

Fig. 6.20. The schematic diagram of experimental set-up to study photoemission of 02- / - quartz vial 2 - quartz window 3 thermostating jacket 4 - aluminum shield 5 - filter 6 - thermostating jacket 7 - blue glass 8 - sensor 9 - platinum rings 10 - glass covered weight 11 - 13 - lenses A, B - jackets providing optical isolation of chambers.

Figure 8 Schematic diagram of experimental setup for photo-CVD polysilane synthesis.

Fig. 6.17 Schematic diagram of experimental apparatus of supercritical water gasification...

Figure 2. Schematic Diagram of Experimental Setup for FGD Process.

Experimental Procedure. A schematic diagram of experimental apparatus is shown in Figure 2. About ten of cylindrical glass bottles enclosed samples of same composition were set in a thermostatic air chamber. The samples melted perfectly by holding for about 2h at... 

FIGURE 3.11 Schematic diagram of experimental approach to the Beer-Lambert law. 

Figure 7.38 Schematic diagram of experimental apparatus used to form SiC/BN composite particles by gas-phase synthesis on a substrate (a). From Carbide, Nitride, and Boride Materials Synthesis and Processing, A. W. Weimer, ed., p. 336. Copyright 1997 by Chapman Hall, London, with kind permission of Kluwer Academic Publishers.

Fiq. 13. Schematic diagram of experimental system used to study the adsorption of nitrogen on tungsten. 

Figure 8 Schematic diagram of experimental setup and image of microplasma reactor with VHF source developed for the synthesis of photoluminescent silicon nanocrystals at room temperature (Nozaki et al, 2007a reproduced with permission). M.B. is a matching electrical circuit.

Fig. 38. Schematic diagram of experimental apparatus. (After Y. Murakami, Fujimoto, K., Kakimoto. S., and Sekino. M., J. Chem. Eng. of Jpn. 5 (3), 257, 1972.)...

Figure 1. Schematic diagram of experimental apparatus used in this work 1. equilibrium cell 2. magnet 3. pressure gauge 4. thermometer 5. rupture disc 6. check valve 7. high pressure pump 8. CO2 gas 9. line filter 10. water bath.

Fig. 1 Schematic diagram of experimental apparatus employed for the test of TCE deradation Q) Oxygen tank d)Ozonizer(DOzone stock solution distilled erater Mixing vessel ( )Dual plunger pump without pulsating current (J) syringe pump with high concentration of TCE solution Packed column with an adsorbent Column packed with wet activated carbon for the degradation of exhausted ozone...

FIGURE 13.15 Schematic diagram of experimental setup with capillary membrane for simultaneous removal and enrichment of CO2. (From Teramoto, M., Kitada, S., Ohnishi, N., et al., J. Mem. Sci., 234, 83, 2004. With permission.)... 

Figure 12.10 Schematic diagram of experimental mixing process...

Fig. 10. Schematic diagram of experimental layout for detection of high harmonics...

Figure 14. Schematic diagram of experimental set up used for investigating the self-cleaning capability of the Ti02-based room temperature hydrogen gas sensor [79],...

Fig. 5. A schematic diagram of experimental setup for LIF detection of metal atoms from photo-CVD processing of metal organics.

Fig. 30 Schematic diagram of experimental setup to study the magnetoelastic properties...

Figure 5. Schematic diagram of experimental arrangement to excite Ps from the n=l to n=2 states.

Figure 3. Schematic diagram of experimental setup 1. medium reservoir, 2. peristaltic pump, 3. dual hollow-fiber bioreactor, 4. water bath, 5. air or pure oxygen bombe, 6. rotameter, 7. humidifier, 8. inoculum syringe, 9. sampling bottle, 10. effluent reservoir.

FIGURE 2.3.12 (a) Schematic diagram of experimental setup for scanning Kelvin probe microscopy (SKPM). (b) Profiles of an L = 5.5 J,m P3HT transistor with Cr electrodes taken at three different temperatures V = 0 V, = -8 V). The inset shows a profile obtained after switching the source and drain contacts on the same TFT with both Cr and Cr-Au contacts Vg = 0 V, = -8 V). (From Burgi, L. et ah, J. Appl. Phys., 94, 6129-6137, 2003. Reprinted with permission. Copyright 2003, American Institute of Physics.)... 

---