Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Salt molecule

Silver nitrate and/or cuppric nitrate [50] can photoinitiate the polymerization of acrylonitrile in a dimethyl formamide (DMF) medium. The photoactive species is the complex formed between the monomer and salt molecules ... [Pg.251]

The Dissociation Constant of Nitric Add. Alodcrately Weak Acids. The Variation of J with Temperature. Proton Transfers between Solute Particles. A Proton Transfer in Methanol Solution. Proton Transfers with a Negative Value for. / . The Hydrolysis of Salts. Molecules with Symmetry. Substituted Ammonium Ions. Deuteron Transfers in D2(). The Dissociation of Molecular Ions. [Pg.138]

Fig. 7-10 Kohler curves calculated for the saturation ratio Phjo/PhjO of a water droplet as a function of droplet radius r. The quantity im/M is given as a parameter for each line, where m = mass of dissolved salt, M = molecular mass of the salt, i = number of ions created by each salt molecule in the droplet. Fig. 7-10 Kohler curves calculated for the saturation ratio Phjo/PhjO of a water droplet as a function of droplet radius r. The quantity im/M is given as a parameter for each line, where m = mass of dissolved salt, M = molecular mass of the salt, i = number of ions created by each salt molecule in the droplet.
They also discussed the excitation mechanism of alkali-metal atoms as follows. The addition of a metal species from a liquid solution into cavitating bubbles is through the ablation of the bubble-liquid interface, the ablation of liquid jet or the evaporation of droplets, since the evaporation of salt is negligible. The salt molecules are released and decomposed into atoms via homolysis, analogous with the projection into a flame of metal species from salt solutions. The metal atoms are... [Pg.341]

The NaCl -SOD formed during these reactions can be clearly identified by its IR spectrum, perchlorate sodalite collapse at 1050°C. From the thermo gravimetric analysis it is evident that at this temperature the entire amount of NaCl escapes. The degree of the cage filling by salt molecules can be calculated on the basis of both the oxygen and the NaCl loss. [Pg.79]

Figures 17 and 18 represent FT-IR transmission and RA spectra, respectively, of the alternating S(PS)9-Ba films at various temperatures from 0 ° to 120 °C [7], Two intense bands at 2919 and 2852 cm 1 are the antisymmetric and symmetric CH2 stretching bands of DOPC, and two bands at 2192 and 2088 cm 1 are the antisymmetric and symmetric CD2 stretching bands of St-d35, respectively. Apparently, all these bands decreases their intensities with the increase in temperature in Figure 17. At the same time, intensity differences of the respective bands are evident between the transmission and RA spectra. From these data, we calculated temperature dependence of the orientation angle y of the hydro-carbon chain axes of the constituent molecules in the alternating S(PS)9 and S(PS)9-Ba films using Eqs. (2) and (3). The results are shown in Figure 19 [7]. Apparently, the y values of the respective constituents in the S(PS)9-Ba film are much smaller than those of the corresponding molecules in the S(PS)9 film. This reveals that the barium salt molecules are more highly oriented as compared with the... Figures 17 and 18 represent FT-IR transmission and RA spectra, respectively, of the alternating S(PS)9-Ba films at various temperatures from 0 ° to 120 °C [7], Two intense bands at 2919 and 2852 cm 1 are the antisymmetric and symmetric CH2 stretching bands of DOPC, and two bands at 2192 and 2088 cm 1 are the antisymmetric and symmetric CD2 stretching bands of St-d35, respectively. Apparently, all these bands decreases their intensities with the increase in temperature in Figure 17. At the same time, intensity differences of the respective bands are evident between the transmission and RA spectra. From these data, we calculated temperature dependence of the orientation angle y of the hydro-carbon chain axes of the constituent molecules in the alternating S(PS)9 and S(PS)9-Ba films using Eqs. (2) and (3). The results are shown in Figure 19 [7]. Apparently, the y values of the respective constituents in the S(PS)9-Ba film are much smaller than those of the corresponding molecules in the S(PS)9 film. This reveals that the barium salt molecules are more highly oriented as compared with the...
Bca = binary ion-ion interaction parameter CCa ternary ion-ion interaction parameter Dca m = binary salt-molecule interaction parameter or Setschenow constant D = dielectric constant... [Pg.87]

Micelles tend to aggregate, and there are many ways to measure their concentration, including surface tension measurements. The midpoint of the concentration range over which micellar aggregation occurs is called the critical micellar concentration (CMC). Below the CMC, added bile-salt molecules dissolve in the form of monomers above the CMC, added bile-salt molecules form micelles, leaving the monomeric concentration essentially constant. The pH at which CMC formation occurs is called the critical micellar pH, (CMpH). Table 1.1 lists values for some of the bile acids mentioned in this review. [Pg.8]

The initial rates in Figures 1 to 6 were normally linear over the period required to measure them, and the effect of hydroperoxide on rate is therefore probably small in the concentration ranges used. However, this problem is being investigated in more detail. From the induction period in Figure 7, determined by the method described by Hammond and his coworkers (4), a stoichiometric factor, n, the number of peroxy radicals reacting with each zinc salt molecule, can be calculated. Values... [Pg.340]

Spontaneous polymerization of 4-vinyl pyridine in the presence of polyacids was one of the earliest cases of template polymerization studied. Vinyl pyridine polymerizes without an additional initiator in the presence of both low molecular weight acids and polyacids such as poly(acrylic acid), poly(methacrylic acid), polyCvinyl phosphonic acid), or poly(styrene sulfonic acid). The polyacids, in comparison with low molecular weight acids, support much higher initial rates of polymerization and lead to different kinetic equations. The authors suggested that the reaction was initiated by zwitterions. The chain reaction mechanism includes anion addition to activated double bonds of quaternary salt molecules of 4-vinylpyridine, then propagation in the activated center, and termination of the growing center by protonization. The proposed structure of the product, obtained in the case of poly(acrylic acid), used as a template is ... [Pg.27]

However the question of whether the salt should be considered as a molecular or ionic constituent is raised. The laws of solution theory suggest the latter. Hence, unless the salt is either fully associated or fully dissociated over the entire liquid composition range, the varying degree of salt dissociation over this range is important. In other words, since both species of ion and salt molecules contribute to the total effect caused by a partially dissociated salt, the total number of salt particles (ions and molecules) present should be considered. This would suggest that an even more correct expression of liquid composition for use in calculating liquid phase activity coefficients would be... [Pg.38]

Shaded area. Lipid-soluble cyclic hydrocarbon part of bile salt molecule... [Pg.57]

The other experiment was performed by Isaksson (5) earlier. He extracted desiccated bile, using different solvents in succession. With chloroform, all of the lecithin was extracted but was accompanied by a large part of the bile salts. While bile salts by themselves are insoluble in chloroform, the extract thus obtained contains a proportion by weight of 2 parts of bile salt to 1 of lecithin—about one molecule of lecithin for three molecules of bile salt. Here, it is the lecithin, soluble in chloroform because of its paraffinic chains, which by association solubilizes the bile salt. It is interesting to inquire how these associations are achieved in both cases—i.e., how the molecules of bile salt are arranged and oriented in relation to the molecules of lecithin and to the polar or non-polar solvent. Let us examine first the state of the bile salt molecules in an aqueous phase. [Pg.87]

Fig. 26a-c. Swelling curves in aqueous solution with various molalities (mol/kg) of with organic sodium salts molecules, (a) HCOOH,... [Pg.233]

The oscillatory motion of the wavepacket between the inner and the outer bounds obviously shows up in the absorption signal of the transient salt molecule. Probing with the wavelength of the free Na atom yields the upper trace in Figure 16.7. It roughly measures the produc-... [Pg.377]


See other pages where Salt molecule is mentioned: [Pg.106]    [Pg.248]    [Pg.2033]    [Pg.301]    [Pg.70]    [Pg.132]    [Pg.140]    [Pg.117]    [Pg.126]    [Pg.349]    [Pg.100]    [Pg.65]    [Pg.66]    [Pg.87]    [Pg.126]    [Pg.3]    [Pg.23]    [Pg.470]    [Pg.232]    [Pg.36]    [Pg.39]    [Pg.55]    [Pg.70]    [Pg.71]    [Pg.527]    [Pg.230]    [Pg.221]    [Pg.54]    [Pg.197]    [Pg.302]    [Pg.283]    [Pg.36]    [Pg.377]    [Pg.159]    [Pg.231]   
See also in sourсe #XX -- [ Pg.30 ]




SEARCH



© 2024 chempedia.info