Reversible aldehydes

The typical aldehyde reactions of D-(-H)-glucose—osazone formation, and perhaps reduction of Tollens and Fehling s reagents—are presumably due to a small amount of open-chain compound, which is replenished as fast as it is consumed. The concentration of this open-chain structure is, however, too low (less than 0.5%) for certain easily reversible aldehyde reactions like bisulfite addition and the Schiff test. 

The above reversible equation indicates that one mol of aluminium iso-propoxlde will reduce directly three mols of the carbonyl compound. It is generally desirable to use excess of the reductant except for aromatic aldehydes for the latter side reactions (e.g., 2RCHO-----> RCOOCH R Tischenko re-... 

There also exists an acidregioselective condensation of the aldol type, namely the Mannich reaction (B. Reichert, 1959 H. Hellmann, 1960 see also p. 291f.). The condensation of secondary amines with aldehydes yields Immonium salts, which react with ketones to give 3-amino ketones (=Mannich bases). Ketones with two enolizable CHj-groupings may form 1,5-diamino-3-pentanones, but monosubstitution products can always be obtained in high yield. Unsymmetrical ketones react preferentially at the most highly substituted carbon atom. Sterical hindrance can reverse this regioselectivity. Thermal elimination of amines leads to the a,)3-unsaturated ketone. Another efficient pathway to vinyl ketones starts with the addition of terminal alkynes to immonium salts. On mercury(ll) catalyzed hydration the product is converted to the Mannich base (H. Smith, 1964). 

In contrast to oxidation in water, it has been found that 1-alkenes are directly oxidized with molecular oxygen in anhydrous, aprotic solvents, when a catalyst system of PdCl2(MeCN)2 and CuCl is used together with HMPA. In the absence of HMPA, no reaction takes place(100]. In the oxidation of 1-decene, the Oj uptake correlates with the amount of 2-decanone formed, and up to 0.5 mol of O2 is consumed for the production of 1 mol of the ketone. This result shows that both O atoms of molecular oxygen are incorporated into the product, and a bimetallic Pd(II) hydroperoxide coupled with a Cu salt is involved in oxidation of this type, and that the well known redox catalysis of PdXi and CuX is not always operalive[10 ]. The oxidation under anhydrous conditions is unique in terms of the regioselective formation of aldehyde 59 from X-allyl-A -methylbenzamide (58), whereas the use of aqueous DME results in the predominant formation of the methyl ketone 60. Similar results are obtained with allylic acetates and allylic carbonates[102]. The complete reversal of the regioselectivity in PdCli-catalyzed oxidation of alkenes is remarkable. 

In the reverse reaction, thioheteroaryl amides reacted under reflux in alcohol with haloketones or aldehydes to give the corresponding 2-heteroarylthiazole derivatives (238, 271, 482, 550, 751, 765, 776, 781). 2,2 -Bithiazoles (4,4 -disubstituted) have been obtained in 80 to 90% yield by cyclocondensation of 1 mole rubeanic acid with 2 moles of a-bromoketones in polyphosphoric acid at 95 to 135 C (780). Some multiheteroaryl substituted thiazoles have been also reported (704). 

Cyanohydrin formation is reversible and the position of equilibrium depends on the steric and electronic factors governing nucleophilic addition to carbonyl groups described m the preceding section Aldehydes and unhindered ketones give good yields of cyanohydrins... 

You have had earlier experience with enols m their role as intermediates m the hydration of alkynes (Section 9 12) The mechanism of enolization of aldehydes and ketones is precisely the reverse of the mechanism by which an enol is converted to a carbonyl compound... 

As with other reversible nucleophilic addition reactions the equilibria for aldol additions are less favorable for ketones than for aldehydes For example only 2% of the aldol addition product of acetone is present at equilibrium... 

Cleavage reactions of carbohydrates also occur on treatment with aqueous base for prolonged periods as a consequence of base catalyzed retro aldol reactions As pointed out m Section 18 9 aldol addition is a reversible process and (3 hydroxy carbonyl com pounds can be cleaved to an enolate and either an aldehyde or a ketone... 

The carbon-oxygen double bond of the carbonyl group is opened, and the hydrogen sulfite radical is added. An increase in temperature reverses the reaction more easily for ketones than for aldehydes. 

A new class of synthetic aldehyde reactions involves effectively reversing the polarity of the carbonyl group by forming a dithiane intermediate. 

Other Borohydrides. Potassium borohydride was formerly used in color reversal development of photographic film and was preferred over sodium borohydride because of its much lower hygroscopicity. Because other borohydrides are made from sodium borohydride, they are correspondingly more expensive. Generally their reducing properties are not sufficiently different to warrant the added cost. Zinc borohydride [17611-70-0] Zn(BH 2> however, has found many appHcations in stereoselective reductions. It is less basic than NaBH, but is not commercially available owing to poor thermal stabihty. It is usually prepared on site in an ether solvent. Zinc borohydride was initially appHed to stereoselective ketone reductions, especially in prostaglandin syntheses (36), and later to aldehydes, acid haHdes, and esters (37). 

These reversible reactions are cataly2ed by bases or acids, such as 2iac chloride and aluminum isopropoxide, or by anion-exchange resias. Ultrasonic vibrations improve the reaction rate and yield. Reaction of aromatic aldehydes or ketones with nitroparaffins yields either the nitro alcohol or the nitro olefin, depending on the catalyst. Conjugated unsaturated aldehydes or ketones and nitroparaffins (Michael addition) yield nitro-substituted carbonyl compounds rather than nitro alcohols. Condensation with keto esters gives the substituted nitro alcohols (37) keto aldehydes react preferentially at the aldehyde function. 

The reversible addition of sodium bisulfite to carbonyl groups is used ia the purification of aldehydes. Sodium bisulfite also is employed ia polymer and synthetic fiber manufacture ia several ways. In free-radical polymerization of vinyl and diene monomers, sodium bisulfite or metabisulfite is frequentiy used as the reduciag component of a so-called redox initiator (see Initiators). Sodium bisulfite is also used as a color preventative and is added as such during the coagulation of crepe mbber. 

Vanillin, being an aldehyde, is able to form acetals and hemiacetals. Therefore, in flavor formulations using high concentrations of vanillin in conjunction with carriers such as propylene glycol, a glc analysis often shows a reduced vanillin peak after storage of the compounded flavor, and the presence of new peaks indicating acetal formation. Addition of about 0.5% of water to the formula reverses the reaction, ie, there is a reduction of acetal, and the reappearance of vanillin peaks. 

In stepwise additions, ketenes are usually the nucleophilic component, so that such additions can be catalyzed by Lewis acids, such as the additions of trimethylsilylketenes to aldehydes, catalyzed by BF3 (Scheme 14) (79JOC733). However, the roles can be reversed, such as in the addition of chlorocyanoketene to benzaldehyde (79JA5435). 

Aldehydes and ketones undergo reversible addition reactions with alcohols. The product of addition of one mole of alcohol to an aldehyde or ketone is referred to as a hemiacetal or hemiketal, respectively. Dehydration followed by addition of a second molecule of alcohol gives an acetal or ketal. This second phase of the process can be catalyzed only by acids, since a necessary step is elimination of hydroxide (as water) from the tetrahedral intermediate. There is no low-energy mechanism for base assistance of this... 

Stereoselective epoxidation can be realized through either substrate-controlled (e.g. 35 —> 36) or reagent-controlled approaches. A classic example is the epoxidation of 4-t-butylcyclohexanone. When sulfonium ylide 2 was utilized, the more reactive ylide irreversibly attacked the carbonyl from the axial direction to offer predominantly epoxide 37. When the less reactive sulfoxonium ylide 1 was used, the nucleophilic addition to the carbonyl was reversible, giving rise to the thermodynamically more stable, equatorially coupled betaine, which subsequently eliminated to deliver epoxide 38. Thus, stereoselective epoxidation was achieved from different mechanistic pathways taken by different sulfur ylides. In another case, reaction of aldehyde 38 with sulfonium ylide 2 only gave moderate stereoselectivity (41 40 = 1.5/1), whereas employment of sulfoxonium ylide 1 led to a ratio of 41 40 = 13/1. The best stereoselectivity was accomplished using aminosulfoxonium ylide 25, leading to a ratio of 41 40 = 30/1. For ketone 42, a complete reversal of stereochemistry was observed when it was treated with sulfoxonium ylide 1 and sulfonium ylide 2, respectively. ... 

---