Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Reverse selective polymer membrane

The chemical composihons of the zeolites such as Si/Al ratio and the type of cation can significantly affect the performance of the zeolite/polymer mixed-matrix membranes. MiUer and coworkers discovered that low silica-to-alumina molar ratio non-zeolitic smaU-pore molecular sieves could be properly dispersed within a continuous polymer phase to form a mixed-matrix membrane without defects. The resulting mixed-matrix membranes exhibited more than 10% increase in selectivity relative to the corresponding pure polymer membranes for CO2/CH4, O2/N2 and CO2/N2 separations [48]. Recently, Li and coworkers proposed a new ion exchange treatment approach to change the physical and chemical adsorption properties of the penetrants in the zeolites that are used as the dispersed phase in the mixed-matrix membranes [56]. It was demonstrated that mixed-matrix membranes prepared from the AgA or CuA zeolite and polyethersulfone showed increased CO2/CH4 selectivity compared to the neat polyethersulfone membrane. They proposed that the selectivity enhancement is due to the reversible reaction between CO2 and the noble metal ions in zeolite A and the formation of a 7i-bonded complex. [Pg.338]

Chemical surface modification methods of gas-separation membranes include treatment with fluorine, chlorine, bromine, or ozone. These treatments result in an increase in membrane selectivity with a decrease in flux. Cross-linking of polymers is often applied to improve the chemical stability and selectivity of membranes for reverse osmosis, pervaporation, and gas-separation applications (41). Mosqueda-Jimenez and co-workers studied the addition of surface modifying macromolecules, and the use of the additive... [Pg.219]

Following a brief review of the development of dynamic membranes and an overview of the current state of the art, Spencer (10) discusses dynamic polyblend membranes. In particular, he looks at the Influence that polymer selection and membrane preparation procedures have on membrane performance. Dynamic membranes composed of a poly(acrylic acid)/basic polyamine blend deposited on a ZOSS (hydrous zirconium oxide on stainless steel) ultrafiltration membrane are discussed. Their hyperfiltration or reverse osmosis properties are compared to the more traditional ZOPA (zirconium oxide plus poly(acrylic acid)) membrane. [Pg.17]

The study of gas transport in membranes has been actively pursued for over 100 years. This extensive research resulted in the development of good theories on single gas transport in polymers and other membranes. The practical use of membranes to separate gas mixtures is, however, much more recent. One well-known application has been the separation of uranium isotopes for nuclear weapon production. With few exceptions, no new, large scale applications were introduced until the late 1970 s when polymer membranes were developed of sufficient permeability and selectivity to enable their economical industrial use. Since this development is so recent, gas separations by membranes are still less well-known and their use less widespread than other membrane applications such as reverse osmosis, ultrafiltration and microfiltration. In excellent reviews on gas transport in polymers as recent as 1983, no mention was made of the important developments of the last few years. For this reason, this chapter will concentrate on the more recent aspects of gas separation by membranes. Naturally, many of the examples cited will be from our own experience, but the general underlying principles are applicable to many membrane based gas separating systems. [Pg.559]

Facilitated transport membranes have been attracting attention since they have veiy high selectivity, compared with conventional polymer membranes (7). This high selectivity is attributable to carriers which can react reversibly with permeant specif There are two types of facilitated (carrier) transport membranes. One is the mobile carrier membrane in which the carrier can diffuse in the membrane, and the other is the fixed carrier membrane in ich the carrier cannot move. [Pg.252]

Polymer/sihca composite blends, not only improve the physical properties, snch as the mechanical properties and thermal properties of the materials, but they can also exhibit some unique properties that have attracted strong interest in many industries. Besides common plastics and rubber reinforcanent, many other potential and practical applications of this type of nanocomposites have been reported coatings, flame-retardant materials, optical devices, electronics and optical packaging materials, photo resist materials, photo-luminescent conducting film, per-vaporation membrane, ultra-permeable reverse-selective membranes, proton exchange membranes, grouting materials, sensors and materials for metal uptake, etc. As for the colloidal polymer/sihca nanocomposites with various morphologies, they usually exhibit enhanced, even novel, properties when compared with the traditional nanocomposites and have many potential applications in various areas. [Pg.93]

Nanocomposite mixed-matrix membranes have been investigated for close to a decade. Ti02-poly(amide-imide) membranes showed selectivity improvement but suffered loss of productivity when TiOa was added. Nonporous, nanoscale, fumed silica was embedded in a glassy, amorphous polymer, poly(4-methyl-2-pentyne), which resulted in enhancements in both permeability and selectivity for the mixed-matrix membrane. These membranes were discovered to be reverse selective, so the membrane is selective for the larger penetrant. This phenomenon is attributed to increased free volume in the bulk polymer from chain packing disruption, which occurs when the filler is added. ... [Pg.800]

Fig.4(a),(b)] show totally different morphology with introduction of cavity and tortuous surface on the film. The tortuous surface may be the migrations of Au NPs are directed to the surface. Also the distribution of Au NPs is uniform across the film without any agglomeration, which could have improved the polymer-filler interaction. This observation coincides with the reverse-selective nature of PDMS/Au membrane [Tablel]. [Pg.1852]


See other pages where Reverse selective polymer membrane is mentioned: [Pg.650]    [Pg.650]    [Pg.770]    [Pg.342]    [Pg.147]    [Pg.60]    [Pg.159]    [Pg.300]    [Pg.312]    [Pg.313]    [Pg.144]    [Pg.77]    [Pg.242]    [Pg.361]    [Pg.70]    [Pg.78]    [Pg.79]    [Pg.83]    [Pg.2215]    [Pg.183]    [Pg.22]    [Pg.859]    [Pg.37]    [Pg.2199]    [Pg.148]    [Pg.153]    [Pg.159]    [Pg.160]    [Pg.40]    [Pg.88]    [Pg.3]    [Pg.529]    [Pg.979]    [Pg.36]    [Pg.301]    [Pg.35]    [Pg.663]    [Pg.931]    [Pg.950]    [Pg.950]    [Pg.177]    [Pg.200]    [Pg.194]   
See also in sourсe #XX -- [ Pg.650 , Pg.800 ]




SEARCH



Membrane Polymer Selection

Membrane selection

Membrane selectivity

Polymer membranes

Polymer reversibility

Polymer selection

Reversed selectivity

Selectivity reversal

© 2024 chempedia.info