Replacement trichloride

Place 38 ml. of isopropanol in a two-necked 500 ml. round-bottomed flask fitted with (a) a reflux water-condenser having a calcium chloride tube at the top, and (b) a dropping-funnel. Cool the flask in ice-water and then run 13 5 ml. of phosphorus trichloride in from the dropping-funnel during 15 minutes. Then allow the reaction-mixture to attain room temperature. Now replace the condenser and the... 

The reaction of 2-methyla2iridine with boron trichloride [10294-34-5] lea.ds to replacement of all three chlorides by ayiridine rings to form tri(methylethyleneimine) boron [17862-61-2] (152). The reaction of boron trifluoride [7637-07-2] with ethyleneimine at — 78°C proceeds via substitution and subsequent ring opening to yield A/-P-fluoroethyl-fl-difluorobora2ene (153). 

Synthesis. Titanium alkoxy halides are intermediates in the preparation of alkoxides from a titanium tetrahaUde (except the fluoride) and an alcohol or phenol. If TiCl is heated with excess primary alcohol, only two chlorine atoms can be replaced and the product is dialkoxydichlorotitanium alcoholate, (RO)2TiCl2 ROH. The yields are poor, and some alcohols, such as aHyl, ben2yl, and /-butyl alcohols, are converted to chlorides (46). Using excess TiCl at 0°C, the trichloride ROTiCl is obtained nearly quantitatively, even from sec- and / f/-alcohols (47,48). 

TV-Amino groups are replaced by hydrogen on treatment with nitrous acid (e.g. 562 -> 563) (80AHC(27)24l) or phosphorus trichloride (l,2,4-triazole-4-acylimines are converted into triazoles (74AHC(17)213)). 

Jsomerides of Morphine and Codeine. When morphine is treated with thionyl chloride, phosphorus trichloride or tribromide, the alcoholic hydroxyl group is replaced by the halogen, forming a-chloromorphide and bromomorphide respectively. The former on treatment with concentrated hydrochloric acid is converted into /3-chloromorphide. Schopf and Hirsch have provided evidence that the two are structural isomerides. With the same reagents codeine yields a parallel set of compounds, viz., a- and -chlorocodides, and bromocodide. The chief characteristics of these products may be summarised thus —... 

Many reactions of fluorinated organics with metal halides result in the replacement of fluorine with halogen A general route to 1,1,1-trichloro- or tribromo-fluoroalkanes involves treating primary fluoroalkyl iodides with aluminum trichloride or aluminum tribromide [74], Benzylic [75, 76] or vinylic [72] fluorine can be exchanged for chlorine when treated with aluminum trichloride... 

Replacement of one of the benzene rings by pyridine in the fenamic acid-type analgesics leads to an agent with full pharmacologic activity. Treatment of the N-oxide of nicotinic acid with phosphorus trichloride followed by hydrolysis of the acid... 

Assay Methods. A Na carbonate fusion prod is currently used for assay of mil grade AP (see below under Specifications), but recently attempts have been made to replace it with a method which is faster and simpler to carry out. Two procs have been proposed a) Titanous Chloride Titration. A measured excess of Ti trichloride is added to a known weight of AP which reacts according to the equation ... 

Ammonia (NH3) and hypochlorite ion (OC1-) combine to produce three different chloramine species—that is, compounds that are derivatives of ammonia in which one or more of the hydrogen atoms has been replaced by a chlorine atom. In order of increasing degree of chlorine substitution, these chloramines are named monochloramine (NH2CI), dichloramine (NHCh), and nitrogen trichloride (NCI3) ... 

If, during the transfer, the pressure of boron trichloride should fall much below 15 mm., the Dewar vessel surrounding tube A should be lowered until the pressure rises to a satisfactory value and then replaced by another empty Dewar vessel at room temperature. It is also possible to achieve a relatively constant temperature by allowing a slow stream of compressed air to exit from a tube leading to the bottom of the Dewar vessel. 

The original method1 reported for the preparation of trichloroborazine involves the use of borazine. However, this procedure is not recommended because of the difficulty of preparing this heterocycle and its hydrolytic instability. More recently, this trichloroborazine has been prepared directly from ammonium chloride and boron trichloride at elevated temperatures with or without a solvent.2-8 Ammonium chloride may be replaced by a primary aliphatic or aromatic amine or its hydrochloride, and organodihaloboranes can be used in place of the boron trichloride to give the respective N- and B-substituted borazines.6 Boron tribromide has been used in analogous reactions to yield -B,/ , .B"-tribromoborazines.6... 

Simple dialkylmercury reagents react with phosphorus trichloride replacing a single halogen and leading to the alkyldichlorophosphine in reasonable yield (Equation 4.12).23... 

By controlling the stoichiometry of the reaction between lanthanide trichlorides and sodium cyclopentadienide it is possible to replace the chloride ions stepwise. Equihbria are rapidly established, so the addition of Ln(C5H5)3 to one or two equivalents of LnCls will produce M(C5H5)2C1 and M(C5H5)Cl2, respectively. The dichlorides are known only for the lanthanides from samarium to lutetium and are obtained from THF solutions as tris-THF adducts. 

Isoflurophate Isoflurophate, the di-wo-propyl ester of fluorophosphoric acid (13.2.21), is made by reacting Mo-propyl alcohol with phosphorous trichloride, forming di-wo-propy-Iphosphite (13.2.19), which is chlorinated to (13.2.20), and further reacted with sodium fluoride to replace the chlorine atom with fluorine, thus giving isofluorophate (13.2.21) [50]. 

Some reactions of 2,2 -bipyridine /V-oxides have been reported. The l,T-dioxide is nitrated readily to 4,4 -dinitro-2,2 -bipyridine 1,T-dioxide. ° ° °" 2,2 -Bipyridine 1-oxide is also nitrated in the 4 position. The nitro groups in 4,4 -dinitro-2,2 -bipyridine l,T-dioxide are reactive, being replaced by chlorine with concentrated hydrochloric acid," by bromine with acetyl bromide, by hydroxyl with dilute sulfuric acid, and by alkoxy groups with sodium alkoxides. Some of the dialkoxy derivatives are useful catalysts for the oxidation of aromatic compounds. The dinitro dioxide is deoxygenated to 4,4 -dinitro-2,2 -bipyridine with phosphorus trichloride in chloroform, and other substituted l,T-dioxides behave similarly, but with phosphorus trichloride alone, 4,4 -dichloro-2,2 -bipyridine results. The dinitro dioxide is reduced by iron powder in acetic acid to 4,4 -diamino-2,2 -bipyridine, whereas 4,4 -dichloro-2,2 -bipyridine l,T-dioxide is converted to its 4,4 -diamino analogs with amines. Related reactions have been described. ... 

Gugot Mixture—same as above, but replacing the chloro-sulfuric acid with the bromo-sulfuric Sophronius Mixture consisted of 3 parts of concentrated H2S04 and 2 parts of KMn04 In addition to these mixtures, it was proposed to use phosphorous trichloride, which catches fire on contact with either ammonia or ammonium hydrosulfide, NH4 HS... 

---