Reaction kinetics, distinguishing adsorption from surface

In the biomedical literature (e.g. solute = enzyme, drug, etc.), values of kf and kr are often estimated from kinetic experiments that do not distinguish between diffusive transport in the external medium and chemical reaction effects. In that case, reaction kinetics are generally assumed to be rate-limiting with respect to mass transport. This assumption is typically confirmed by comparing the adsorption transient to maximum rates of diffusive flux to the cell surface. Values of kf and kr are then determined from the start of short-term experiments with either no (determination of kf) or a finite concentration (determination of kT) of initial surface bound solute [189]. If the rate constant for the reaction at the cell surface is near or equal to (cf. equation (16)), then... 

In kinetic studies of heterogeneous catalysis, many schemes involving adsorption of reactants, reaction on the surface, and desorption of products have to be considered which differ less from first-order kinetics than the extremes given in Table III. However, it is just these schemes which we need to distinguish one from the other. 

It is important to distinguish clearly between the surface area of a decomposing solid [i.e. aggregate external boundaries of both reactant and product(s)] measured by adsorption methods and the effective area of the active reaction interface which, in most systems, is an internal structure. The area of the contact zone is of fundamental significance in kinetic studies since its determination would allow the Arrhenius pre-exponential term to be expressed in dimensions of area"1 (as in catalysis). This parameter is, however, inaccessible to direct measurement. Estimates from microscopy cannot identify all those regions which participate in reaction or ascertain the effective roughness factor of observed interfaces. Preferential dissolution of either reactant or product in a suitable solvent prior to area measurement may result in sintering [286]. The problems of identify-... 

In surface chemistry, adsorption isotherms describe the equiUhrium situation. However, just as in the consideration of the gas-phase chemistry in the interstellar medium, it is the kinetics of surface processes which are more relevant. Two mechanisms for surface-catalysed reactions can be distinguished and are illustrated by the cartoons in Fig. 1.6. In the Eley-Rideal mechanism, it is assumed that reaction occurs when a species (say, A) from the gas-phase impacts on a species (say, B) that is adsorbed on the surface. At significant surface coverage, the rate of reaction will be proportional to the product of the fraction of the surface covered in B (6b) and the pressure (p ) of the species A, which will be proportional to the rate of collisions of A with unit area of the solid surface. An alternative picture is encapsulated in the Langmuir-Hinshelwood mechanism. Here it is assumed that reaction occurs in encounters between species both of which are adsorbed on the surface. Then the rate of reaction will be proportional to the product of the fractions of the surface covered by A and by B that is proportional to 0a b-... 

---