Pyridine measurements

To fully characterize and categorize the solute selectivities of GC stationary phases, Rohrschneider and McRe5molds pioneered one of the earliest characterization methods [5,6]. The Rohrschneider-McReynolds system is the oldest and widely accepted stationary phase classification systems that is based on the retention of five probe molecules namely, benzene, bufanol, 2-penfanone, nifropropane, and pyridine. Each probe molecule is used to represenf a disfincf or a combination of interactions with the stationary phase. Benzene measures dispersive interactions with weak proton acceptor properties butanol measures dipolar interactions with both proton donor and proton acceptor capabilities 2-pentanone measures dipolar interactions with proton acceptor but not proton donor capabilities nitropropane measures weak dipolar interactions and pyridine measures weak dipolar interactions with strong proton acceptor but not proton donor capabilities. 

Bruceton coal was depolymerized in refluxing phenol using p-toluenesulfonic acid (HOTs) catalyst (29). The products were 91% extractable into pyridine and had a number average molecular weight of 400 in pyridine, measured by vapor pressure osmometry. Yet most of the materials in this solution have molecular weights above 2500. 

Table 12. N chemical shifts for a series of pyridines measured using...

Measurements on copper) I) chloride show the vapour to be the dimer of formula CU2CI2, but molecular weight determinations in certain solvents such as pyridine show it to be present in solution as single molecules, probably because coordination compounds such as py -> CuCl (py = pyridine) are formed. 

As early as 1889 Walker (320), using samples of thiazole, 2,4-dimethylthiazoie, pyridine, and 2,6-dimethylpyridine obtained from Hantzsch s laboratory, measured the electrical conductivity of their chlorhydrates and compared them with those of salts of other weak bases, especially quinoline and 2-methylquinoline. He observed the following order of decreasing proton affinity (basicity) quinaldine>2,6-dimethyl-pyridine>quinoline>pyridine>2,4-dimethylthiazole> thiazole, and concluded that the replacement of a nuclear H-atom by a methyl group enhanced the basicity of the aza-aromatic substrates. 

Soum and Fontanillet prepared a living polymer of 2-vin yl pyridine using benzyl picolyl magnesium as the initiator. The values of were measured experimentally for polymers prepared with different concentrations of initiator and different initial concentrations of monomer. The results are given below calculate the theoretical molecular weights expected if polymerization proceeds completely from 100% predissociated initiator and compare the theoretical and experimental values ... 

A iridine traces in aqueous solution can be determined by reaction with 4-(p-nitroben25l)pyridine [1083-48-3] and potassium carbonate [584-08-7]. Quantitative determination is carried out by photometric measurement of the absorption of the blue dye formed (367,368). Alkylating reagents interfere in the determination. A iridine traces in the air can be detected discontinuously by absorption in Folin s reagent (l,2-naphthoquinone-4-sulfonate) [2066-93-5] (369,370) with subsequent chloroform extraction and hplc analysis of the red dye formed (371,372). The detection limit is ca 0.1 ppm. Nitrogen-specific thermal ionisation detectors can be used for continuous monitoring of the ambient air. 

Quantitative Structure-Property Relationships. A useful way to predict physical property data has become available, based only on a knowledge of molecular stmcture, that seems to work well for pyridine compounds. Such a prediction can be used to estimate real physical properties of pyridines without having to synthesize and purify the substance, and then measure the physical property. 

Arsenic. Total arsenic concentration can be determined by reduction of all forms to arsine (AsH ) and collection of the arsine in a pyridine solution of silver diethyldithiocarbamate. Organoarsenides must be digested in acidic potassium persulfate prior to reduction. The complex that forms is deep red, and this color can be measured spectrophotometricaHy. Reduction is carried out in an acidic solution of KI—SnCl2, and AsH is generated by addition of 2inc. 

Cyanide compounds are classified as either simple or complex. It is usually necessary to decompose complex cyanides by an acid reflux. The cyanide is then distilled into sodium hydroxide to remove compounds that would interfere in analysis. Extreme care should be taken during the distillation as toxic hydrogen cyanide is generated. The cyanide in the alkaline distillate can then be measured potentiometricaHy with an ion-selective electrode. Alternatively, the cyanide can be determined colorimetricaHy. It is converted to cyanogen chloride by reaction with chloramine-T at pH <8. The CNCl then reacts with a pyridine barbituric acid reagent to form a red-blue dye. 

The acetyl content of cellulose acetate may be calculated by difference from the hydroxyl content, which is usually determined by carbanilation of the ester hydroxy groups in pyridine solvent with phenyl isocyanate [103-71-9J, followed by measurement of uv absorption of the combined carbanilate. Methods for determining cellulose ester hydroxyl content by near-infrared spectroscopy (111) and acid content by nmr spectroscopy (112) and pyrolysis gas chromatography (113) have been reported. 

The other analytical methods necessary to control the typical specification given in Table 5 are, for the most part, common quality-control procedures. When a chemical analysis for purity is desired, acetylation or phthalation procedures are commonly employed. In these cases, the alcohol reacts with a measured volume of either acetic or phthalic anhydride in pyridine solution. The loss in titratable acidity in the anhydride solution is a direct measure of the hydroxyl groups reacting in the sample. These procedures are generally free from interference by other functional groups, but both are affected adversely by the presence of excessive water, as this depletes the anhydride reagent strength to a level below that necessary to ensure complete reaction with the alcohol. Both procedures can be adapted to a semimicro- or even microscale deterrnination. 

Chemical shifts of pyridine and the diazines have been measured as a function of pH in aqueous solution and generally protonation at nitrogen results in deshielding of the carbon resonances by up to 10 p.p.m. (73T1145). The pH dependence follows classic titration curves whose inflexions yield pK values in good agreement with those obtained by other methods. 

Figure 2.28. Sequence of measurements to determine the spin-lattice relaxation times of the C nuclei of the pyridine ring in L-nicotine (46) [(CD3)2CO, 75 % v/v, 25 °C, inversion-recovery sequence, 20 MHz], The times at which signals pass through zero have been used to calculate, by equation 10, the T, values for the pyridine C atoms in L-nicotine...

Rgure 5 NEXAFS spectra above the C K-edge for a saturation coverage of pyridine C5H5N on Pt(111), measured at two different polarisation angles with the X-ray beam at normal incidence and at 20° to the sample surface. 

Intensity enhancement takes place on rough silver surfaces. Under such conditions, Raman scattering can be measured from monolayers of molecular substances adsorbed on the silver (pyridine was the original test case), a technique known as surface-enhanced Raman spectroscopy. More recendy it has been found that sur-fiice enhancement also occurs when a thin layer of silver is sputtered onto a solid sample and the Raman scattering is observed through the silver. 

The toughness of interfaces between immiscible amorphous polymers without any coupling agent has been the subject of a number of recent studies [15-18]. The width of a polymer/polymer interface is known to be controlled by the Flory-Huggins interaction parameter x between the two polymers. The value of x between a random copolymer and a homopolymer can be adjusted by changing the copolymer composition, so the main experimental protocol has been to measure the interface toughness between a copolymer and a homopolymer as a function of copolymer composition. In addition, the interface width has been measured by neutron reflection. Four different experimental systems have been used, all containing styrene. Schnell et al. studied PS joined to random copolymers of styrene with bromostyrene and styrene with paramethyl styrene [17,18]. Benkoski et al. joined polystyrene to a random copolymer of styrene with vinyl pyridine (PS/PS-r-PVP) [16], whilst Brown joined PMMA to a random copolymer of styrene with methacrylate (PMMA/PS-r-PMMA) [15]. The results of the latter study are shown in Fig. 9. 

Figure 4-12. Stopped-flow study of the pyridine-catalyzed hydrolysis of acetic anhydride, showing the formation and decay of the acetylpyridinium ion intermediate. Initial concentrations were 0.087 M pyridine, 2.1 x im M acetic anhydride the pH was 5.5 ionic strength, 1.0 M temperature, 25 C. Five hundred data points tabsorbance at 280 nm) were measured in I s. The smooth curve is a ht to Eq. (3-27). Source Data of D. Khossravi and S.-F. Hsu, University of Wisconsin.

Z values are obtained from Eq. (8-76) for solvents having Z in the approximate range 63-86. In more polar solvents the CT band is obscured by the pyridinium ion ring absorption, and in nonpolar solvents l-ethyl-4-carbomethoxy-pyridinium iodide is insoluble. By using the more soluble pyridine-1-oxide as a secondary standard and obtaining an empirical equation between Z and the transition energy for pyridine-1-oxide, it is possible to measure the Z values of nonpolar solvents. The value for water must be estimated indirectly from correlations with other quantities. Table 8-15 gives Z values for numerous solvents. 

Closely related to the basicity of pyridine is its hydrogen-bonding ability two indices of this property have been measured for a very short series of substituted pyridines and are very well correlated by CT-values. ... 

Few other reactions of series of substituted pyridines have been investigated extensively. Dondoni, Modena, and Todesco have measured the rate of N-oxidation of a limited series of pyridines and found a good correlation with normal u-values with a p-value of — 2.23. The A-alkylation of pyridines with alkyl iodides in nitrobenzene has been studied by Brown and Cahn and by Clarke and Rothwell. Unfortunately, the only data available are for the parent compound and for alkyl derivatives, and, since the a-values for the various alkyl groups in a given position are substantially constant, this leaves a correlation of only three independent points. However, the rates of A-alkylation of the j8- and y-alkyl derivatives are so nearly equal that it appears as if no correlation existed. Clarke and Rothwell have also studied the alkylation with allyl bromide in nitromethane at various temperatures, and in this case a more extensive series is available. The authors state that no overall Hammett correlation is obtained however, the j8-substituted derivatives fall on one straight line and the y-derivatives on another one with a different slope. The data are shown in Fig. 2. The line for the j8-compounds, p = — 2.53 0.31, r = 0.95, is seen not to be very good the line for the y-derivatives, p = — 1.42 0.06, r = 0.99, is much more satisfactory. It does not seem likely that the discrepancy is due to the intervention of resonance effects, since in this case one would expect the correlation for the y-derivatives to be poorer than that for the j8-analogs. More extensive studies with a wider variety of substituents would seem very desirable. 

The methods outlined, of course, are readily applicable to a wide variety of substituted heterocycles like the carboxyl, hydroxy and mercapto derivatives of pyridines, pyridine 1-oxides, pyrroles, etc. The application to amines and to diaza compounds such as pyrimidine, where the two centers are basic, is obvious except that now 23 takes the role of the neutral compound, 21 and 22 the roles of the tautomeric first conjugate bases, and 20 the role of the second conjugate base. Extensions to molecules with more than two acidic or basic centers, such as aminonicotinic acid, pyrimidinecarboxylic acids, etc., are obvious although they tend to become algebraically cumbersome, involving (for three centers) three measurable Kg s, four Ay s, and fifteen ideal dissociation constants (A ), a total of twenty-two constants of which seven are independent. 

---