Process simulation user-defined unit operations

Various degrees of effort can be applied in process simulation. A simple split balance can give a first overview of the process without introducing any physical relationships into the calculation. The user just defines split factors to decide which way the particular components take. In a medium level of complexity, shortcut methods are used to characterize the various process operations. The rigorous simulation with its full complexity can be considered as the most common case. The particular unit operations (reactors, columns, heat exchangers, flash vessels, compressors, valves, pumps, etc.) are represented with their correct physical background and a model for the thermophysical properties. 

Another example is the systematic analysis undertaken by Palsson et al. on combined SOFC and gas turbine cycles [36]. In combination with a robust and accurate 2-D SOFC model, the system-level model attempts to provide an unbiased evaluation of performance prospects and operational behaviours of such systems. The 2-D SOFC model was integrated into a process simulation tool. Aspen Plus , as a user-defined model, whereas other components constituting the system are modelled as standard unit operation models. Parametric studies can be carried out to gain knowledge of stack and system behaviour such as the influence of fuel and air flow rate on the stack performance and the mean temperature and the effects of cell voltage and compressor pressure on the system efficiency. The pressure ratio is shown to have a large impact on performance and electrical efficiencies of higher than 65% are possible at low-pressure ratios. 

---