Pressurized capillary electrochromatography pCEC

Applied pressure during CEC can decrease the separation time [30]. In this study the pressurized capillary electrochromatography (pCEC) coupled to NMR separated and identified a mixture of unsaturated fatty acid esters. The analysis time has been reduced by factor of 10 compared to nonpressurized CEC. 

A new analytical method, pressurized capillary electrochromatography (pCEC) with AD using 1.5 mm reversed phase nonporous silica packed columns has been developed for the rapid separation and determination of four Sudan dyes in hot chili [36]. The influence of several experimental parameters on the retention behavior has been investigated. The electrochemical oxidation of Sudans I-FV separated by pCEC can be reliably monitored with a carbon electrode at 0.95 V (vs. Ag/AgCl). Fast and efficient separation of the analytes was achieved within 7 min by pCEC under the optimum conditions. To evaluate the feasibility and reliability of this method, the proposed pCEC-AD method was further demonstrated with hot chili samples spiked with Sudan dyes. 

Several different analytical and ultra-micropreparative CEC approaches have been described for such peptide separations. For example, open tubular (OT-CEC) methods have been used 290-294 with etched fused silicas to increase the surface area with diols or octadecyl chains then bonded to the surface.1 With such OT-CEC systems, the peptide-ligand interactions of, for example, angiotensin I-III increased with increasing hydrophobicity of the bonded phase on the capillary wall. Porous layer open tubular (PLOT) capillaries coated with anionic polymers 295 or poly(aspartic acid) 296 have also been employed 297 to separate basic peptides on the inner wall of fused silica capillaries of 20 pm i.d. When the same eluent conditions were employed, superior performance was observed for these PLOT capillaries compared to the corresponding capillary zone electrophoresis (HP-CZE) separation. Peptide mixtures can be analyzed 298-300 with OT-CEC systems based on octyl-bonded fused silica capillaries that have been coated with (3-aminopropyl)trimethoxysilane (APS), as well as with pressurized CEC (pCEC) packed with particles of similar surface chemistry, to decrease the electrostatic interactions between the solute and the surface, coupled to a mass spectrometer (MS). In the pressurized flow version of electrochromatography, a pLC pump is also employed (Figure 26) to facilitate liquid flow, reduce bubble formation, and to fine-tune the selectivity of the separation of the peptide mixture. 

---