Powder packaging

Sodium borobydride is available as a 12% solution in caustic soda and in soHd form either as powder or pellets (3). The predominant form produced is the solution, the DOT shipping classification for which is corrosive Hquid. Forms of packaging are 18.9-L pails, 208.2-L dmms, and either tank tmck or tank car for bulk shipments. 1991 pricing for the solution form was 40.34/kg of borobydride contained. SoHd sodium borobydride, a white powder packaged in polyethylene bags in metal containers, was priced at 48.39/kg. 

Dosage form Simulect is a sterile lyophilized powder, packaged in glass vials. Each vial contains basiliximab 20 mg, to be reconstituted in sterile water for injection. 

Powder packaging of carbon blacks creates clusters of particles. The spaces between the clusters yield mesoporosity. Packed carbon blacks provide a fair multipore-... 

Insert fuse through hole In end of cardboard container Be sure It goes into Uack powder package. 

Thread fuse through hole in end cap and place package in end cap. Screw end cap onto pipe, being careful that black powder package is not caught between the threads ... 

Roll rag wad so that it is about 6 in (IS cm) long and has approximately the same diameter as the pipe. Push rolled rag into open-end of pipe until it rests against black powder package. 

Netherlands Spices, frozen products, poultry, dehydrated vegetables, rice, egg powder, packaging materials... 

The CPF-technology /8,9/ offers the possibility to change continuously the mixing composition of up to four powder components. Defined amount of powders were supplied to a form, open on the top and rotating horizontally, fall on a distributor which spreads them uniformly to the wall. The powder package must be fixed with a binder because only the centriftigal forces kept them in position. In our equipment the forming process is combined with a liquid binder supply... 

Measure off a length of fuse that will give the desired delay. Thread this through hole in bottom of container so that it penetrates into the black powder package. 

Insert fuse through hole in end of cardboard container. Be sure it goes into black powder package. 

Insert rag into front of shotgun. Pick rag against powder package with stick. Use caution. Method II - If Standard Shotgun is Used... 

---