Phase transfer catalyst phenol

Hypochlorite readily chlorinates phenols to mono-, di-, and tri-substituted compounds (163). In wastewater treatment chlotophenols ate degraded by excess hypochlorite to eliminate off-flavor (164). Hypochlorite converts btomoben2ene to cb1oroben2ene in a biphasic system at pH 7.5—9 using phase-transfer catalysts (165). 

The terminal R groups can be aromatic or aliphatic. Typically, they are derivatives of monohydric phenoHc compounds including phenol and alkylated phenols, eg, /-butylphenol. In iaterfacial polymerization, bisphenol A and a monofunctional terminator are dissolved in aqueous caustic. Methylene chloride containing a phase-transfer catalyst is added. The two-phase system is stirred and phosgene is added. The bisphenol A salt reacts with the phosgene at the interface of the two solutions and the polymer "grows" into the methylene chloride. The sodium chloride by-product enters the aqueous phase. Chain length is controlled by the amount of monohydric terminator. The methylene chloride—polymer solution is separated from the aqueous brine-laden by-products. The facile separation of a pure polymer solution is the key to the interfacial process. The methylene chloride solvent is removed, and the polymer is isolated in the form of pellets, powder, or slurries. 

Dichloro monomers can also be polymerized with bisphenols in the presence of fluorides as promoting agents.78 The fluoride ions promote the displacement of the chloride sites to form more reactive fluoride sites, which react with phenolate anion to form high-molecular-weight polymers. Adding 5-10 mol % phase transfer catalysts such as A-alkyl-4-(dialkylamino)pyridium chlorides significantly increased the nucleophilicity and solubility of phenoxide anion and thus shortened the reaction time to one fifth of the uncatalyzed reaction to achieve the same molecular weight.79... 

Cyanide and thiocyanate anions in aqueous solution can be determined as cyanogen bromide after reaction with bromine [686]. The thiocyanate anion can be quantitatively determined in the presence of cyanide by adding an excess of formaldehyde solution to the sample, which converts the cyanide ion to the unreactive cyanohydrin. The detection limits for the cyanide and thiocyanate anions were less than 0.01 ppm with an electron-capture detector. Iodine in acid solution reacts with acetone to form monoiodoacetone, which can be detected at high sensitivity with an electron-capture detector [687]. The reaction is specific for iodine, iodide being determined after oxidation with iodate. The nitrate anion can be determined in aqueous solution after conversion to nitrobenzene by reaction with benzene in the presence of sulfuric acid [688,689]. The detection limit for the nitrate anion was less than 0.1 ppm. The nitrite anion can be determined after oxidation to nitrate with potassium permanganate. Nitrite can be determined directly by alkylation with an alkaline solution of pentafluorobenzyl bromide [690]. The yield of derivative was about 80t.with a detection limit of 0.46 ng in 0.1 ml of aqueous sample. Pentafluorobenzyl p-toluenesulfonate has been used to derivatize carboxylate and phenolate anions and to simultaneously derivatize bromide, iodide, cyanide, thiocyanate, nitrite, nitrate and sulfide in a two-phase system using tetrapentylammonium cWoride as a phase transfer catalyst [691]. Detection limits wer Hi the ppm range. 

Alternatively, the Sn2 nucleophilic substitution reaction between alcohols (phenols) and organic halides under basic conditions is the classical Williamson ether synthesis. Recently, it was found that water-soluble calix[n]arenes (n = 4, 6, 8) containing trimethylammonium groups on the upper rim (e.g., calix[4]arene 5.2) were inverse phase-transfer catalysts for alkylation of alcohols and phenols with alkyl halides in aqueous NaOH solution to give the corresponding alkylated products in good-to-high yields.56... 

The 9,10-dihydrodiol of 3-MC (24a) was synthesized from 9-hy-droxy-3-MC by Method IV (86). Oxidation of this phenol with Fremy s salt in the presence of Adogen 464, a quaternary ammonium phase transfer catalyst, furnished 3-MC 9,10-dione. Reduction of the qui-none with NaBH -C gave pure 24a in good yield. Treatment of 24a with m-chloroperbenzoic acid was monitored by HPLC in order to optimize the yield of the anti diol epoxide (25 ) and minimize its decomposition. 

Imidoyl esters (Scheme 3.7) are obtained readily when the appropriate imidoyl chloride is reacted with an alcohol or phenol under basic conditions in the presence of phase-transfer catalysts [71]. The reaction with thiophenol yields the corresponding thioimidoyl ester. Diaroyl amides are produced by the analogous reaction of the imidoyl chloride and carboxylate anions. In this reaction, the initially formed carboxylic ester undergoes a 1,3-migration to produce the amide. 

General Procedure for PTC Catalyzed Arvl Bisplacement, Reactions. Alkali phenolate or thiolate, substrate, phase transfer catalyst, and a magnetic stirring bar were weighed into a dry stoppered flask under nitrogen. Solvent was added, and the reaction mixture was stirred and heated under the conditions described in the tables. Hydrocarbon internal standards (n-alkanes for VPC... 

Typical phase transfer catalysis in liquid-liquid systems combines processes in which Na+ or K+ salts of inorganic and organic anions derived from strong adds (phenolates, thiolates, carboxylates, etc.) are continuously transferred from aqueous (often alkaline) solutions to the organic phase by the phase transfer catalysts. Applications include nucleophilic substitution, addition, elimination, oxidation, and reduction reactions. 

The parent / -f-butylcalix[n] arenes (n = 4, 6, 8) are almost completely insoluble in water. However, their resemblance to crown ethers and spherands makes them interesting from the point of view of applications as phase transfer catalysts (Section 3.8.2). Table 3.20 shows the selectivity of calixarene 3.118 and its hexameric and octameric homologues for the extraction of various metal hydroxides into an organic receiving phase such as chloroform. Fortunately, in aqueous base the calixarenes are sufficiently soluble to act as phase transfer catalysts as a consequence of deprotonation of one of their phenolic hydroxyl groups. This solubility contrasts to [18] crown-6, which is much more effective in neutral solution. 

---