Permeability membrane sample preparation

The membrane is critically important in osomometry. Selection of a membrane involves reconciliation of high permeability toward the solvent with virtual impermeability to the smallest polymer molecules present in the sample. Membranes of cellulose are most widely used. Commercially Regenerated cellulose film is a common source. The undried gel cellophane film is often preferred, but the dry film may be swollen in water (or in aqueous solutions of caustic or zinc chloride ) to satisfactory porosity. Useful cellulose membranes may also be prepared by denitration of nitrocellulose films/ and special advantages have been claimed for bacterial cellulose films. The water in the swollen membrane in any case may be replaced by a succession of miscible organic solvents ending with the one in which osmotic measurements are to be made. Membranes of varying porosity may be... 

Based on the 96-well format, OCT-PAMPA was proposed and has proved its ability to determine (indirectly) log Poet [87]. PAM PA is a method, first developed for permeability measurements, where a filter supports an artificial membrane (an organic solvent or phospholipids) [88, 89]. With this method, the apparent permeability coefficient (log P ) of the neutral form of tested compounds is derived from the measurement of the diffusion between two aqueous phases separated by 1-octanol layer (immobilized on a filter). A bilinear correlation was found between log Pa and log Poct> therefore log Poet of unknown compounds can be determined from log Pa using a calibration curve. Depending on the detection method used a range oflog P within —2 to +5 (with UV detection) and within —2 to +8 (with LC-MS detection) was successfully explored. This method requires low compound amounts (300 pi of 0.04 mM test compound) and, as for the previous method, samples can be prepared in DM SO stock solutions. For these experiments, an incubation time of 4h was determined as the best compromise in term of discrimination. The limitation of the technique lies in the lower accuracy values... 

HT-solubility/permeability First, solubility is determined at four pH values by comparing the concentration of a saturated compound solution with its dilute, known as the concentration. The filtered, saturated solution from the solubility assay is then used as input material for the membrane permeability determination. The permeability assay is a parallel artificial membrane technique whereby a membrane is created on a solid support, PAMPA. The two artificial membranes presented here model the GIT and the BBB. Data are presented for control compounds, which are well documented in the literature and exemplify a range of solubility and membrane permeability. The advantages of the combination method are (/) reduction of sample usage and preparation time, ( /) elimination of interference from compound precipitation in membrane permeability determination, Hi) maximization of input concentration to permeability assay for improved reproducibility, and (/v) optimization of sample tracking by streamlining data entry and calculations. BBB permeability ranking of compounds correlates well with literature CNS activity. 

---