Periodate oxidation, determination

Methylation of free OH groups, followed by denitration, hydrolysis, reduction, and glc analysis has been suggested as a method for determining the location of nitrate (82). This method has been suggested for CP and CS (82) as the phosphate and sulfate groups are stable to methylation and can then be removed. Periodate oxidation has been used to determine the DS of CS (81). 

When a clean steel coupon is placed in oxygenated water, a rust layer will form quickly. Corrosion rates are initially high and decrease rapidly while the rust layer is forming. Once the oxide forms, rusting slows and the accumulated oxide retards diffusion. Thus, Reaction 5.2 slows. Eventually, nearly steady-state corrosion is achieved (Fig. 5.2). Hence, a minimum exposure period, empirically determined by the following equation, must be satisfied to obtain consistent corrosion-rate data for coupons exposed in cooling water systems (Figs. 5.2 and 5.3) ... 

Thus, if triose reductone is, in fact, the first intermediate in the periodate oxidation of malonaldehyde, the total consumption of periodate per mole of malonaldehyde should be four molar equivalents two moles of formic acid and one mole of carbon dioxide should be formed, in accordance with the sequence proposed by Fleury and his collaborators (22). As in the case of the periodate oxidation of malonic acid (32) the rate determining step should be the hydroxylation step. 

In addition to the foregoing examples, periodate oxidation has been applied to isotopically labeled sugars (for the determination of label distribution), 226 -226 to certain branched-chain sugars,227-229 and to some nitrogenous derivatives of the simple sugars.230-236... 

Measurement of the acidity produced in the periodate oxidation of carbohydrates is confined mainly to the determination of formic acid. Only from unsubstituted ketoses is the formation of such acids as glyoxylic and glycolic to be expected in carbohydrate chemistry.274... 

Since aldehydes are very common amongst periodate-oxidation products, analysis for them has been well developed and widely used. Most emphasis has been placed on methods for the assay of formaldehyde, as this is the most common product. Formaldehyde was first determined (in periodate work) by an oxidation method.2 47 66... 

Pacsu4 5 has suggested a structure for starch involving a small number of non-cyclic hemiacetal linkages, the number being presumably sufficient to account for the number of endgroups determined by the methylation method. Halsall, Hirst and Jones6 have commented on this structure, however, and have shown it to be incompatible with the results of periodate-oxidation studies. In addition, these authors pointed out that it would be difficult to explain enzymic hydrolysis and dextrin formation on the basis of such a structure. 

An ultraviolet spectrophotometric method based on the absorbance of a periodate oxidation product of pseudoephedrine hydrochloride will be the official method of analysis in the USP XX.19,20 A portion of tablets or syrup in water is placed in a separatory funnel. Sodium bicarbonate and sodium metaperiodate are added. After standing for 15 minutes, 1 N HC1 is added. The solution is extracted with hexane. The hexane extract is filtered and its absorbance determined at 242 nm in 1 cm cells. The amount of the oxidation product of pseudoephedrine hydrochloride is determined by comparison of the sample absorbance against the absorbance of a Pseudoephedrine Hydrochloride Reference Standard treated in the same manner. 

The oxidation may be performed at pH 5.0 by addition of an aqueous solution of sodium metaperiodate. The reaction is allowed to proceed in the dark at 4 °C and after 24 hours the excess periodate is destroyed by the addition of ethylene glycol. The aims in periodate oxidation are to elucidate the number of neighbouring hydroxyl groups by estimating the number of moles of periodate consumed and to determine the structure of the moiety remaining after the reaction. The amount of periodate used in the reaction may be determined in several ways, including titrimetric and spectrophotometric methods. 

If the products of periodate oxidation are reduced with sodium borohy-dride, polyalcohols are produced which may be readily hydrolysed under mildly acidic conditions and the reaction products can be determined. The identification of these products gives considerable information about the linkages between the polysaccharide components and also their sequence in the overall structure. 

Unsaturated acids may be split chemically at their double bonds. Permanganate-periodate oxidation has been used to produce the corresponding carboxylic acids, while an alternative technique of ozonolysis results in the formation of aldehydes and aldehyde esters. All these reaction products may be identified by GLC and the information used to determine the position of the double bond in the original fatty acid. 

The hexitols may be determined quantitatively by periodate oxidation. Either the amount of oxidant consumed or the amount of acid or formaldehyde liberated may be determined. This method will not... 

The position and geometry of the side chain double bonds can be determined by ozonolysis and a potassium permanganate-sodium periodate oxidation, as well as by the IR spectrum. Results have shown that the side chain double bonds are always Z 16,122,126). 

Trifluoroacetic acid is volatile, and thus readily removed. This acid was used by Albersheim and coworkers for the hydrolysis of plant cell-walls,39 and has since been employed for cell walls,40-43 plant mucilages,44 blood-group oligosaccharides,45 peptidogalactoman-nans,46 heparin,47 and disaccharides in blood and urine.48,49 It has also been suggested as an alternative to 6 M hydrochloric acid in the determination of amino sugars,50 and for the hydrolysis of polyalcohols produced by periodate oxidation of polysaccharides.503 Lee... 

---