Particles, monodisperse spherical

We have reported a simple, green, bench top, economical and environmentally benign room temperature synthesis of MSe (M=Cd or Zn) nanoparticles using starch, PVA and PVP as passivating agents. The whole process is a redox reaction with selenium acting as the oxidant and MSe as the reduction product. An entire "green" chemistry was explored in this synthetic procedure and it is reproducible. The optical spectroscopy showed that all the particles are blue shifted from the bulk band gap clearly due to quantum confinement. Starch capped CdSe nanoparticles showed the presence of monodispersed spherical... 

Figure 9.41 The relative changes of the surface area after gradual deposition of an additional component on the surface of monodisperse spherical particles depending on the degree of filling of pore volume, U, and initial porosity of a support s0.

Note that err = y (crr)a3/k Tand recall that in a concentrated dispersion the Peclet number is Pe = 67ry (crr)a3/k T. The use of the suspension viscosity implies that the particle diffusion can be estimated from an effective medium approach. Both Krieger and Cross gave the power law indices (n and m) as 1 for monodisperse spherical particles. In this formulation, the subscript c indicates the characteristic value of the reduced stress or Peclet number at the mid-point of the viscosity curve. The expected value of Pec is 1, as this is the point at which diffusional and convective timescales are equal. This will give a value of ac 5 x 10 2. Figure 3.15 shows a plot of Equation (3.57a) with this value and n = 1... 

Any study of colloidal crystals requires the preparation of monodisperse colloidal particles that are uniform in size, shape, composition, and surface properties. Monodisperse spherical colloids of various sizes, composition, and surface properties have been prepared via numerous synthetic strategies [67]. However, the direct preparation of crystal phases from spherical particles usually leads to a rather limited set of close-packed structures (hexagonal close packed, face-centered cubic, or body-centered cubic structures). Relatively few studies exist on the preparation of monodisperse nonspherical colloids. In general, direct synthetic methods are restricted to particles with simple shapes such as rods, spheroids, or plates [68]. An alternative route for the preparation of uniform particles with a more complex structure might consist of the formation of discrete uniform aggregates of self-organized spherical particles. The use of colloidal clusters with a given number of particles, with controlled shape and dimension, could lead to colloidal crystals with unusual symmetries [69]. 

To date, it has been difficult to produce monodisperse spherical powders from metal alkoxides with low valence, such as Al and Fe, because the hydrolysis and condensation of metal alkoxides in alcohol are too rapid to allow control of particle size, size distribution, and morphology. Many previous studies reported (28-30) that alkoxide-... 

Generally, alkoxide-derived monodisperse oxide particles have been produced by batch processes on a beaker scale. However, on an industrial scale, the batch process is not suitable. Therefore, a continuous process is required for mass production. The stirred tank reactors (46) used in industrial process usually lead to the formation of spherical, oxide powders with a broad particle size distribution, because the residence time distribution in reactor is broad. It is necessary to design a novel apparatus for a continuous production system of monodispersed, spherical oxide particles. So far, the continuous production system of monodisperse particles by the forced hydrolysis... 

Several monodisperse, spherical oxide particles were produced from the hydrolysis of metal alkoxide in ethanol or emulsion solution using the CTTR system. 

Preparation of Monodisperse, Spherical Oxide Particles by Hydrolysis of Metal Alkoxide Using a Couette-Taylor Vortex Flow Reactor... 

Monodisperse spherical oxide particles were prepared by the hydrolysis of metal alkoxide in homogeneous alcohol in an emulsion state. The formation mechanism from homogeneous alcohol and emulsion state was discussed by chronomal analysis and in situ observation using laser photo scattering. Two types of continuous systems for the industrial production of monodispersed oxide powders were also offered. 

In 1968, Stober et al. (18) reported that, under basic conditions, the hydrolytic reaction of tetraethoxysilane (TEOS) in alcoholic solutions can be controlled to produce monodisperse spherical particles of amorphous silica. Details of this silicon alkoxide sol-gel process, based on homogeneous alcoholic solutions, are presented in Chapter 2.1. The first attempt to extend the alkoxide sol-gel process to microemul-sion systems was reported by Yanagi et al. in 1986 (19). Since then, additional contributions have appeared (20-53), as summarized in Table 2.2.1. In the microe-mulsion-mediated sol-gel process, the microheterogeneous nature (i.e., the polar-nonpolar character) of the microemulsion fluid phase permits the simultaneous solubilization of the relatively hydrophobic alkoxide precursor and the reactant water molecules. The alkoxide molecules encounter water molecules in the polar domains of the microemulsions, and, as illustrated schematically in Figure 2.2.1, the resulting hydrolysis and condensation reactions can lead to the formation of nanosize silica particles. 

It can now be said that the microemulsion-mediated silicon alkoxide sol-gel process has come of age. The ability to form monodisperse spherical silica particles (20-39) and monolithic gels (40-53) by this method has been amply demonstrated. Recipes are available to prepare materials with predetermined characteristics, especially particle size and polydispersity. Potential applications of these microemulsion-derived... 

Consider the energy balance of radiant flux through a scattering medium of monodispersed spherical particles, in which absorption, emission, and scattering by spherical particles are included. As shown in Fig. 4.7, the equation for the change in monochromatic radiant... 

Equation (14) also provides a satisfactory description of the II-A isotherm for monodisperse spherical polystyrene particles 2.6 pm in diameter at the water/octane interface.40,41 For this system, fitting parameters using Eq. (14)... 

---