Palladium acetate malonates

Palladium acetate and triphenylphosphine generate the active tri- or tetrakis(triphenylphosphine)palladium(0) catalyst on addition of sodium dimethyl malonate. 

It has been reported that the reaction of aromatic compounds with sodium palladium(II) malonate in a mixed solvent of acetic acids and acetic anhydride or carbon tetrachloride gives aromatic acids in good yields, together with lower yields of aromatic dimers. 

Based on the above-mentioned stereochemistry of the allylation reactions, nucleophiles have been classified into Nu (overall retention group) and Nu (overall inversion group) by the following experiments with the cyclic exo- and ent/n-acetales 12 and 13[25], No Pd-catalyzed reaction takes place with the exo-allylic acetate 12, because attack of Pd(0) from the rear side to form Tr-allyl-palladium is sterically difficult. On the other hand, smooth 7r-allylpalladium complex formation should take place with the endo-sWyWc acetate 13. The Nu -type nucleophiles must attack the 7r-allylic ligand from the endo side 14, namely tram to the exo-oriented Pd, but this is difficult. On the other hand, the attack of the Nu -type nucleophiles is directed to the Pd. and subsequent reductive elimination affords the exo products 15. Thus the allylation reaction of 13 takes place with the Nu nucleophiles (PhZnCl, formate, indenide anion) and no reaction with Nu nucleophiles (malonate. secondary amines, LiP(S)Ph2, cyclopentadienide anion). 

Snyder and Smith prepared diethyl acetamidomalonate in 40% yield by reduction of diethyl isonitrosomalonate in ethanol over palladium on charcoal followed by direct acetylation of diethyl aminomalonate in the filtrate with acetic anhydride. Ghosh and Dutta used zinc dust instead of palladium. A modification using Raney nickel is described by Akabori et al. Shaw and Nolan reported a 98% yield by conversion of diethyl oximino-malonate-sodium acetate complex. 

Chiral phosphinous amides have been found to act as catalysts in enantio-selective allylic alkylation. Horoi has reported that the palladium-catalyzed reaction of ( )-l,3-diphenyl-2-propenyl acetate with the sodium enolate of dimethyl malonate in the presence of [PdCl(7i-allyl)]2 and the chiral ligands 45 gave 46 in 51-94% yields and up to 97% ee (Scheme 38). It is notorious that when the reaction is carried out with the chiral phosphinous amide (S)-45a, the product is also of (S) configuration, whereas by using (R)-45b the enantiomeric (R) product is obtained [165]. 

Allylic substitutions catalysed by palladium NHC complexes have been studied and the activity and selectivity of the catalysts compared to analogous Pd phosphine complexes. A simple catalytic system involves the generation of a Pd(NHC) catalyst in situ in THF, from Pdj(dba)j, imidazolium salt and Cs COj. This system showed very good activities for the substitution of the allylic acetates by the soft nucleophilic sodium dimethyl malonate (2.5 mol% Pdj(dba)3, 5 mol% IPr HCl, 0.1 equiv. C (CO ), THF, 50°C) (Scheme 2.22). Generation of the malonate nncleophile can also be carried out in situ from the dimethyhnalonate pro-nucleo-phile, in which case excess (2.1 equivalents) of Cs COj was used. The nature of the catalytic species, especially the number of IPr ligands on the metal is not clear. 

Scheme 2.22 Palladium-NHC complex catalysed substitution of allylic acetate by malonate...

Nucleophilic Substitution of xi-Allyl Palladium Complexes. TT-Allyl palladium species are subject to a number of useful reactions that result in allylation of nucleophiles.114 The reaction can be applied to carbon-carbon bond formation using relatively stable carbanions, such as those derived from malonate esters and (3-sulfonyl esters.115 The TT-allyl complexes are usually generated in situ by reaction of an allylic acetate with a catalytic amount of fefrafcz s-(triphenylphosphine)palladium... 

The first iridium catalysts for allylic substitution were published in 1997. Takeuchi showed that the combination of [fr(COD)Cl]2 and triphenylphosphite catalyzes the addition of malonate nucleophiles to the substituted terminus of t -allyliridium intermediates that are generated from allylic acetates. This selectivity for attack at the more substituted terminus gives rise to the branched allylic alkylation products (Fig. 4), rather than the linear products that had been formed by palladium-catalyzed allylic substitution reactions at that time [7]. The initial scope of iridium-catalyzed allylic substitution was also restricted to stabilized enolate nucleophiles, but it was quickly expanded to a wide range of other nucleophiles. 

Blechert reported a skillful method of cross-enyne metathesis. Solid-supported alkyne 139 is reacted with alkene in the presence of Ic to give 140. For cleavage of 1,3-diene from solid-supported product 140 having an allyl acetate moiety, palladium-catalyzed allylic substitution is used. Thus, 140 is treated with Pd(PPh3)4 in the presence of methyl malonate to afford three-component coupling product 141 in good yield ... 

Treatment of the (—)-menthone-derived 2/7-1,3-benzoxazin-4(3//)-one 202 with triflic anhydride gave the triflate 203 in quantitative yield. Palladium-catalyzed cross-coupling of 203 with 2-pyridylzinc halide resulted in formation of an approximately 3 1 mixture of the 4-(2-pyridyl)-2//-l,3-benzoxazine 204 and a 4-imino-l,3-benzodioxane derivative 205 (Scheme 36). Compound 205 was formed by the isomerization of 203, which occurred with complete retention of stereochemistry. The 4-(2-pyridyl)-l,3-benzoxazine derivative 204 was applied in enantioselective allylic alkylations of 1,3-diphenyl-2-propenyl acetate with dimethyl malonate as a chiral ligand inducing a 62% ee in the product <2005JOM(690)2027>. 

TABLE 8.34. PALLADIUM-CATALYZED ALKYLATION OF DTPHFNYT AT.TYT. ACETATE WITH DIMETHYL MALONATE... 

TABLE 8.35 PALLADIUM-CATALYZED ALKYLATION OF DIMF.THYT AT T YT. ACETATE AND DIMETHYLALLYL l-BUTYLCARBONATE WITH DIMETHYL MALONATE, 490... 

In 1992, Legros and Fiaud found palladium-catalyzed benzyiic alkylation of naphthylmethyl and 1-naphthylethyl esters 103 with sodium dimethyl malonate 104 in dimethylformamide (DMF) to give the corresponding benzyiic alkylated products 105 in high yields (Equation (41)). " When trifluoroacetyl group is used as a leaving group of the ester partner, catalytic alkylation proceeds quite smoothly even at room temperature. In this reaction system, no reaction occurs with benzyiic acetates. 

No reaction of soft carbon nucleophiles takes place with propargylic acet-ates[37], but soft carbon nucleophiles, such as /7-keto esters and malonates, react with propargylic carbonates under neutral conditions using dppe as a ligand. The carbon nucleophile attacks the central carbon of the ir-alleny[palladium complex 81 to form the 7r-allylpalladium complex 82, which reacts further with the carbon nucleophile to give the alkene 83. Thus two molecules of the a-monosubstituted /7-keto ester 84, which has one active proton, are... 

Figure 8.9 Results of palladium-catalyzed asymmetric allylic alkylation of 1,3-di phenyl al lyl acetate and dimethyl malonate upon applying a ligand library of self-assembled bidentate ligands. The ligands a-i on the x-axis are defined in Figure 8.8. 

Palladium-catalyzed coupling of allylic acetate 113 (Scheme 23) with diethyl malonate, or with acetylated diethyl tartronate, yielded the Boc-protected allylic amines 114 in 99 1 E stereoselectivity.1 "1 Saponification of 114 (R1 = H) and decarboxylation gave the Tyr- Ala alkene isostere 116 in quantitative yield, whereas 114 (R = OAc) was converted into the Tyr-Gly alkene isostere 115 in a two-step procedure in 62% overall yield. Considering the number of steps and the overall yield, this procedure is among the most efficient to prepare Xaatp, CH=CH]Gly dipeptide isosteres. 

---