Other Acyclic Aldehydes

The homoallylation product 16a presumably stems from oxidative cycloaddition of a Ni(0) species across the diene and aldehyde moieties of 15, leading to an oxanickellacycle intermediate 17 (path A, Scheme 5), which undergoes 0-bond metathesis with triethylsilane giving rise to a o-allylnickel 19. On the other hand, formation of 16b may start with addition of a Ni - H species upon the diene followed by intramolecular nucleophilic allylation as described in Eqs. 4-6 (path B). Alternatively, allylic transposition of the NiH group providing 20 from 19 may be related to the formation of 16b. The different reactivity between cyclohexadiene and many other acyclic dienes is also observed for the reaction undertaken under typical homoallylation conditions (see Scheme 14). 

In subsequent studies, methyl vinyl ketone (2.0 mmole) was chosen as the dienophile so as to determine the combined effect of the ionic liquid (2 mL) and the Lewis acids (0.2 and 0.5 wt%) upon the yield and selectivity. Without the Lewis acid catalyst, this system demonstrated a 52% conversion of the cyclopentadiene (2.2 mmol) in 1 h with the endojexo selectivity being 85/15. The cerium triflate-catalyzed reaction was quantitative in 5 min and the endo. exo selectivity was very good for this experiment as well (94 6, endo. exo). Also with the scandium or yttrium salts tested, reactions came to completion in a short time with high stereo-selection. Cerium, scandium and yttrium triflates are strong Lewis acids known to be quite effective catalysts in the cycloadditions of cyclopentadiene with acyclic aldehydes, ketones, quinones and cycloalkenones. These compounds are expected to act as strong Lewis acids because of their hard character and the electron-withdrawing triflate group. On the other hand, reaction times of 1 hour were required for... 

Aromatic aldehydes react very easily with tetramic acid under acidic conditions to give 3-benzylidene compounds (41). The yields are moderate, because often there are subsequent reactions. As a,/3-unsaturated carbonyl compounds, (41) react in a Michael addition with excess tetramic acid to form (67), but it can also react with other acyclic and cyclic 1,3-dicarbonyl compounds. In these reactions the aryl substituents may vary over a wide range. Thus, (67) and (68) can be cyclized with ammonium acetate to afford pharmacologically interesting compounds (70) and (71) (90TH1). The latter are dihydropyridines. Curiously, (69) does not cyclize under these conditions. (See Fig. 32.)... 

In general, a six-membered pyranose form is preferred over a five-membered furanose form because of the lower ring strain, and these cyclic forms are very much favoured over the acyclic aldehyde or ketofte forms. As can be seen in Table 1.3, at equilibrium, the anomeric ratios of pyranoses differ considerably between aldoses. These observations are a direct consequence of differences in anomeric and steric effects between monosaccharides. The amount of the pyranose and furanose present in aqueous solution varies considerably for the different monosaccharides. Some sugars, such as D-glucose, have undetectable amounts of furanose according H-NMR spectroscopic measurements whereas others, such as D-altrose, have 30% furanose content under identical conditions. 

A number of other acyclic Z and E lithium enolates were quenched similarly. In all cases the stereochemistry at the enol double bond was retained, as shown by subsequent conversion into the corresponding silyl enol ether. Upon reacting the titanium enolates with aldehydes, very clean aldol addition occured (>90% conversion at —78 °C). Generally, erythro-selectivity was observed irrespective of the geometry of the enolate. Equations 64 and 65 are typical25). 

This latter was employed in the enantioselective addition of diethylzinc to aromatic and aliphatic aldehydes. For example, (S)-l-phenylpropanol was isolated in a yield of 92% and an ee of 96% when the reaction was performed in a 1/1 mixture of toluene and dichloromethane. The presence of dichloromethane proved to be essential for swelling of the polymer and making the catalytic sites accessibles to substrates. With other aromatic aldehydes and cyclohexane carboxaldehyde, the same range of chemical yield and ee was obtained. But with acyclic aliphatic aldehydes the chemical yield and ee dropped significantly. The recyclability of the chiral polymer 160 has been investigated and it was noticed a slightly decrease of the enantioselectivity of 1% per run. 

A significant acyclic sesquiterpenic aldehyde occurring in orange essential oil is a-sinensal (8-41), which is formed by oxidation of (3 ,6 )-a-farnesene. The mandarin essential oil contains P-sinensal (8-41), which is produced by oxidation of ( )-P-farnesene (8-7). Some other sesquiterpenic aldehydes are minor, but still significant components of citrus oils, such as monocyclic aldehyde lanceal (8-41) andbicyclic aldehyde bergamotenal (8-41). 

If there is no other interaction, the reaction proceeds through an acyclic TS and steric factors determine the amount of syn versus anti addition. This is the case with BF3, where the tetracoordinate boron-aldehyde adduct does not offer any free coordination sites for formation of a cyclic TS. Stereoselectivity increases with the steric bulk of the silyl enol ether substituent R1.50... 

In contrast to the other large cats, the urine of the cheetah, A. jubatus, is practically odorless to the human nose. An analysis of the organic material from cheetah urine showed that diglycerides, triglycerides, and free sterols are possibly present in the urine and that it contains some of the C2-C8 fatty acids [95], while aldehydes and ketones that are prominent in tiger and leopard urine [96] are absent from cheetah urine. A recent study [97] of the chemical composition of the urine of cheetah in their natural habitat and in captivity has shown that volatile hydrocarbons, aldehydes, saturated and unsaturated cyclic and acyclic ketones, carboxylic acids and short-chain ethers are compound classes represented in minute quantities by more than one member in the urine of this animal. Traces of 2-acetylfuran, acetaldehyde diethyl acetal, ethyl acetate, dimethyl sulfone, formanilide, and larger quantities of urea and elemental sulfur were also present in the urine of this animal. Sulfur was found in all the urine samples collected from male cheetah in captivity in South Africa and from wild cheetah in Namibia. Only one organosulfur compound, dimethyl disulfide, is present in the urine at such a low concentration that it is not detectable by humans [97]. 

A straightforward method for aldolizing unsymmetrical ketones on the more hindered side involves the use of catalytic titanium(lV) chloride in toluene at room temperature. For examples using acyclic and cyclic ketones, and linear, branched, and aromatic aldehydes, the regioselectivity varied from 7 1 to >99 1, while the symanti ratios were moderate to good, and yields were in the range 62-91%. In contrast to other methods, base is not required, and the ketone can be used as is (i.e. the silyl enol ether is not required). 

The first asymmetric enamine-catalyzed Mannich reactions were described by List in 2000 [208]. Paralleling the development of the enamine-catalyzed aldol reactions, the first asymmetric Mannich reactions were catalyzed by proline, and a range of cyclic and acyclic aliphatic ketones were used as donors (Schemes 24 and 25). In contrast to the aldol reaction, however, most Mannich reactions are syn selective. This is presumably due to the larger size of the imine acceptor, forcing the imine and the enamine to approach each other in a different manner than is possible with aldehyde acceptors (Scheme 23). 

Acyclic acetals are simple protecting groups for aldehydes and ketones, and we have previously reported their synthesis catalyzed by Bi(OTf)3 [104]. Acyclic acetals can also be converted to other useful functional groups. For example, allylation of acyclic acetals to give homoallyl ethers has been well investigated, and we have reported a Bi(OTf)3-catalyzed method for the same [105]. The success of Bi(OTf)3-catalyzed formation and allylation of acyclic acetals prompted us to develop a one-pot method for the synthesis of homoallyl ethers from aldehydes, catalyzed by bismuth triflate. A one-pot process saves steps by eliminating the need for isolation of the intermediate and thus minimizes waste. Three one-pot procedures for the synthesis of homoallyl ethers were developed [106]. 

---