Olefin complexes hydrosilylation

By analogy with hydroformylation, dicobalt octacarbonyl has been examined as a hydrosilylation catalyst. Various silanes and a-olefins react, often exothermically. Thermal deactivation occurs above 60° C hence, large exotherms and high temperatures must be avoided (56, 57,130). Isomerization is more pronounced than for the bridged olefin complexes of Pt(II) and Rh(I) (see below) it even occurs with trialkoxysilanes (57). Though isomerization is faster than hydrosilylation, little variation in the relative rates of these two processes with the nature of the silane is observed this is in marked contrast to the bridged systems (55). 

The use of tri-tert-butylphosphine has produced still higher selectivities, allowing near total control in the synthesis of (A)-vinylsilanes, including alkoxysilanes and disiloxanes.38,39 In the context of a total synthesis of an HMG-CoA reductase inhibitor, hydrosilylation with a chlorosilane catalyzed by a platinum(O) olefin complex, Pt2 [(CH2=CH)Me2Si]20 3 (also known as Karstadt s catalyst), followed by coupling with a 2,6-disubstituted aryl iodide forged a key intermediate shown in Scheme 6.38... 

Titanium-catalyzed cyclization/hydrosilylation of 6-hepten-2-one was proposed to occur via / -migratory insertion of the G=G bond into the titanium-carbon bond of the 77 -ketone olefin complex c/iatr-lj to form titanacycle cis-ll] (Scheme 16). cr-Bond metathesis of the Ti-O bond of cis- iij with the Si-H bond of the silane followed by G-H reductive elimination would release the silylated cyclopentanol and regenerate the Ti(0) catalyst. Under stoichiometric conditions, each of the steps that converts the enone to the titanacycle is reversible, leading to selective formation of the more stable m-fused metallacycle." For this reason, the diastereoselective cyclization of 6-hepten-2-one under catalytic conditions was proposed to occur via non-selective, reversible formation of 77 -ketotitanium olefin complexes chair-1) and boat-1), followed by preferential cyclization of chair-1) to form cis-11) (Scheme 16). 

Yttrium-catalyzed cascade cyclization/hydrosilylation of 3-(3-butynyl)-l,5-hexadienes was stereospecific, and syn-19 (R =Gy, R = OGPh3) underwent cascade cyclization/hydrosilylation to form 80b (R = Gy, R = OGPh3) in 97% yield as a single diastereomer (Scheme 20). The regio- and stereoselective conversion of syn-19 to 80b was proposed to occur through an initial 5- x -intramolecular carbometallation via a chairlike transition state that resembles alkenyl olefin eomplex syn- m. followed by S-exo intramolecular carbometallation via a boatlike transition state that resembles alkyl olefin complex boat-llm. The second intramolecular carbometallation presumably occurs via a boatlike transition state to avoid the unfavorable 1,3-interaction present in the corresponding chairlike transition state (Scheme 20). 

The mechanism of platinum-catalyzed hydrosilylation was studied in detail by Chalk and Harrod (Scheme 18.10). The catalyticaUy active species [PtCl4] is obtained by a reduction of [PtClg] with isopropanol. One of the Cl ligands is then replaced with the olefin (A), whereby a 16 VE (VE = valence electron) r -olefin complex forms. Subsequent oxidative addition of external... 

The olefin complexes of platinum(II) resemble those of rhodium(I) in being very effective catalysts for addition of silanes to olefinic compounds (66). The following results have been found for the hydrosilylation of hexene-1 ... 

Although the polymerization prowess of organolanthanide complexes has been known for some time, efforts to apply these catalysts to small molecule synthesis have only recently begun. The selectivity of these metallocenes is predominantly steric in nature, and they are compatible with a wide variety of organic functional groups. A review of their use in olefin hydrogenation,hydrosilylation, and polyene cydization with emphasis on chemoselectivity and diastereoselectivity is presented here. The various ways in which the catalysts and reagents can be tuned to produce the desired products is also discussed. 

Reactions of 2-alkenes, 3-alkenes, etc., with monohydrosilanes lead predominantly to alkylsilanes with terminal silyl group, which means that in the presence of transition metal complexes, hydrosilylation is accompanied by the isomerization of olefins. The formation of adducts with an internal silyl group is also possible, especially in the presence of chiral platinum and palladium complexes (8). 

The proposed mechanism for the hydrosilylation of olefins catalyzed by chloroplatinic acid is outlined in Fig. 6. Catalysis by square-planar or trigonal bipyramidal rf complexes can be similarly described (54, 55, 105). 

Excess of the olefin is desirable so that the formation of Si—Co complexes [Eq. (112) and Section II,B,7] is suppressed 54, 57). These silyl complexes are not hydrosilylation catalysts. 

It is probable that during hydrosilylations these Ni(II) complexes are reduced to 7r-olefin Ni(0) species which then undergo an oxidative addition in an identical manner to that already discussed for the chloroplatinic acid case. There is current interest in such oxidations (83), and the platinum analog (Ph3P)2Pt(olefin) has been shown in one case (olefin = C2H4) to be an excellent hydrosilylation catalyst (240). In this system, intermediate low oxidation state Pt species have been isolated their nature is dependent on the electronegativity of the other groups attached to silicon. 

Very recently, the yttrium hydride [2,2 -bis(tert-butyldimethylsilylamido)-6,6 -di-methylbiphenyl]YH(THF) 2 (36), conveniently generated in situ from [2,2 -bis(tert-butyldimethylsilylamido)-6,6 -dimethylbiphenyl]YMe(THF)2 (35) demonstrated its high catalytic activity in olefin hydrosilylation. This system represents the first use of a d° metal complex with non-Cp ligands for the catalytic hydrosilylation of olefins. Hydrosilylation of norbornene with PhSiHs gave the corresponding product (37) of 90% ee (Scheme 3-15) [43]. 

The mechanism for the reaction catalyzed by cationic palladium complexes (Scheme 24) differs from that proposed for early transition metal complexes, as well as from that suggested for the reaction shown in Eq. 17. For this catalyst system, the alkene substrate inserts into a Pd - Si bond a rather than a Pd-H bond [63]. Hydrosilylation of methylpalladium complex 100 then provides methane and palladium silyl species 112 (Scheme 24). Complex 112 coordinates to and inserts into the least substituted olefin regioselectively and irreversibly to provide 113 after coordination of the second alkene. Insertion into the second alkene through a boat-like transition state leads to trans cyclopentane 114, and o-bond metathesis (or oxidative addition/reductive elimination) leads to the observed trans stereochemistry of product 101a with regeneration of 112 [69]. 

These complexes anchored to a solid via a ligand have been tested for a number of reactions including the hydrogenation, hydroformylation, hydrosilylation, isomerization, dimerization, oligomerization, and polymerization of olefins carbonylation of methanol the water gas shift reaction and various oxidation and hydrolysis reactions (see later for some examples). In most cases, the characterization of the supported entities is very limited the surface reactions are often described on the basis of well-known chemistry, confirmed in some cases by spectroscopic data and elemental analysis. 

One or both carbonyls in /3-diketones can be reduced, as well as the carbonyl function in acyl cyanides (210). Similar treatment of a,/3-unsat-urated ketones and aldehydes can lead to the saturated carbonyl products via selective reduction of the olefinic bond (207, 208, 210) see Eq. (51) in Section III,A,4. Some terpenes (a- and /3-ionone, pulegone) were reduced in this way (208). Platinum(II) phosphine complexes have been used for the hydrosilylation of saturated ketones and could be used for the reduction (211). 

Quite recently, ruthenium carbene complexes more typically known as olefin metathesis catalysts have been shown to act as alkyne hydrosilylation catalysts.78,79 7Vzz r-addition is the major product with trialkylsilanes, even in a single example with an internal alkyne.78 This result represents one of the very few examples of fra r-hydrosilylation of internal alkynes. 

A hydrosilylation/cyclization process forming a vinylsilane product need not begin with a diyne, and other unsaturation has been examined in a similar reaction. Alkynyl olefins and dienes have been employed,97 and since unlike diynes, enyne substrates generally produce a chiral center, these substrates have recently proved amenable to asymmetric synthesis (Scheme 27). The BINAP-based catalyst employed in the diyne work did not function in enyne systems, but the close relative 6,6 -dimethylbiphenyl-2,2 -diyl-bis(diphenylphosphine) (BIPHEMP) afforded modest yields of enantio-enriched methylene cyclopentane products.104 Other reported catalysts for silylative cyclization include cationic palladium complexes.105 10511 A report has also appeared employing cobalt-rhodium nanoparticles for a similar reaction to produce racemic product.46... 

It is well documented that hydrosilylation of alkyl-substituted terminal olefins catalyzed by transition metal complexes proceeds with high regioselectivity in giving linear hydrosilylation products which do not possess a stereogenic carbon center.2 It follows that the asymmetric synthesis by use of the hydrosilylation of alkyl-substituted... 

---