Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Of graphite-epoxy composite

Energy Impact Strength of Graphite/Epoxy Composites An Initial Exploration , PLASTEC Note N25 (1973) 41) N.E. Beach, Govern-... [Pg.789]

Madhukar, M.S. and Drzal, L.T. (1991). Fiber-matrix adhesion and its effects on composite mechanical properties II. Longitudinal (0°) and transverse (90°) tensile and flexural behaviour of graphite/epoxy composites. J. Composite Mater. 25, 958-991. [Pg.89]

Morris, D.H. and Hahn, H.T. (1977). Fracture resistance characterisation of graphite/epoxy composites. In Composite Materials Testing and Design (Fourth Conf), ASTM STP 617, ASTM, Philadelphia, PA, pp. 5 17. [Pg.276]

Jea L.C. and Felbeck D.K. (1980). Increased fracture toughness of graphite epoxy composites through intermittent interlaminar bonding. J. Composite Mater. 15, 245-159,... [Pg.323]

Rhee, H.W. and Bell, J.P. (1991). Effects of reactive and non-reactive fiber coatings upon performance of graphite/epoxy composites. Polym. Composites 12, 213-225. [Pg.326]

Ishai O., Rosenthal H., Sela N. and Drukker E. (1988). Effect of selective adhesive interleaving on interlaminar fracture toughness of graphite/epoxy composite laminates. Composites 19, 49-54. [Pg.362]

Figure 11. Sketch of the specimen and test configuration to detect EE and AE from the interlaminar fracture of graphite/epoxy composites. Figure 11. Sketch of the specimen and test configuration to detect EE and AE from the interlaminar fracture of graphite/epoxy composites.
Loos, A., Springer, G. Curing of Graphite/Epoxy Composites, Air Force Contract AFWAL-TR-83-4040, Interim Report for June 1982-March 1983... [Pg.315]

On the other hand, manually mix epoxy resin and hardener in the ratio 20 3 (w/w) using a spatula. When the resin and hardener are well mixed, add the graphite powder (particle size 50 pm) in the ratio 20 80 (w/w) and mix thoroughly for 30 min to obtain a homogeneous paste of graphite-epoxy composite. Place the resulting paste into the cylindrical PYC sleeve, onto the copper disk. [Pg.1315]

Incorporate the neodymium magnet into the body of the paste of graphite-epoxy composite, 2 mm under the surface of the electrode [1] and continue placing the paste until filling all the cavity. Cure the conducting composite at 40°C during 1 week. Once the resin is hardened, polish the surface first with abrasive paper and then with alumina paper. [Pg.1315]

Kibler, K. G. Time-dependent Environmental Behavior of Graphite/Epoxy Composites. U.S. Air Force Wright Aeronautical Laboratories Report AFWAL-TR-80-4052 (1980)... [Pg.169]

Ascorbic acid (1) is most commonly used for testing the performance of electrodes in redox systems. Thus, a Ag-Ag ascorbate selective electrode was constructed with view to use it for vitamin C determination. Its reproducibility and stability was satisfactory and ascorbate ion concentration could be determined in neutral, alkaline and alcoholic media" . A voltametric study was carried out for the evaluation of graphite-epoxy composite (GEC) electrodes for use in the determination of ascorbic acid and hydroquinone. They were compared with mercury and CPE in similar operating conditions of pH and supporting electrolytes. Like all redox electrodes, also GEC electrodes deteriorate on exposure to air or after repeated usage, and the surface had to be renewed for activation. GEC electrodes were found to be adequate for redox system analyses"". The electrocatalytic oxidation of 1 is an amplification method for determination of specific miRNA strands using the An biosensor described in Table 1 . [Pg.699]

Balageas cl al. showed that measuring both the apparent elTusivity of a composite and the thermal resistance between two layers can be a useful exercise in the determination of the depth at which delamination has occurred in carbon epoxy laminates [73]. The heat flow in a single layer of graphite epoxy composite with a constant flux applied to one surface is given by [74]... [Pg.794]

A study of radiographic parameter variations due to low-energy inspection of graphite epoxy composites has been made by Fassbender and Hagemaier [176]. This study demonstrated that radiographic films exhibited higher subject contrast at 25 kV than at... [Pg.831]

Zalameda. J. N.. and Winfree, W. P. (1991). Thermal imaging of graphite,epoxy composite samples with fabricated defects. Review of Progress in QNDE. Plenum Press. Vol. lOA. pp. [Pg.836]

Awerbuch J, Hahn HT. Off-axis fatigue of graphite/epoxy composites. In Fatigue of fibrous composite materials. ASTM STP 723 1981. pp. 243—73. [Pg.189]

R Kosuri and Y Weitsman, Sorption process and immersed-fatigue response of graphite/epoxy composites in sea-water , Proc. ICCM-IO, Whistler, BC, Canada. Cambridge, UK, Woodhead, 1995, Volume 6, pp 177-184. [Pg.67]

M L Karasek, L H Strait, M F Amateau and J P Runt, Effect of temperature and moisture on the impact behaviour of graphite/epoxy composites. Part I impact energy absorption , J Compos Technol Res 1995 17(1) 3-10. [Pg.263]

T S Grant and W L Bradley, In-situ observations in SEM of degradation of graphite/epoxy composite materials due to seawater immersion , / Compos Mater 1995 29(7) 852-867. [Pg.264]

Modern aircraft are constructed from a variety of materials, with aluminium and graphite epoxies now being dominant. The F/A18 incorporates significant quantities of graphite/epoxy composite materials which, whilst... [Pg.323]

N R Adsit and J P Waszczak, Effect of near-visual damage on the properties of graphite/epoxy . Composite Materials Testing and Design, ASTM STP 674,1979, pp 101-117. [Pg.333]

SMS Madhukar and L T Drzal, Effect of fiber-matrix adhesion on the longitudinal compressive properties of graphite/epoxy composites . Proceedings Fifth Technical Conference American Society for Composites, 1990, pp 849-858. [Pg.347]

M S Madhukar and L T Drzal, Fiber-matrix adhesion and its effect on composite mechanicai properties. I. In-plane and interlaminar shear behavior of graphite/ epoxy composites , J Compos Mater 1991 25 932-957. [Pg.347]

Shu Shu, W.-Y., Lin, K.-F. The effects of additives on curing properties, resin contents, and mechanical properties of graphite/epoxy composites. Polym. Compos 13 (1992) 213-222. [Pg.538]

GrifEs, C.A., Masumra, R.A., and Chang, C.I. (1981) Thermal response of graphite epoxy composite subjected to rapid heating. J. Compos. Mater., 15, 427-442. [Pg.131]

See other pages where Of graphite-epoxy composite is mentioned: [Pg.110]    [Pg.224]    [Pg.10]    [Pg.260]    [Pg.274]    [Pg.274]    [Pg.161]    [Pg.110]    [Pg.228]    [Pg.131]    [Pg.132]    [Pg.824]    [Pg.437]    [Pg.99]   
See also in sourсe #XX -- [ Pg.157 , Pg.160 , Pg.161 , Pg.162 ]



SEARCH



Graphite composites

Graphite composition

Graphite-epoxy

Graphite-epoxy composites

Of graphite

© 2024 chempedia.info