Nitrobenzenes nitration

J. A. Hetherington and Masson [84], basing their views on the studies of benzene nitration kinetics, stated that the reaction of nitrobenzene nitrated with a mixture of HN03, H2S04 and H20 would stop before all the nitric acid was used if the amount of sulphuric acid in the mixture was insufficient to form the H2S04.H20... 

FIGURE 14.74 Nitrobenzene nitrates very slowly at 0 °C, and almost entirely in the meta position. 

Further nitration gives w-dinilrobenzene sulphonation gives w-nitrobenzene sulphonic acid. Reduction gives first azoxybenzene, then azobenzene and aniline depending upon the conditions. Used in the dyestufTs industry as such or as aniline. 

Nitration. Mix together in a boiling-tube 2 ml. of cone. HNO, and 2 ml. of oonc. H1SO4. Add 1 ml. of nitrobenzene with shaking and then heat the mixture over a small flame with constant shaking in a fume-cupboard for a... 

Nitrations are usually carried out at comparatively low temperatures at higher temperatures there may be loss of material because of the oxidising action of the nitric acid. For substances which do not nitrate readily with a mixture of concentrated nitric and sulphuric acids ( mixed acid ), the intensity of the reaction may be increased inler alia by the use of fuming sulphuric acid (containing up to 60 per cent, of sulphur trioxide) or by fuming nitric acid. Thus nitrobenzene is converted by a mixture of fuming nitric acid and concentrated sulphuric acid into about 90 per cent, of wi-dinitrobenzene and small amounts of the o- and p-isomers the latter are eliminated in the process of recrystallisation ... 

Nitration of bromobenzene with mixed acid yields largely p-bromo nitrobenzene accompanied by a little of the o-isomeride ... 

A brief account of aromatic substitution may be usefully given here as it will assist the student in predicting the orientation of disubstituted benzene derivatives produced in the different substitution reactions. For the nitration of nitrobenzene the substance must be heated with a mixture of fuming nitric acid and concentrated sulphuric acid the product is largely ni-dinitrobenzene (about 90 per cent.), accompanied by a little o-dinitrobenzene (about 5 per cent.) which is eliminated in the recrystallisation process. On the other hand phenol can be easily nitrated with dilute nitric acid to yield a mixture of ortho and para nitrophenols. It may be said, therefore, that orientation is meta with the... 

The first nitration to be reported was that of beri2ene itself. Mitscher-lich in 1834 prepared nitrobenzene by treating benzene with fuming nitric acid. Not long afterwards the important method of effecting nitration with a mixture of nitric and sulphuric acids ( mixed acid ) was introduced, evidently in a patent by Mansfield the poor quality of early nitric acid was probably the reason why the method was developed. Since these beginnings, nitration has been the subject of continuous study. 

Our knowledge of the mechanism of the reaction in this medium comes from an investigation of the nitration of nitrobenzene, /)-chloronitro-benzene and i-nitroanthraquinone. These compounds underwent reaction according to the following rate law ... 

Nitration in aqueous solutions of nitric acid Added water retards nitration in concentrated nitric acid without disturbing the kinetic order of the reaction. The rate of nitration of nitrobenzene was depressed sixfold by the addition of 5 % of water, (c. 3 2 mol 1 ), but because of the complexity of the equilibria involving water, which exist in these media, no simple relationship could be found between the concentration of water and its effect on the rate. 

A simple kinetic order for the nitration of aromatic compounds was first established by Martinsen for nitration in sulphuric acid (Martin-sen also first observed the occurrence of a maximum in the rate of nitration, occurrii for nitration in sulphuric acid of 89-90 % concentration). The rate of nitration of nitrobenzene was found to obey a second-order rate law, first order in the concentration of the aromatic and of nitric acid. The same law certainly holds (and in many cases was explicitly demonstrated) for the compounds listed in table 2.3. 

If it be assumed that the ionising characteristics of nitric acid are similar to those of the organic indicators used to define the scales of acidity, then a correspondence between the acidity-dependence of nitration and would suggest the involvement of the nitronium ion, whereas a correspondence with Hq would support the h)rpothesis that the nitric acidium ion were active. The analogies with and Hg are expressed in the first and last pairs of the followii equations respectively. The symbol AQ represents anthraquinone, the indicator originally used in this way for comparison with the acidity dependence of the rate of nitration of nitrobenzene ... 

There is increasing evidence that the ionisation of the organic indicators of the same type, and previously thought to behave similarly, depends to some degree on their specific structures, thereby diminishing the generality of the derived scales of acidity. In the present case, the assumption that nitric acid behaves like organic indicators must be open to doubt. However, the and /fp scales are so different, and the correspondence of the acidity-dependence of nitration with so much better than with Hg, that the effectiveness of the nitronium ion is firmly established. The relationship between rates of nitration and was subsequently shown to hold up to about 82 % sulphuric acid for nitrobenzene, />-chloronitrobenzene, phenyltrimethylammonium ion, and p-tolyltrimethylammonium ion, and for various other compounds. ... 

Solutions of dinitrogen pentoxide have been used in preparative nitrations.Benzene, bromobenzene, and toluene were nitrated rapidly in solutions of the pentoxide in carbon tetrachloride nitrobenzene could not be nitrated under similar conditions, but reacted violently with solid dinitrogen pentoxide. 

Relative rate meaning, here, simply the ratio of nitro-alkylbenzene to nitrobenzene, multiplied by the initial ratio of alkylbenzene to benzene. This is not precisely the same as the ratio of rate constants for nitration. ... 

It has already been noted that, as well as alkylbenzenes, a wide range of other aromatic compounds has been nitrated with nitronium salts. In particular the case of nitrobenzene has been examined kinetically. Results are collected in table 4.4. The reaction was kinetically of the first order in the concentration of the aromatic and of the nitronium salt. There is agreement between the results for those cases in which the solvent induces the ionization of nitric acid to nitronium ion, and the corresponding results for solutions of preformed nitronium salts in the same solvent. 

In nitration with nitronium salts in sulpholan, nitrobenzene was substituted in the following proportions 8% ortho, 90% meta and 2% paraf under the same conditions benzylidyne trifluoride yielded 8%, 88% and 4% of 0-, m- and p-nitro compound respectively Both of these aromatic compounds were stated to be io -10 times less reactive than benzene. "... 

TABLE 4.4 The kinetics of nitration of nitrobenzene in various medial... 

The argument for the S 2 process, when the transition from acetic acid as solvent to nitric acid as solvent is considered, is less direct, for because of the experimental need to use less reactive compounds, zeroth-order nitration has not been observed in nitric acid. It can be estimated, however, that a substance such as nitrobenzene would react about 10 faster in first-order nitration in nitric acid than in a solution of nitric acid (7 mol 1 ) in acetic acid. Such a large increase is understandable in terms of the S z mechanism, but not otherwise. 

A silicon atom might be expected to release electrons inductively, but because of empty 7-orbitals shows the overall character ( + 7 —717). Nitration of trimethylsilylbenzene with nitric acid in acetic anhydride at —10 to o °C gives 25-5,39-8,30-2 and 6-8 %, respectively, of 0-, m-, and /)-nitro-trimethylsilylbenzene and nitrobenzene, with a rate of reaction relative to that of benzene of about 1-5. The figures give no indication of an important conjugative effect. 

Table 9.7 contains recent data on the nitration of polychlorobenzenes in sulphuric acid. The data continue the development seen with the diehlorobenzenes. The introduetion of more substituents into these deactivated systems has a smaller effect than predicted. Whereas the -position in ehlorobenzene is four times less reactive than a position in benzene, the remaining position in pentachlorobenzene is about four times more reactive than a position in 1,3,4,5-tetraehlorobenzene. The chloro substituent thus activates nitration, a circumstance recalling the faet that o-chloronitrobenzene is more reactive than nitrobenzene. As can be seen from table 9.7, the additivity prineiple does not work very well with these compounds, underestimating the rate of reaction of pentachlorobenzene by a factor of nearly 250, though the failure is not so marked in the other cases, especially viewed in the circumstance of the wide range of reactivities covered. 

The nitration of some substituted nitrobenzenes has been studied in connection with the high o -ratios produced by [ —/ — A/] substituents. Thus nitration in sulphuric acid of 2,5-dialkyl-nitrobenzenes produces the isomer distributions shown below. As has been seen ( 9.1.3), one explanation for the occurrence of high o -ratios with [-/—A/] substituents is that the latter specifically deactivate para positions. In the... 

Ridd - has reinterpreted the results concerning the anticatalysis of the first-order nitration of nitrobenzene in pure and in partly aqueous nitric acid brought about by the addition of dinitrogen tetroxide. In these media this solute is almost fully ionised to nitrosonium ion and nitrate ion. The latter is responsible for the anticatalysis, because it reduces the concentration of nitronium ion formed in the following equilibrium ... 

Nitration Warming benzene with a mixture of nitric acid and sulfuric acid gives nitrobenzene A nitro group (—NO2) replaces one of the ring hydrogens... 

Mixtures of HNO, H2SO4, and SO also result in high concentrations of NO/, and toluene can be readily nitrated at —40 to — 10°C as a result (6). At these low temperatures, the formation of the meta-isomer of mononitrotoluene (MNT) is greatiy reduced. Such a reduction is highly desired in the production both of dinitrotoluenes (DNTs) employed to produce intermediates for polyurethane production and of trinitrotoluene (TNT), which is a high explosive. > -MNT results in the production of undesired DNT and TNT isomers (see Nitrobenzene and nitrotoluenes). 

Organic Reactions. Nitric acid is used extensively ia iadustry to nitrate aHphatic and aromatic compounds (21). In many iastances nitration requires the use of sulfuric acid as a dehydrating agent or catalyst the extent of nitration achieved depends on the concentration of nitric and sulfuric acids used. This is of iadustrial importance ia the manufacture of nitrobenzene and dinitrotoluene, which are iatermediates ia the manufacture of polyurethanes. Trinitrotoluene (TNT) is an explosive. Various isomers of mononitrotoluene are used to make optical brighteners, herbicides (qv), and iasecticides. Such nitrations are generally attributed to the presence of the nitronium ion, NO2, the concentration of which iacreases with acid strength (see Nitration). 

Nitrobenzene was first synthesized in 1834 by treating benzene with fuming nitric acid (1), and was first produced commercially in England in 1856 (2). The relative ease of aromatic nitration has contributed significantly to the large and varied industrial appHcations of nitrobenzene, other aromatic nitro compounds, and their derivatives. 

---