Multi photon-ionization Spectroscopy

The temi action spectroscopy refers to those teclmiques that do not directly measure die absorption, but rather the consequence of photoabsorption. That is, there is some measurable change associated with the absorption process. There are several well known examples, such as photoionization spectroscopy [47], multi-photon ionization spectroscopy [48], photoacoustic spectroscopy [49], photoelectron spectroscopy [, 51], vibrational predissociation spectroscopy [ ] and optothemial spectroscopy [53, M]. These teclmiques have all been applied to vibrational spectroscopy, but only the last one will be discussed here. 

REMPI resonance-enhanced multi photon ionization spectroscopy... 

As we have seen, collisions are important for the signal generation in LEI. In low-pressure experiments photoionization instead is the principal origin of the signal. The term Resonance Ionization Spectroscopy (RIS) is then frequently used. Several examples of opto-galvanic detection schemes for different atoms are shown in Fig.9.11. If multi-photon excitation of the atoms to be studied is used the technique is referred to as REMPI (REsonance Multi-Photon Ionization) spectroscopy. The selectivity of RIS and REMPI can be further enhanced by using a mass spectrometer to ana-... 

Tunable laser spectroscopic techniques such as laser-induced fluorescence (LIF) or resonantly enhanced multi-photon ionization (REMPI) are well-established mature fields in gas-phase spectroscopy and dynamics, and their application to gas-surface dynamics parallels their use elsewhere. The advantage of these techniques is that they can provide exceedingly sensitive detection, perhaps more so than mass spectrometers. In addition, they are detectors of individual quantum states and hence can measure nascent internal state population distributions produced via the gas-surface dynamics. The disadvantage of these techniques is that they are not completely general. Only some interesting molecules have spectroscopy amenable to be detected sensitively in this fashion, e.g., H2, N2, NO, CO, etc. Other interesting molecules, e.g. 02, CH4, etc., do not have suitable spectroscopy. However, when applicable, the laser spectroscopic techniques are very powerful. 

Two-color, Resonance Enhanced Multi-Photon Ionization (REMPI) spectroscopy is similar to OODR, differing only in that the... 

Conventional photoelectron spectroscopy uses a rare-gas discharge lamp to produce radiation at the wavelength of the He 2p <— Is atomic transition (hu = 21.218 eV). Synchrotron radiation is now widely used for PES because its photon energy is widely tunable yet monochromatic. The initial state, in the first PES experiments, has been the molecular ground state but now, by exploiting Resonance Enhanced Multi-Photon Ionization (REMPI) excitar tion/detection schemes (see Section 1.2.2.3), any excited state of the molecule can be used as the initial state for PES (for a review, see Pratt, 1995). 

A technique which combines the high sensitivity of resonant laser ionization methods with the advantages of nonlinear coherent Raman spectroscopy is called IDSRS (ionization detected stimulated Raman spectroscopy). The excitation process, illustrated in Figure 5, can be briefly described as a two-step photoexcitation process followed by ion/electron detection. In the first step two intense narrow-band lasers (ct L, 0) ) are used to vibrationally excite the molecule via the stimulated Raman process. The excited molecules are then selectively ionized in a second step via a two- or multiphoton process. If there are intermediate resonant states involved (as state c in Figure 5), the method is called REMPI (resonance enhanced multi-photon ionization)-detected stimulated Raman spectroscopy. The technique allows an increase in sensitivity of over three orders of magnitude because ions can be detected with much higher sensitivity than photons. 

Besides various detection mechanisms (e.g. stimulated emission or ionization), there exist moreover numerous possible detection schemes. For example, we may either directly detect the emitted polarization (oc PP, so-called homodyne detection), thus measuring the decay of the electronic coherence via the photon-echo effect, or we may employ a heterodyne detection scheme (oc EP ), thus monitoring the time evolution of the electronic populations In the ground and excited electronic states via resonance Raman and stimulated emission processes. Furthermore, one may use polarization-sensitive detection techniques (transient birefringence and dichroism spectroscopy ), employ frequency-integrated (see, e.g. Ref. 53) or dispersed (see, e.g. Ref. 54) detection of the emission, and use laser fields with definite phase relation. On top of that, there are modern coherent multi-pulse techniques, which combine several of the above mentioned options. For example, phase-locked heterodyne-detected four-pulse photon-echo experiments make it possible to monitor all three time evolutions inherent to the third-order polarization, namely, the electronic coherence decay induced by the pump field, the djmamics of the system occurring after the preparation by the pump, and the electronic coherence decay induced by the probe field. For a theoretical survey of the various spectroscopic detection schemes, see Ref. 10. 

---