Resin Morphology

Mechanical Properties. The principal mechanical properties are Hsted in Table 1. The features of HDPE that have the strongest influence on its mechanical behavior are molecular weight, MWD, orientation, morphology, and the degree of branching, which determines resin crystallinity and density. 

Two modifications of the duidized-bed reactor technology have been developed. In the first, two gas-phase duidized-bed reactors coimected to one another have been used by Mobil Chemical Co. and Union Carbide to manufacture HDPE resins with broad MWD (74,75). In the second development, a combination of two different reactor types, a small slurry loop reactor followed by one or two gas-phase duidized-bed reactors (Sphetilene process), was used by Montedision to accommodate a Ziegler catalyst with a special particle morphology (76,77). This catalyst is able to produce PE resins in the form of dense spheres with a diameter of up to 4—5 mm such resins are ready for shipping without pelletization. 

Studies of the particle—epoxy interface and particle composition have been helphil in understanding the mbber-particle formation in epoxy resins (306). Based on extensive dynamic mechanical studies of epoxy resin cure, a mechanism was proposed for the development of a heterophase morphology in mbber-modifted epoxy resins (307). Other functionalized mbbers, such as amine-terminated butadiene—acrylonitrile copolymers (308) and -butyl acrylate—acryhc acid copolymers (309), have been used for toughening epoxy resins. 

Mechanical properties of mbber-modifted epoxy resins depend on the extent of mbber-phase separation and on the morphological features of the mbber phase. Dissolved mbber causes plastic deformation and necking at low strains, but does not result in impact toughening. The presence of mbber particles is a necessary but not sufficient condition for achieving impact resistance. Optimum properties are obtained with materials comprising both dissolved and phase-separated mbber (305). 

Polymers with differing morphologies respond differentiy to fillers (qv) and reinforcements. In crystalline resins, heat distortion temperature (HDT) increases as the aspect ratio and amount of filler and reinforcement are increased. In fact, glass reinforcement can result in the HDT approaching the melting point. Amorphous polymers are much less affected. Addition of fillers, however, intermpts amorphous polymer molecules physical interactions, and certain properties, such as impact strength, are reduced. 

Since the last edition several new materials have been aimounced. Many of these are based on metallocene catalyst technology. Besides the more obvious materials such as metallocene-catalysed polyethylene and polypropylene these also include syndiotactic polystyrenes, ethylene-styrene copolymers and cycloolefin polymers. Developments also continue with condensation polymers with several new polyester-type materials of interest for bottle-blowing and/or degradable plastics. New phenolic-type resins have also been announced. As with previous editions I have tried to explain the properties of these new materials in terms of their structure and morphology involving the principles laid down in the earlier chapters. 

Apicella,A., Nicolais, L. and de Cataldis, C. Characterization of the Morphological Fine Structure of Commercial Thermosetting Resins Through Hygrothermal Experiments. Vol. 66, pp. 189-208. 

Characterization of the Morphological Fine Structure of Commercial Thermosetting Resins Through Hygrothermal Experiments... 

W. A. Romanchick, J. E. Sohn, and J. F. Geibel Synthesis, Morphology, and Thermal Stability of Elastomer-Modified Epoxy Resin, in ACS Symposium Series 221 — Epoxy Resin Chemistry II, R. S. Bauer (ed.), American Chemical Society, Washington DC, 1982, pp. 85-118. 

---