Molybdenum arsenates Complex

Phosphate. Phosphoms occurs in water primarily as a result of natural weathering, municipal sewage, and agricultural mnoff The most common form in water is the phosphate ion. A sample containing phosphate can react with ammonium molybdate to form molybdophosphoric acid (H2P(Mo202q)4). This compound is reduced with stannous chloride in sulfuric acid to form a colored molybdenum-blue complex, which can be measured colorimetrically. SiUca and arsenic are the chief interferences. 

The following procedure has been recommended by the Analytical Methods Committee of the Society for Analytical Chemistry for the determination of small amounts of arsenic in organic matter.20 Organic matter is destroyed by wet oxidation, and the arsenic, after extraction with diethylammonium diethyldithiocarbamate in chloroform, is converted into the arsenomolybdate complex the latter is reduced by means of hydrazinium sulphate to a molybdenum blue complex and determined spectrophotometrically at 840 nm and referred to a calibration graph in the usual manner. 

Molybdenum and Nitrogen, Phosphorus, and Arsenic—Heteropoly-compounds— Carbides— Molybdenum Canjonyl—Complex Cyanogen Derivatives—Compounds with Sdioon and Boron. 

Gravimetric methods and chemical methods, such as colorimetric measurements based on the arsenic-molybdenum blue complex (1,2,3) and arsine generation in combination with silver diethyldithiocarbamate (4, 5, 6,7), have been used to measure arsenic in aqueous media. Various instrumental methods such as differential pulse polarography (8), heated vaporization atomic absorption (9), arsine generation in combination with atomic absorption spectroscopy (10, 11, 12) or non-dispersive atomic fluorescence spectroscopy (13), and optical emission spectroscopy (14) can be used to determine arsenic in aqueous solutions. 

Early catalysts for acrolein synthesis were based on cuprous oxide and other heavy metal oxides deposited on inert siHca or alumina supports (39). Later, catalysts more selective for the oxidation of propylene to acrolein and acrolein to acryHc acid were prepared from bismuth, cobalt, kon, nickel, tin salts, and molybdic, molybdic phosphoric, and molybdic siHcic acids. Preferred second-stage catalysts generally are complex oxides containing molybdenum and vanadium. Other components, such as tungsten, copper, tellurium, and arsenic oxides, have been incorporated to increase low temperature activity and productivity (39,45,46). 

Although trialkyl- and triarylbismuthines are much weaker donors than the corresponding phosphoms, arsenic, and antimony compounds, they have nevertheless been employed to a considerable extent as ligands in transition metal complexes. The metals coordinated to the bismuth in these complexes include chromium (72—77), cobalt (78,79), iridium (80), iron (77,81,82), manganese (83,84), molybdenum (72,75—77,85—89), nickel (75,79,90,91), niobium (92), rhodium (93,94), silver (95—97), tungsten (72,75—77,87,89), uranium (98), and vanadium (99). The coordination compounds formed from tertiary bismuthines are less stable than those formed from tertiary phosphines, arsines, or stibines. 

Liquid-Phase Epoxidation with Hydroperoxides. Molybdenum, vanadium, and tungsten have been proposed as Hquid-phase catalysts for the oxidation of the ethylene by hydroperoxides to ethylene oxide (205). tert- uty hydroperoxide is the preferred oxidant. The process is similar to the arsenic-catalyzed route, and iacludes the use of organometaUic complexes. 

The solution should be free from the following, which either interfere or lead to an unsatisfactory deposit silver, mercury, bismuth, selenium, tellurium, arsenic, antimony, tin, molybdenum, gold and the platinum metals, thiocyanate, chloride, oxidising agents such as oxides of nitrogen, or excessive amounts of iron(III), nitrate or nitric acid. Chloride ion is avoided because Cu( I) is stabilised as a chloro-complex and remains in solution to be re-oxidised at the anode unless hydrazinium chloride is added as depolariser. 

Molybdenum blue method. When arsenic, as arsenate, is treated with ammonium molybdate solution and the resulting heteropolymolybdoarsenate (arseno-molybdate) is reduced with hydrazinium sulphate or with tin(II) chloride, a blue soluble complex molybdenum blue is formed. The constitution is uncertain, but it is evident that the molybdenum is present in a lower oxidation state. The stable blue colour has a maximum absorption at about 840 nm and shows no appreciable change in 24 hours. Various techniques for carrying out the determination are available, but only one can be given here. Phosphate reacts in the same manner as arsenate (and with about the same sensitivity) and must be absent. 

Sulphuric acid is not recommended, because sulphate ions have a certain tendency to form complexes with iron(III) ions. Silver, copper, nickel, cobalt, titanium, uranium, molybdenum, mercury (>lgL-1), zinc, cadmium, and bismuth interfere. Mercury(I) and tin(II) salts, if present, should be converted into the mercury(II) and tin(IV) salts, otherwise the colour is destroyed. Phosphates, arsenates, fluorides, oxalates, and tartrates interfere, since they form fairly stable complexes with iron(III) ions the influence of phosphates and arsenates is reduced by the presence of a comparatively high concentration of acid. 

The ability of metal ions to form complexes with formazans is utilized to determine these ions either directly (for low valent reducing ions) or indirectly in the presence of a reducing agent. Among others, molybdenum(VI) and vanadium(V) have been determined using this method.442,443 Indirect methods have been reported for the analyses of substances that do not reduce tetrazolium salts. Examples include arsenic in nickel ores436 and traces of selenium.437 A method for the extraction and analysis of a number of metal ternary ion association complexes has been described.444 - 448... 

Johnson and Pilson [229] have described a spectrophotometric molybdenum blue method for the determination of phosphate, arsenate, and arsenite in estuary water and sea water. A reducing reagent is used to lower the oxidation state of any arsenic present to +3, which eliminates any absorbance caused by molybdoarsenate, since arsenite will not form the molybdenum complex. This results in an absorbance value for phosphate only. 

Fujiwara et al. [94] found that, when present as a heteropolyacid complex, molybdenum(VI), germanium(IV), and silicon(IV) produced CL emission from the oxidation of luminol, and similar CL oxidation of luminol was observed for arsenic(V) and phosphorus(V) but with the addition of the metavanadate ion to the acid solution of molybdate. A hyphenated method was therefore proposed for the sensitive determination of arsenate, germanate, phosphate, and silicate, after separation by ion chromatography. The minimum detectable concentrations of arsenic(V), germanium(IV), phosphate, and silicon(IV) were 10, 50, 1, and 10... 

Devoto 115)has described an indirect procedure for the determination of 0.1 ppm arsenic in urine. The arsenomolybdic acid complex is formed and extracted from 1 ml of urine at pH 2 into 10 ml of cyclohexanone. The molybdenum in the complex is then measured. Before extracting the arsenic, phosphate in the urine is separated by extracting the phosphomolybdic acid complex at pH 1 into isobutyl acetate. The direct determination of arsenic in biological material and blood and urine is best done using a nitrous oxide-acetylene flame 116>. The background absorption by this flame is low at 1937 A, and interferences are minimized due to the high temperature of the flame. 

A second example of a membrane-bound arsenate reductase was isolated from Sulfurospirillum barnesii and was determined to be a aiPiyi-heterotrimic enzyme complex (Newman et al. 1998). The enzyme has a composite molecular mass of 100kDa, and a-, P-, and y-subunits have masses of 65, 31, and 22, respectively. This enzyme couples the reduction of As(V) to As(III) by oxidation of methyl viologen, with an apparent Kra of 0.2 mM. Preliminary compositional analysis suggests that iron-sulfur and molybdenum prosthetic groups are present. Associated with the membrane of S. barnesii is a h-type cytochrome, and the arsenate reductase is proposed to be linked to the electron-transport system of the plasma membrane. 

Molecular recognition, calmodulin, 46 447 Mollusks, arsenic in, 44 150, 167, 168, 170 Molten salts electrolysis, 31 11 oxygen activation, 44 328-329 Molybdate ions, tetrahedral, 39 194-195 Molybdenite, 17 108 Molybdenum, 45 1 acetylene complexes of, 4 104 alkoxides... 

---