Mobile phase nitrogen

Mobile phase — nitrogen, temperature — 23°C, split ratio 1 1000. 

For MS detection, special columns with low bleeding silicon phases should be used to diminish background noise. We normally use DB5-MS columns, consisting of 5% phenylmethylsilicon for better separation of nonpolar compounds. As carrier gas (mobile phase) nitrogen, or better helium, is used, and inlet gas pressure is set to 50 kPa. 

The column is swept continuously by a carrier gas such as helium, hydrogen, nitrogen or argon. The sample is injected into the head of the column where it is vaporized and picked up by the carrier gas. In packed columns, the injected volume is on the order of a microliter, whereas in a capillary column a flow divider (split) is installed at the head of the column and only a tiny fraction of the volume injected, about one per cent, is carried into the column. The different components migrate through the length of the column by a continuous succession of equilibria between the stationary and mobile phases. The components are held up by their attraction for the stationary phase and their vaporization temperatures. 

As described above, the mobile phase carrying mixture components along a gas chromatographic column is a gas, usually nitrogen or helium. This gas flows at or near atmospheric pressure at a rate generally about 0,5 to 3.0 ml/min and evenmally flows out of the end of the capillary column into the ion source of the mass spectrometer. The ion sources in GC/MS systems normally operate at about 10 mbar for electron ionization to about 10 mbar for chemical ionization. This large pressure... 

An excellent example of PLC applications in the indirect coupling version is provided by the works of Miwa et al. [12]. These researchers separated eight phospholipid standards and platelet phospholipids from the other lipids on a silica gel plate. The mobile phase was composed of methylacetate-propanol-chloro-form-methanol-0.2% (w/v) potassium chloride (25 30 20 10 10, v/v). After detection with iodine vapor (Figure 9.2), each phospholipid class was scraped off and extracted with 5 ml of methanol. The solvent was removed under a stream of nitrogen, and the fatty acids of each phospholipid class were analyzed (as their hydrazides) by HPLC. The aim of this study was to establish a standardized... 

The researeh on dehydroepiandrosterone (DHEA) is limited beeause of the laek of radiolabeled metabolites. Robinzon et al. [126] showed that, using pig liver mierosomes, the radiolabeled metabolites of DHEA can be prepared in stable, pure form for bioehemical smdies. They utilized pig liver microsomal (PLM) fractions to prepare pH]-labeled 7a-hydroxy-DHEA (7a-OH-DHEA), 7[3-hydroxy-DHEA (7P-OH-DHEA), and 7-oxo-DHEA substrates from 50 pM [1,2,6,7-3H]DHEA. The metabolites were separated by silica gel PLC plates using ethyl aeetate-hexane-gla-eial aeetic acid (18 8 , v/v) as the mobile phase, extracted with ethyl aeetate, and dried under a stream of nitrogen. The purity of markers was determined with the use of TLC and GC/MS. 

Supercritical fluid chromatography (SEC) was first reported in 1962, and applications of the technique rapidly increased following the introduction of commercially available instrumentation in the early 1980s due to the ability to determine thermally labile compounds using detection systems more commonly employed with GC. However, few applications of SEC have been published with regard to the determination of triazines. Recently, a chemiluminescence nitrogen detector was used with packed-column SEC and a methanol-modified CO2 mobile phase for the determination of atrazine, simazine, and propazine. Pressure and mobile phase gradients were used to demonstrate the efficacy of fhe fechnique. 

The withdrawn hquid-phase samples were analyzed with an HPLC (Biorad Aminex HPX-87C carbohydrate coluttm. 1.2 ttiM CaS04 in deionized water was used as a mobile phase, since calcium ions improve the resolution of lactobionic acid [17]). Dissolved metals were analysed by Direct Current Plasma (DCP). The catalysts were characterized by (nitrogen adsorption BET, XPS surface analysis, SEM-EDXA, hydrogen TPD and particle size analysis). 

Also, subcritical (hot/liquid) water can be used as a mobile phase for packed-column RPLC with solute detection by means of FID [942]. In the multidimensional on-line PHWE-LC-GC-FTD/MS scheme, the solid sample is extracted with hot pressurised water (without the need for sample pretreatment), and the analytes are trapped in a solid-phase trap [943]. The trap is eluted with a nitrogen flow, and the analytes are carried on to a LC column for cleanup, and separated on a GC column using the on-column interface. The closed PHWE-LC-GC system is suitable for many kinds of sample matrices and analytes. The main benefit of the system is that the concentration step is highly efficient, so that the sensitivity is about 800 times better than that obtained with traditional methods [944]. Because small sample amounts are required (10 mg), special attention has to be paid to the homogeneity of the sample. The system is... 

Dean et al. [93] used a high performance liquid chromatographic method for the simultaneous determination of primaquine and carboxyprimaquine in plasma with electrochemical detection. After the addition of the internal standard, plasma was deproteinized by the addition of acetonitrile. Nitrogen-dried supernatants, resuspended in mobile phase were analyzed on a C8 reversed-phase column. Limits of detection for primaquine and carboxyprimaquine were 2 and 5 ng/mL with quantitation limits of 5 and 20 ng/mL, respectively. The assay sensitivity and specificity are sufficient to permit quantitation of the drug in plasma for pharmacokinetics following low dose (30 mg, base) oral administration of primaquine, typically used in the treatment of malaria and P. carinii pneumonia. 

---