Mixed powder flow rate

Figure 8. Pulse adsorptions following sequential injections of 20 pi of 0.01 molar aqueous solution of K2PtCl6 (0.2 pmol) into water percolating throught 25.8 mg of graphitised carbon black mixed with PTFE powder. Flow rate of water - 3 mlh, temperature - 20°C.

PFPE, AI2O3, and X-IP were 500 mg, 200 mg, and 100 mg, respectively. The materials in Samples 2 to 4 were sufficiently mixed to ensure that the liquid PFPE and X-IP completely wet the alumina powders. These specimens were put in a closed space hlled with inert nitrogen. The flow rate of the nitrogen gas was kept at 20 milliliters per minute. The environmental temperature of the system was set at 220 ° C and the duration time was 250 minutes per sample for each individual operation procedure. PFPE used in the experiment was Z-dol and the alumina was in ultra-fine powders with chemical analytic grade purity. 

Fig. 2.48 DSC traces of Tego Magnan MgH powder doped with m- and n-Ni, and (a) mixed for 1 h without milling (no steel balls) and (b) mixed for 1 h with Tego Magnan MgH which was premilled for 20 h (heating rate 4°C/min argon flow rate 25 ml/min)...

Figure 4.7 is a schematic diagram of a well-mixed open-circuit grinding mill. Here a powder is fed to a grinding mill with a volume V. The outlet flow rate Q is equal to the inlet flow rate Qp at stea state. The mean retention time, t, is the ratio of the mill volume to the flow rate (i.e., T = V/Q). We have two options to attack this problem. The first is to directly use the population balance ... 

Other characteristics of the mixed powder such as particle size, flavor, flow rate, and bulk density before and after tapping have to be verified. 

---