Microfiber glass fleece separator

For the separation of such batteries, gel construction and microfiber glass fleece separators again compete because of the deep discharge cycles, the gel construction with its lower tendency to acid stratification and to penetration shorts has advantages for the required power peaks, microfiber glass fleece construction would be the preferred solution. The work on reduction of premature capacity loss with lead-calcium alloys has shown that considerable pressure (e.g., 1 bar) on the positive electrode is able to achieve a significantly better cycle life [31-36], Pressure on the electrodes produces counter pressure on the separators, which is not unproblematic for both separation systems. New separator developments have been presented with... 

AMER-SIL s. a, [861 has recently introduced a microfiber glass fleece separator ( AMER-GLASS ). 

Microfiber glass fleece mats are typically produced from a blend of 20 - 30 percent glass microfibers <1 //m in diameter, with the balance of the glass fibers thicker (3 - 10 //m) and longer (cf. Fig. 1), on a specialized paper machine (Fou-drinier), since this is the only way of achieving the desired tensile strength without binder. The material is supplied in roll form, even though it is normally not processed into pockets, which are not required due to the absence of free electrolyte. The classification here as a leaf separator should be seen in this sense. 

Because of the increased shedding with these alloys, pure leaf separation is hardly suitable. Separations with supporting glass mats or fleeces as well as microfiber glass mats provide technical advantages, but are expensive and can be justified only in special cases. Also under these conditions of use the microporous polyethylene pocket offers the preferred solution [40]. Lower electrical properties at higher temperatures, especially decreased cold crank duration, are battery-related the choice of suitable alloys and expanders gains increased importance. 

Because of the increased shedding with these alloys, pure leaf separation is hardly suitable. Separations with supporting glass mats or fleeces as well as microfiber glass mats provide technical advantages, but are expensive and can be justified only... 

---