Methyl methacrylate initiator influence

Gosh and Gosh [105] studied photoinitiated polymerization of methyl methacrylate initiated by the BP-TV,A-dimethylaniline couple, and Clarke and Shanks [106] tested the influence of a variety of amines on benzophenone-initiated polymerization. That amino radicals resulted during the initiation the polymerization by benzophenone-tertiary aromatic amines was shown by Li through the use of ESR and spin-trapping methods [107]. It was shown that the rate of photoinitiated polymerization depends on the structure of the amine. More recently [108] benzophenone-tertiary aromatic amines were studied as initiators of the free-radical polymerization of polyol acrylates. Illustrative kinetic curves recorded during photoinitiated polymerization of TMPTA are shown in Figure 23. 

Naito et al. have examined the photopolymerization of methyl methacrylate initiated by poly(3-methyl-3-buten-2-one). Again a-cleavage was found to be the dominant initiating step. The photoinitiated polymerization of methyl methacrylate by benzophenone derivatives has been found to depend upon the nature of the substituent, which in turn influences the activity of the semipinacol radical. ... 

A critical survey of the literature on free radical polymerizations in the presence of phase transfer agents indicates that the majority of these reactions are initiated by transfer of an active species (monomer or initiator) from one phase to another, although the exact details of this phase transfer may be influenced by the nature of the phase transfer catalyst and reaction medium. Initial kinetic studies of the solution polymerization of methyl methacrylate utilizing solid potassium persulfate and Aliquat 336 yield the experimental rate law ... 

The stereoselective polymerization of various acrylates and methacrylates has been studied using initiators such as atkyllithium [Bywater, 1989 Pasquon et al., 1989 Quirk, 1995, 2002]. Table 8-12 illustrates the effects of counterion, solvent, and temperature on the stereochemistry of the anionic polymerization of methyl methacrylate (MMA). In polar solvents (pyridine and THF versus toluene), the counterion is removed from the vicinity of the propagating center and does not exert an influence on entry of the next monomer unit. The tendency is toward syndiotactic placement via chain end control. The extent of syndiotacticity... 

Influence of Interpolymer Properties. As stated earlier, the physical and chemical properties of interpolymers markedly influence the reaction rate after the induction period. If the monomer present yields a polymer comparable in viscosity with the initial mixture the rate of scission will not accelebrate. For example, the polymerization rate of chloroprene on mastication with natural rubber does not increase as markedly with conversion (69), see Fig. 19, as with methyl methacrylate and styrene. The reason is the chloroprene-rubber system remained elastic and softer than the original rubber. 

It seems that the method of preparation of a polymer has significant influence on its mode of degradation. Thus, a sample of poly(methyl methacrylate), prepared by a free radical reaction, suffers rapid depolymerization at about 275 "C and a second mode of initiation of chain depolymerization between 350 and 400 °C, while the sample, prepared by anionic polymerization, undergoes depolymerization as a whole above 350 °C. Ab-... 

The reactions which are induced by pairs of different degradation agencies may also be clarified by studying the influence of one on the other. For example, the decrease In the thermal stability of poly(methyl methacrylate) (PMMA), as a result of pre-irradiation, has been clearly shown to be due to photo-induced chain scission which results in chain terminal unsaturation at which subsequent thermal decomposition is readily initiated (10). 

The free radical polymerization of styrene initialized by iniferter is influenced by chemical binding of iniferter on the surface of the silica." This reaction is used for grafting the polymer onto the surface of the silica. A similar approach is used when carbon whisker is incorporated during the graft-polymerization of methyl methacrylate. Depending on how the whisker is prepared, surface conversion can be increased up to twelve times compared to a polymerization with no whisker present. The addition of graphite to the poly esterification reaction doubles the molecular weight of the polymer. ... 

In the photopolymerisation of methyl methacrylate induced by mixtures of chloroacetic acid derivatives and dimethylaniline the kinetics were found to be influenced by the degree of substitution of the chlorine atoms while the initiation occurred through a complex S. Ethyl aluminium sesquichloride has been found to induce the photocopolymerisation of 9-vinylanthracene with methyl methacrylate at -20°c while photochromic polymers have been made by reacting para-bromoazobenzene with ethylene gas O. Surface active N-cetylpyridinium bromide and chloride have been found to... 

Since the first preparation of stereoregular poly(methyl methacrylate) by Fox et al. and Miller et al. in 1958, a large number of papers have been published on the steieospecific polymerization of methyl methacrylate, while the NMR technique for the determination of microstructure developed by Bovey and Tiers and Nishioka et al. enabled us to accumulate the extensive information on this polymerization. Mostly anionic initiators have been used for the pdymerization. A review on the polymerization by lithium compounds was presented by Bywater In a recent review by Pino and Suter were discussed some of the factors which can influence the stereoregulation in the polymerization of vinyl monomers including a-substituted acrylate. A variety of magnesium and aluminum compounds can be utilized as stereospecific initiators. Besides methyl methacrylate, not only methacrylates with various ester groups, but also a-substituted acrylates, such as a-ethyl- or o-phenyl-acrylate, were also subjected to the stereospecific polymerization by anionic initiator. The stereospecificity in the copolymerization between the monomers described above is also a matter of interest. 

---