Metallurgical complex

Pig iron is obtained from the smelting of hemo-ilmenite with anthracite coal in ac- or dc-electric arc furnaces. Pig iron with typically 4.25 wL% C is commercialized under the tradename Soremetal and has been produced since 1950 by slagging at the metallurgical complex of QIT-Fer Titane in Sorel-Tracy, Qc, Canada and later in the 1970s at Richards Bay Minerals, South Africa. 

U.S. Environmental Protection Agency, 2002. Record of Decision. The Bunker HiU Mining and Metallurgical Complex Operable Unit 3. U.S. EPA, Seattle, WA, Region 10, September. 

Aeronautical construction is the main field of application of alloys of the 2000 series, as well as of copper-containing alloys of the 7000 series. The development of these metallurgically complex alloys as well as the requirements of the aeronautical industry in... 

Metals. Most metals react with aqueous HCl foUowing equation 22. The reaction rate is dependent on the concentration of the acid, oxidi2ing, reducing, or complexing agents, and corrosion inhibitors, in addition to the metallurgical characteristics of the material and the prevailing hydrodynamic conditions (see Corrosion and corrosion control). 

The scientific basis of extractive metallurgy is inorganic physical chemistry, mainly chemical thermodynamics and kinetics (see Thermodynamic properties). Metallurgical engineering reties on basic chemical engineering science, material and energy balances, and heat and mass transport. Metallurgical systems, however, are often complex. Scale-up from the bench to the commercial plant is more difficult than for other chemical processes. 

Fatigue Life. The formulas for estimating fatigue life are more complex and usually require several assumptions. Without attempting to evaluate the merit of such formulas, it is suggested here that alloy selection or metallurgical variables operating within an alloy may... 

A range of complex, elastic-plastic behaviors are observed experimentally they are perhaps the most widely encountered and most typical of shock behaviors, but they are perhaps the least understood of the materials responses. Unfortunately, nonspecialists seldom consider realistic elastic-plastic descriptions of shock processes. This section summarizes the very large body of information available in this area. The metallurgical mud is most viscous in this area. 

The technique is used predominantly for the isolation of a single chemical species prior to a determination and to a lesser extent as a method of concentrating trace quantities. The most widespread application is in the determination of metals as minor and trace constituents in a variety of inorganic and organic materials, e g. the selective extraction and spectrometric determination of metals as coloured complexes in the analysis of metallurgical and geological samples as well as for petroleum products, foodstuffs, plant and animal tissue and body fluids. 

---