Metal matrix composites classification

Classification of fiber-metal matrix composite systems ... 

Another type of classification can be done on the basis of filler or reinforcing agent used namely polymer matrix composites (PMCs), metal matrix composites (MMCs), ceramic matrix composites (CMCs), carbon-carbon matrix composites (CCCs), intermetallic... 

There are many ways to classify composites, including schemes based upon (1) materials combinations, such as metal-matrix, or glass-fiber-reinforced composites (2) bulk-form characteristics, such as laminar composites or matrix composites (3) distribution of constituents, such as continuous or discontinuous or (4) function, like structural or electrical composites. Scheme (2) is the most general, so we will utilize it here. We will see that other classification schemes will be useful in later sections of this chapter. 

Fiber-Matrix Composites. As shown in Figure 1.75, there are two main classifications of FMCs those with continuous fiber reinforcement and those with discontinuous fiber reinforcement. Continuous-flber-reinforced composites are made from fiber rovings (bundles of twisted filaments) that have been woven into two-dimensional sheets resembling a cloth fabric. These sheets can be cut and formed to a desired shape, or preform, that is then incorporated into a composite matrix, typically a thermosetting resin such as epoxy. Metallic, ceramic, and polymeric fibers of specific compositions can all be produced in continuous fashions, and the properties of the... 

This review is intended to focus on ceramic matrix composite materials. However, the creep models which exist and which will be discussed are generic in the sense that they can apply to materials with polymer, metal or ceramic matrices. Only a case-by-case distinction between linear and nonlinear behavior separates the materials into classes of response. The temperature-dependent issue of whether the fibers creep or do not creep permits further classification. Therefore, in the review of the models, it is more attractive to use a classification scheme which accords with the nature of the material response rather than one which identifies the materials per se. Thus, this review could apply to polymer, metal or ceramic matrix materials equally well. 

Fibrous reinforced composites are sometimes classified according to matrix type within this scheme are three classifications polymer-, metal-, and ceramic-matrix composites. 

---