Material properties monomers units

PVDF is mainly obtained by radical polymerisation of 1,1-difluoroethylene head to tail is the preferred mode of linking between the monomer units, but according to the polymerisation conditions, head to head or tail to tail links may appear. The inversion percentage, which depends upon the polymerisation temperature (3.5% at 20°C, around 6% at 140°C), can be quantified by F or C NMR spectroscopy [30] or FTIR spectroscopy [31], and affects the crystallinity of the polymer and its physical properties. The latter have been extensively summarised by Lovinger [30]. Upon recrystallisation from the melted state, PVDF features a spherulitic structure with a crystalline phase representing 50% of the whole material [32]. Four different crystalline phases (a, jS, y, S) may be identified, but the a phase is the most common as it is the most stable from a thermodynamic point of view. Its helical structure is composed of two antiparallel chains. The other phases may be obtained, as shown by the conversion diagram (Fig. 7), by applying a mechanical or thermal stress or an electrical polarisation. The / phase owns ferroelectric, piezoelectric and pyroelectric properties. 

Polymerization of propene by the Ziegler process gives a very useful plastic material. It can be made into durable fibers or molded into a variety of shapes. Copolymers (polymers with more than one kind of monomer unit in the polymer chains) of ethene and propene made by the Ziegler process have highly desirable rubberlike properties and are potentially the cheapest useful elastomers... 

These results indicate that the properties of the redox polymers, such as redox potentials and spectroscopic properties, can be varied systematically and, more importantly, can be predicted from those observed for mononuclear model compounds. As an example of the transfer of photochemical properties from monomeric analogues to the corresponding polymers, the photochemical behavior of the redox polymer [Ru(bpy)2(PVP)sCl]Cl will be considered. This polymer contains one metal center for every five-monomer units. Photolysis of a thin layer of this material on a glassy carbon surface leads to a change in the redox potential of the material from about 650 to 850 mV (See Figure 4.17) [32]. The voltammetric process affected is associated with a metal-center-based Ru(ll/m) redox process. By analogy to the behavior observed for the mononuclear species [Ru(bpy)2(py)Cl]+ (py = pyridine),... 

The example considered is the redox polymer, [Os(bpy)2(PVP)ioCl]Cl, where PVP is poly(4-vinylpyridine) and 10 signifies the ratio of pyridine monomer units to metal centers. Figure 5.66 illustrates the structure of this metallopolymer. As discussed previously in Chapter 4, thin films of this material on electrode surfaces can be prepared by solvent evaporation or spin-coating. The voltammetric properties of the polymer-modified electrodes made by using this material are well-defined and are consistent with electrochemically reversible processes [90,91]. The redox properties of these polymers are based on the presence of the pendent redox-active groups, typically those associated with the Os(n/m) couple, since the polymer backbone is not redox-active. In sensing applications, the redox-active site, the osmium complex in this present example, acts as a mediator between a redox-active substrate in solution and the electrode. In this way, such redox-active layers can be used as electrocatalysts, thus giving them widespread use in biosensors. 

---