Introduction Mass Spectrometry

Mass spectrometry allows analysis by hydrocarbon family for a variety of petroleum cuts as deep as vacuum distillates since we have seen that the molecules must be vaporized. The study of vacuum residues can be conducted by a method of direct introduction which we will address only briefly because the quantitative aspects are ek r metiy difficult to master. Table 3.6 gives some examples the matrices used differ according to the distillation cut and the chemical content such as the presence or absence of olefins or sulfur. 

In this discussion, only inert gases such as argon or neon are used as examples because they are monatomic, which simplifies description of the excitation. The introduction of larger molecules into a discharge is discussed in later chapters concerning examination of samples by mass spectrometry. 

The advent of atmospheric-pressure ionization (API) provided a method of ionizing labile and nonvolatile substances so that they could be examined by mass spectrometry. API has become strongly linked to HPLC as a basis for ionizing the eluant on its way into the mass spectrometer, although it is also used as a stand-alone inlet for introduction of samples. API is important in thermospray, plasmaspray, and electrospray ionization (see Chapters 8 and 11). 

To examine a sample by inductively coupled plasma mass spectrometry (ICP/MS) or inductively coupled plasma atomic-emission spectroscopy (ICP/AES) the sample must be transported into the flame of a plasma torch. Once in the flame, sample molecules are literally ripped apart to form ions of their constituent elements. These fragmentation and ionization processes are described in Chapters 6 and 14. To introduce samples into the center of the (plasma) flame, they must be transported there as gases, as finely dispersed droplets of a solution, or as fine particulate matter. The various methods of sample introduction are described here in three parts — A, B, and C Chapters 15, 16, and 17 — to cover gases, solutions (liquids), and solids. Some types of sample inlets are multipurpose and can be used with gases and liquids or with liquids and solids, but others have been designed specifically for only one kind of analysis. However, the principles governing the operation of inlet systems fall into a small number of categories. This chapter discusses specifically substances that are normally liquids at ambient temperatures. This sort of inlet is the commonest in analytical work. 

The use of mass spectrometry for the analysis of peptides, proteins, and enzymes has been summarized. This chapter should be read in conjunction with others, including Chapter 45, An Introduction to Biotechnology, and Chapters 1 through 5, which describe specific ionization techniques in detail. 

Hill, H.C., Introduction to Mass Spectrometry, Heyden, London, 1972. 

The main advantages of the ms/ms systems are related to the sensitivity and selectivity they provide. Two mass analyzers in tandem significantly enhance selectivity. Thus samples in very complex matrices can be characterized quickly with Htde or no sample clean-up. Direct introduction of samples such as coca leaves or urine into an ms or even a gc/lc/ms system requires a clean-up step that is not needed in tandem mass spectrometry (28,29). Adding the sensitivity of the electron multiplier to this type of selectivity makes ms/ms a powerhil analytical tool, indeed. It should be noted that introduction of very complex materials increases the frequency of ion source cleaning compared to single-stage instmments where sample clean-up is done first. 

A large number of silylating agents exist for the introduction of the trimethylsilyl group onto a variety of alcohols. In general, the sterically least hindered alcohols are the most readily silylated, but are also the most labile to hydrolysis with either acid or base. Trimethylsilylation is used extensively for the derivatization of most functional groups to increase their volatility for gas chromatography and mass spectrometry. 

Watson, J. T. Introduction to Mass Spectrometry. New York Raven Press, 1985. What is Mass Spectrometryl The American Society for Mass Spectrometry (ASMS), 815 Don Gaspar Drive, Santa Fe, NM 87501. 

Watson, J. T. Introduction to Mass Spectrometry Biomedical, Environmental Forensic Application. New York Raven Press, 1975. 

Every mass spectrometer consists of four principal components (Fig 1) (1) the source, where a beam of gaseous ions are produced from the sample (2) the analyzer, where the ion beam is resolved into its characteristic mass species (3) the detector, where the ions are detected and their intensities measured (4) the sample introduction system to vaporize and admit the sample into the ion source. There is a wide variety in each of these components and only those types which are relevant to analytical and organic mass spectrometry will be emphasized in this survey. The instrumentation... 

Kiser, Introduction to Mass Spectrometry and its Applications , Prentice-Hall, Englewood. 

Liquid Chromatography -Mass Spectrometry An Introduction. Robert E. Ardrey... 

Haddon, W. E. and Harden, L. A., Advantages of particle beam sample introduction for analysis of thermally sensitive natural products by mass spectrometry , in Proceedings of the 39th ASMS Conference on Mass Spectrometry and Allied Topics, Nashville, TN, May 19-24, 1991, pp. 1316-1317. 

Moens L, Verreft P, Boonen S, Vanhaecke F and Dams R (1995) Solid sampling electrothermal vaporization for sample introduction in inductively coupled plasma atomic emission spectrometry and inductively coupled plasma mass spectrometry. Spectrochim Acta 508 463-475. Mooijman KA, In t Veld PH, Hoekstra JA, Heisterkamp SH, Havelaar AH, Notermans SHW, Roberts D, Griepink B, Maier E (1992) Development of Microbiological Reference Materials. European Commission Report EUR 14375 EN, Community Bureau of Reference, Brussels. 

Gray AL (1985). Solid sample introduction by laser ablation for inductively coupled plasma source mass spectrometry. Analyst 110 551-556... 

---