Lyotropic mesophase formation mesophases

Drug molecules with amphiphilic character may form lyotropic mesophases, and amphiphilic excipients in drug formulations also form lyotropic liquid crystals. Especially surfactants, which are commonly used as emulsifiers in dermal formulations, associate to micelles after dissolution in a solvent. With increasing concentration of these micelles the probability of interaction between these micelles increases and thus the formation of liquid crystals. 

The chemical potentials measured so far do not allow the formulation of thermodynamic criteria for the formation of lyotropic mesophases. Some qualitative remarks, however, can be made. Of particular interest are Ekwall s studies of the relations between the water binding of the mesophases, their ionization, x-ray parameters, and vapor pressures (4). For common soaps at room temperature mesophases can be observed only in the presence of amounts of water that hydrate the ionic and polar groups. Hydration is therefore characteristic of aqueous lyotropic mesophases as well as micellar systems (1, 2, 3). The binding of counterions to the micelles and to the mesoaggregates seems to be of a similar electrostatic nature. The addition of NaCl greatly affects the lamellar phase D and, to a lesser extent, phase E in these phases the counterions are more strongly bound than by micelles in the solution... 

Hydrophobically modified polybetaines combine the behavior of zwitterions and amphiphilic polymers. Due to the superposition of repulsive hydrophobic and attractive ionic interactions, they favor the formation of self-organized and (micro)phase-separated systems in solution, at interfaces as well as in the bulk phase. Thus, glasses with liquid-crystalline order, lyotropic mesophases, vesicles, monolayers, and micelles are formed. Particular efforts have been dedicated to hydrophobically modified polyphosphobetaines, as they can be considered as polymeric lipids [5,101,225-228]. One can emphasize that much of the research on polymeric phospholipids was not particularly focused on the betaine behavior, but rather on the understanding of the Upid membrane, and on biomimicking. So, often much was learnt about biology and the life sciences, but little on polybetaines as such. 

Triphenylenes provided with nonionic di(ethylene oxide) side-chains (25f)132 134 or with ionic alkyl chains (25g)135 form supramolecular polymers in water.136 The arene—arene interactions of the aromatic cores allow for the formation of columnar micelles . At low concentrations the columns are relatively short, and the solutions are isotropic. At higher concentrations the longer columns interact and lyotropic mesophases are formed.133 Computer simulations showed that in the isotropic solution the polymerization of the discotics is driven by solute-solute attraction and follows the theory of isodesmic linear aggregation the association constants for dimerization, trimerization, and etc., are equal and the DP of the column thus can easily be tuned by concentration and temperature.137 138 At higher concentrations the sizes of the columns are influenced by their neighbors, the columns align, and the DP rises rapidly. 

Other amphiphilic cobalt(III) complexes were reported by Yashiro et al. [192] (Figure 106A) who measured the cmc to be at very low concentrations (3.3 X 10 moldm ) in water but did not report any mesophase formation, and by ourselves demonstrating lyotropic mesophases in surfactant ethylenediamine-based complexes including those of chromium (Figure 106B) [193]. 

As for low molecular weight surfactants, the superstructures are assumed to be formed by micellar aggregates [126], But it seems that the formation of lyotropic liquid crystals is supported by the additional presence of thermotropic mesogens [87,122-124,126], Lamellar, hexagonal, cubic and even nematic and cholesteric mesophases were reported for binary systems, the latter being exceptional. Lyotropic mesophases were also observed in non-aqueous solvents [240,400,401,405], If polymerizable surfactants are studied, not only the phase diagram but also the types of mesophases observed for the monomer and the polymer may be different. 

The photoinitiated polymerization of divinylbenzene (DVB) within four separate cubic phases of the system DVB/didodecyl dimethyl ammonium bromide (DDAB) is reported to yield retention of the lyotropic order during the course of the reaction [48], although the structure of the pure polymer matrix after removal of the template was not investigated. Similarly, polymerization of acrylamide within lamellar, hexagonal, and cubic phases of the surfactant Aerosol OT led to preservation of the parental mesostructure [49]. SAXS measurements showed similar diffractograms before and after polymerization, but again there was no report of characterization of the polymer matrix after surfactant removal. Hence, at least in these cases, the formation of a polymer phase within a lyotropic mesophase does not prevent the formation of lyotropic surfactant phases. 

Fig. 6. Scanning electron micrograph of a poly(acryl amide) gel templated in a lyotropic mesophase of CTMA-tartrate. The formation of a layer-like morphology is directed by the anisotropic reaction medium. Adapted with permission from [52]...

If more surfactant is added above the cmc, the concentration of micelles increases (rather than the concentration of free surfactant) until the micelle concentration becomes so high that they themselves organize to form ordered arrays of lyotropic liquid-crystal phase. There are several well-characterized lyotropic liquid-crystal phases and a host of so-called intermediate phases whose characterization is not unequivocal. While cmc values are typically found in the range lO -lO moldm, formation of lyotropic mesophases typically starts at around 20wt.% of the surfactant in water. 

The structure and arrangement of cellulosic chains play an important role in the formation of liquid crystals. At present, neither the conformation of cellulosics nor the solvent bound to the chain in the case of a lyotropic mesophase are known for these liquid-crystalline systems. Nevertheless, these structural features form the basis for a discussion of structural and thermodynamic aspects. Information on cellulosics is available for the two borderline cases next to the LC state, i.e., for the solvent built-in solid state as well as for the pure solid state, obtained by X-ray, NMR, and potential energy analysis on one side, and for the semi-dilute state from light-scattering experiments on the other side. These data have to be evaluated for a discussion of possible structures and models in liquid-crystalline phases. 

Only a few solvents are known to dissolve cellulose completely, and solid cellulose decomposes before melting. Therefore, it is difficult to study the mesophase behavior of cellulose. Chanzy et al. [32] reported lyotropic mesophases of cellulose in a mixture of jV-methyl-morpholine-Af-oxide and water (20-50%), but were unable to determine the nature of the mesophase. Lyotropic cholesteric mesophase formation in highly concentrated mixtures of cellulose in trifluoroa-cetic acid + chlorinated-alkane solvent [33] and in ammonia/ammonium thiocyanate solutions [34] has been studied, and although poor textures were obtained in the polarizing microscope, high optical rotatory power has been measured in an optical rotation (ORD) experiment, which could be fitted to the de Vries equation [Eq. (3)] for selective reflection beyond the visible wavelength region and was taken as proof of a lyotropic chiral nematic phase. 

We have shown elsewhere that sol-gel microparticle formation is one case in which soft matter is used to template the resulting porous material in a basic chemical strategy for making functional nanomaterials using lyotropic mesophases, foams and emulsion, that has been named by Ozin nanochemistry. "... 

In dependence on how the liquid crystalline phase is formed, lyotropic and thermotropic mesophases can be distinguished. Thermotropic mesophases are induced by temperature and require an anisometric shape of the mesogen. In contrast, amphiphilic molecules (e.g. surfactants) are able to form lyotropic mesophases in the presence of suitable solvents. The formation of lyotropic mesophases depends on the concentration of the mesogen as well as on the temperature. Furthermore, certain molecules may form both thermotropic and lyotropic mesophases (e.g. phospholipids ). 

---