Lithium aluminum hydride, reaction aldehydes

Lithium aluminum hydride, reaction with aldehydes, 610 reaction with carboxylic acids. 611-612... 

On the basis of what we have already learned about the reactions of lithium aluminum hydride with aldehydes and ketones (Chapter 18) and the mechanisms presented so far in this chapter, we can readily predict the product that results when hydride reacts with a carboxylic acid derivative. Consider, for example, the reaction of ethyl benzoate with lithium aluminum hydride. As with all of the reactions in this chapter, this reaction begins with attack of the nucleophile, hydride ion, at the carbon of the carbonyl group, displacing the pi electrons onto the oxygen (see Figure 19.7). Next, these electrons help displace ethoxide from the tetrahedral intermediate. The product of this step is an aldehyde. But recall from Chapter 18 that aldehydes also react with lithium aluminum hydride. Therefore, the product, after workup with acid, is a primary alcohol. 

Anet et al. ( 04) obtained in 1947 the alkaloids hygrine (191) and kusk-hygrine (192) in a very good yield by treatment of y-methylaminobutyralde-hyde with acetoacetic or acetonedicarboxylic acids at pH 7. The same reaction was later accomplished by Galinovsky et al. (305-307), who prepared the starting aldehyde by partial reduction of 1-methyl-2-pyrroli-done with lithium aluminum hydride. He used acetonedicarboxylic acid for the synthesis of both alkaloids and showed that a mixture of both alkaloids is formed, the composition of which depends on the ratio of components. 

The homology between 22 and 21 is obviously very close. After lithium aluminum hydride reduction of the ethoxycarbonyl function in 22, oxidation of the resultant primary alcohol with PCC furnishes aldehyde 34. Subjection of 34 to sequential carbonyl addition, oxidation, and deprotection reactions then provides ketone 21 (31% overall yield from (—)-33). By virtue of its symmetry, the dextrorotatory monobenzyl ether, (/ )-(+)-33, can also be converted to compound 21, with the same absolute configuration as that derived from (S)-(-)-33, by using a synthetic route that differs only slightly from the one already described. 

The lithium cnolate generated by deprotonation of 2-/m-butyl-6-methyl-l,3-dioxan-4-onc, readily available from polyhydroxybutyric acid (PHB), predominantly affords the diastereo-mers 7 when reacted with aldehydes. The diastereomeric ratios of aldol adducts 7/8, produced by reactions with aliphatic aldehydes, range from 87.5 12.5 to >99 1. Pure diastereoiners7are obtained by recrystallization in 25-74% yield116-118. Only marginal diastereoselectivities with respect to the carbinol center are obtained with aromatic aldehydes111-119. Benzoylation of the dioxanones 7, followed by reduction with lithium aluminum hydride, affords enan-tiomerically and diastereomerically pure triols 9 in >85% yield 11. ... 

Direct hydrogenation of key intermediate 248 over the Adams catalyst and subsequent lithium aluminum hydride reduction yielded the two stereoisomeric alcohols 256 and 257, which were separately transformed to ( )-corynantheal (258) and ( )-3-epicorynantheal (259), respectively, by Moffatt oxidation, followed by Wittig reaction with methyltriphenylphosphonium bromide and, finally, by demasking the aldehyde function (151, 152). 

Consider the reaction of an aldehyde with lithium aluminum hydride, LiAlH4, to produce an alcohol. Why is this reaction a reduction, not an oxidation ... 

The reaction of complex hydrides with carbonyl compounds can be exemplified by the reduction of an aldehyde with lithium aluminum hydride. The reduction is assumed to involve a hydride transfer from a nucleophile -tetrahydroaluminate ion onto the carbonyl carbon as a place of the lowest electron density. The alkoxide ion thus generated complexes the remaining aluminum hydride and forms an alkoxytrihydroaluminate ion. This intermediate reacts with a second molecule of the aldehyde and forms a dialkoxy-dihydroaluminate ion which reacts with the third molecule of the aldehyde and forms a trialkoxyhydroaluminate ion. Finally the fourth molecule of the aldehyde converts the aluminate to the ultimate stage of tetraalkoxyaluminate ion that on contact with water liberates four molecules of an alcohol, aluminum hydroxide and lithium hydroxide. Four molecules of water are needed to hydrolyze the tetraalkoxyaluminate. The individual intermediates really exist and can also be prepared by a reaction of lithium aluminum hydride... 

Chemical reduction of aromatic aldehydes to alcohols was accomplished with lithium aluminum hydride [5i], alane [770], lithium borohydride [750], sodium borohydride [757], sodium trimethoxyborohydride [99], tetrabutylam-monium borohydride [777], tetrabutylammonium cyanoborohydride [757], B-3-pinanyl-9-borabicyclo[3.3.1]nonane [709], tributylstannane [756], diphenylstan-nane [114], sodium dithionite [262], isopropyl alcohol [755], formaldehyde (crossed Cannizzaro reaction) [i7i] and others. 

Better reagents than lithium aluminum hydride alone are its alkoxy derivatives, especially di- and triethoxyaluminohydrides prepared in situ from lithium aluminum hydride and ethanol in ethereal solutions. The best of all, lithium triethoxyaluminohydride, gave higher yields than its trimethoxy and tris(/er/-butoxy) analogs. When an equimolar quantity of this reagent was added to an ethereal solution of a tertiary amide derived from dimethylamine, diethylamine, W-methylaniline, piperidine, pyrrolidine, aziridine or pyrrole, and the mixture was allowed to react at 0° for 1-1.5 hours aldehydes were isolated in 46-92% yields [95,1107], The reaction proved unsuccessful for the preparation of crotonaldehyde and cinnamaldehyde from the corresponding dimethyl amides [95]. 

Strong reducing agents like sodium borohydride and lithium aluminum hydride are capable of reducing aldehydes to primary alcohols and ketones to secondary alcohols. The general reaction is the reverse of the reactions used to form aldehydes and ketones by the oxidation of primary and secondary alcohols, respectively (to review, see the earlier section Oxidation reactions ). However, the mechanisms for reduction are different. 

N-Methylation of 3 and reduction of the crystalline oxazolidinone 4 with lithium aluminum hydride was found to give a superior yield of DAIB (5) and a more easily purified product than exhaustive methylation of 2 with methyl iodide and reduction of the quaternary methiodide with Super-Hydride. Recently, a modified version of DAIB, 3-exo-morpholinoisoborneol MIB), was prepared by Nugent that is crystalline and that is reported to give alcohols in high enantiomeric excess from the reaction of diethylzinc with aldehydes. ... 

Indian workers described the synthesis of l,3,4-thiadiazolo[3,2-a]-5-triazine-5(//)-thiones (61) by a hetero Diels-Alder reaction between 2-(arylideneamino)-5-ethylthio-l,3,4-thiadiazoles (60) and aromatic isothiocyanates (Equation (2)) <94MI 410-0I>. Thiadiazoles can be reduced with sodium amalgam to the aldehyde thiosemicarbazone while lithium aluminum hydride will reduce mesoionic thiadiazoles all the way to the hydrazine <84CHEC-I(4)545>. 

A carboxylic acid group may be introduced into the 2-position of dibenzofuran by Friedel-Crafts reaction with 2,2-dichloro-l,3-benzodioxole (catechol dichloromethylene ether) and hydrolysis of the resultant ester. Similarly, reaction with methylphenylcarbamoyl chloride produces the 2-(N-methyl-yV-phenylcarboxamide) or the 2,8-disubstituted derivative under more stringent conditions. Controlled reduction of these amides with lithium aluminum hydride supplies the corresponding aldehydes. ... 

The use of lithium aluminum hydride gives slightly lower yields and probably involves a displacement reaction by hydride ion. The zinc-copper couple technique probably involves formation of an organozinc intermediate. Sodium, magnesium, and aluminum metal may be used to replace the zinc-copper couple [59a, b]. These organometal intermediates react with aldehydes and... 

The iV-aminopyrrole - benzene ring methodology has been applied to a synthesis of the 9,10-dihydrophenanthrene juncusol (218) (81TL1775). Condensation of the tetralone (213) with pyrrolidine and reaction of the enamine with ethyl 3-methoxycarbonylazo-2-butenoate gave pyrrole (214). Diels-Alder reaction of (214) with methyl propiolate produced a 3 1 mixture of (215) and its isomer in 70% yield. Pure (215) was reduced selectively with DIBAL to the alcohol, reoxidized to aldehyde, and then treated with MCPBA to generate formate (216). Saponification to the phenol followed by O-methylation and lithium aluminum hydride reduction of the hindered ester afforded (217), an intermediate which had been converted previously to juncusol (Scheme 46). 

Reviews on stoichiometric asymmetric syntheses M. M. Midland, Reductions with Chiral Boron Reagents, in J. D. Morrison, ed., Asymmetric Synthesis, Vol. 2, Chap. 2, Academic Press, New York, 1983 E. R. Grandbois, S. I. Howard, and J. D. Morrison, Reductions with Chiral Modifications of Lithium Aluminum Hydride, in J. D. Morrison, ed.. Asymmetric Synthesis, Vol. 2, Chap. 3, Academic Press, New York, 1983 Y. Inouye, J. Oda, and N. Baba, Reductions with Chiral Dihydropyridine Reagents, in J. D. Morrison, ed., Asymmetric Synthesis, Vol. 2, Chap. 4, Academic Press, New York, 1983 T. Oishi and T. Nakata, Acc. Chem. Res., 17, 338 (1984) G. Solladie, Addition of Chiral Nucleophiles to Aldehydes and Ketones, in J. D. Morrison, ed., Asymmetric Synthesis, Vol. 2, Chap. 6, Academic Press, New York, 1983 D. A. Evans, Stereoselective Alkylation Reactions of Chiral Metal Enolates, in J. D. Morrison, ed., Asymmetric Synthesis, Vol. 3, Chap. 1, Academic Press, New York, 1984. C. H. Heathcock, The Aldol Addition Reaction, in J. D. Morrison, ed., Asymmetric Synthesis, Vol. 3, Chap. 2, Academic Press, New York, 1984 K. A. Lutomski and A. I. Meyers, Asymmetric Synthesis via Chiral Oxazolines, in J. D. Morrison, ed., Asymmetric Synthesis, Vol. 3, Chap. 

Nitriles can be reduced to amines by lithium aluminum hydride. An imine salt is an intermediate product if the reaction is carried out under the proper conditions, this salt is the major product and provides an aldehyde on hydrolysis (see Section 16-4C) ... 

Hydroxjrmethylbenzof Jthiophenes are most conveniently prepared by reduction with lithium aluminum hydride of the corresponding carboxylic acid78,100 S37 485,486,521,528,540 or ester.77,87,336,337, 52i, 526 Lesg frequently, they are prepared by reduction of the corresponding aldehyde 100,487 or acid chloride,618 with sodium boro-hydride, or, in the case of 2-hydroxymethylbenzo[6]thiophenes, by reaction of the 2-lithium derivative with formaldehyde.90,628 3-Hydroxymethylbenzo[6]thiophene has been prepared from the corresponding aldehyde by means of a crossed Cannizzaro reaction... 

---