Laser vaporization cluster temperature

The microscopic understanding of tire chemical reactivity of surfaces is of fundamental interest in chemical physics and important for heterogeneous catalysis. Cluster science provides a new approach for tire study of tire microscopic mechanisms of surface chemical reactivity [48]. Surfaces of small clusters possess a very rich variation of chemisoriDtion sites and are ideal models for bulk surfaces. Chemical reactivity of many transition-metal clusters has been investigated [49]. Transition-metal clusters are produced using laser vaporization, and tire chemical reactivity studies are carried out typically in a flow tube reactor in which tire clusters interact witli a reactant gas at a given temperature and pressure for a fixed period of time. Reaction products are measured at various pressures or temperatures and reaction rates are derived. It has been found tliat tire reactivity of small transition-metal clusters witli simple molecules such as H2 and NH can vary dramatically witli cluster size and stmcture [48, 49, M and 52]. 

Previously, intense beams of metal clusters could only be produced for the most volatile metals. The limitation arose from significant materials problems involved in the construction of high temperature ovens. The development of a source that utilizes laser vaporization and subsequent condensation in a rapidly flowing gas eliminated the materials problem and has enabled just about any material to be studi ed(la,8). 

The apparatus has been already described in Ref. [7]. The clusters are produced by laser vaporization of a sodium rod, with helium at about 5 bars as a carrier gas and a small amount of SF6. The repetition rate is 10 Hz. In this configuration, the vibrationnal temperature of the formed clusters is roughly 400 K,[10] that gives 85% of C2V geometry and 15% of C3V for a Boltzman distribution. The laser beams are focused onto the cluster beam between the first two plates of an axial Wiley Mac-Laren Time-Of-Flight mass spectrometer with a reflectron. The photoionization efficiency curve as well as the photoabsorption spectrum determined by a photodepletion experiement are displayed on Fig. 1(b) and 1(c) respectively. The ionization threshold is at 4.3 eV, close to the 4.4 eV calculated for the C3V isomer and 4.9 eV for the C2V isomer (see the Fig. 1 (b)). The conclusion arising out of the photodepletion spectrum shown on Fig 1(c) and from ab initio calculations of the excited states, [5] is that the observed... 

Since the demonstration by Schumacher et al ) of the use of alkali metal vapor inclusion into a supersonic beam to produce clusters, there have been a number of attempts to generalize the approach. It has recently been recognized that instead of high temperature ovens, with their concommitant set of complex experimental problems, an intense pulsed laser beam focused on a target could be effectively used to produce metal atoms in the throat of a supersonic expansion valve. ) If these atoms are injected into a high pressure inert gas, such as helium, nucleation to produce clusters occurs. This development has as its most important result that clusters of virtually any material now can be produced and studied with relative ease. 

The first MWNTs have been obtained as early as 1976 by iron-catalyzed pyrolysis of benzene. Apart from that, there is a number of methods to produce MWNT, which all of them differ in the way of generating small carbon clusters or atoms from the respective starting materials. They include arc discharge, laser ablation, chemical vapor deposition with and without plasma enhancement or the catalytic decomposition of various precursor compounds. It turned out that MWNTs from low-temperature syntheses bear more defects and, as a whole, are less ordered than those generated at high temperatures. However, these drawbacks can still be compensated by subsequent recuperation of defective samples at elevated temperatures. 

---