Ketene from oxidation

This method for the preparation of cyclobutanone via oxaspiropentane is an adaptation of that described by Salaiin and Conia. The previously known large-scale preparations of cyclobutanone consist of the reaction of the hazardous diazomethane with ketene, the oxidative degradation or the ozonization in presence of pjrridine of methylenecyclobutane prepared from pentaerythritol, or the recently reported dithiane method of Corey and Seebach, which has the disadvantage of producing an aqueous solution of the highly water-soluble cyclobutanone. A procedure involving the solvolytic cyclization of 3-butyn-l-yl trifluoro-methanesulfonate is described in Org. Syn., 54, 84 (1974). 

Claims 108 have been made for the formation of ketene from mixtures of hydrogen and carbon monoxide in the presence of such catalysts as the oxides of zinc, copper, or chromium, the chromates of zinc or copper, zinc aluminates, potassium zincate, or mixtures at temperatures below 400° to 450° C. and pressures of 200 atmospheres. 

Measured and calculated heats of formation of the corresponding radical cations from oxidation of ketene, methylketene, and dimethylketene were analyzed (Eqn (4.19)), and on average each methyl group lowered AfHby approximately 75 kj moP. However it was concluded that more precise experimental and computational values were needed regarding the methyl group effects on this oxidation. 

The elimination of alcohol from P-alkoxypropionates can also be carried out by passing the alkyl P-alkoxypropionate at 200—400°C over metal phosphates, sihcates, metal oxide catalysts (99), or base-treated zeoHtes (98). In addition to the route via oxidative carbonylation of ethylene, alkyl P-alkoxypropionates can be prepared by reaction of dialkoxy methane and ketene (100). 

Cmde diketene obtained from the dimeriza tion of ketene is dark brown and contains up to 10% higher ketene oligomers but can be used without further purification. In the cmde form, however, diketene has only limited stabHity. Therefore, especiaHy if it has to be stored for some time, the cmde diketene is distiHed to > 99.5% purity (124). The tarry distiHation residue, containing trike ten e (5) and other oligomers, tends to undergo violent Spontaneous decomposition and is neutralized immediately with water or a low alcohol. Ultrapure diketene (99.99%) can be obtained by crystallization (125,126). Diketene can be stabHized to some extent with agents such as alcohols and even smaH quantities of water [7732-18-5] (127), phenols, boron oxides, sulfur [7704-34-9] (128) and sulfate salts, eg, anhydrous copper sulfate [7758-98-7]. 

Petoxycatboxyhc acids have been obtained from the hydrolysis of stable o2onides with catboxyhc acids, pethydtolysis of acyhinida2ohdes, reaction of ketenes with hydrogen peroxide, electrochemical oxidation of alcohols and catboxyhc acids, and oxidation of catboxyhc acids with oxygen in the presence of o2one (181). 

Carbonyl Compounds. Cychc ketals and acetals (dioxolanes) are produced from reaction of propylene oxide with ketones and aldehydes, respectively. Suitable catalysts iaclude stannic chloride, quaternary ammonium salts, glycol sulphites, and molybdenum acetyl acetonate or naphthenate (89—91). Lactones come from Ph4Sbl-cataly2ed reaction with ketenes (92). 

General Reaction Chemistry of Sulfonic Acids. Sulfonic acids may be used to produce sulfonic acid esters, which are derived from epoxides, olefins, alkynes, aHenes, and ketenes, as shown in Figure 1 (10). Sulfonic acids may be converted to sulfonamides via reaction with an amine in the presence of phosphoms oxychloride [10025-87-3] POCl (H)- Because sulfonic acids are generally not converted directiy to sulfonamides, the reaction most likely involves a sulfonyl chloride intermediate. Phosphoms pentachlotide [10026-13-8] and phosphoms pentabromide [7789-69-7] can be used to convert sulfonic acids to the corresponding sulfonyl haUdes (12,13). The conversion may also be accompHshed by continuous electrolysis of thiols or disulfides in the presence of aqueous HCl [7647-01-0] (14) or by direct sulfonation with chlorosulfuric acid. Sulfonyl fluorides are typically prepared by direct sulfonation with fluorosulfutic acid [7789-21-17, or by reaction of the sulfonic acid or sulfonate with fluorosulfutic acid. Halogenation of sulfonic acids, which avoids production of a sulfonyl haUde, can be achieved under oxidative halogenation conditions (15). 

In 1959 Carboni and Lindsay first reported the cycloaddition reaction between 1,2,4,5-tetrazines and alkynes or alkenes (59JA4342) and this reaction type has become a useful synthetic approach to pyridazines. In general, the reaction proceeds between 1,2,4,5-tetrazines with strongly electrophilic substituents at positions 3 and 6 (alkoxycarbonyl, carboxamido, trifluoromethyl, aryl, heteroaryl, etc.) and a variety of alkenes and alkynes, enol ethers, ketene acetals, enol esters, enamines (78HC(33)1073) or even with aldehydes and ketones (79JOC629). With alkenes 1,4-dihydropyridazines (172) are first formed, which in most cases are not isolated but are oxidized further to pyridazines (173). These are obtained directly from alkynes which are, however, less reactive in these cycloaddition reactions. In general, the overall reaction which is presented in Scheme 96 is strongly... 

More definitive evidence for the formation of an oxirene intermediate or transition state was presented recently by Cormier 80TL2021), in an extension of his earlier work on diazo ketones 77TL2231). This approach was based on the realization that, in principle, the oxirene (87) could be generated from the diazo ketones (88) or (89) via the oxocarbenes 90 or 91) or from the alkyne (92 Scheme 91). If the carbenes (90) (from 88) and (91) (from 89) equilibrate through the oxirene (87), and if (87) is also the initial product of epoxidation of (92), then essentially the same mixture of products (hexenones and ketene-derived products) should be formed on decomposition of the diazo ketones and on oxidation of the alkyne this was the case. 

Dehydrochlorination of bis(tnfluoromethylthio)acetyl chloride with calcium oxide gives bis(trifluoromethylthio)ketene [5] (equation 6) Elimination of hydrogen chloride or hydrogen bromide by means of tetrabutylammonium or potassium fluoride from vinylic chlorides or bromides leads to acetylenes or allenes [6 (equation 7) Addition of dicyclohexyl-18-crown-6 ether raises the yields of potassium fluoride-promoted elimination of hydrogen bromide from (Z)-P-bromo-p-ni-trostyrene in acetonitrile from 0 to 53-71 % In dimethyl formamide, yields increase from 28-35% to 58-68%... 

The previous sections have dealt with stable C=N-I- functionality in aromatic rings as simple salts. Another class of iminium salt reactions can be found where the iminium salt is only an intermediate. The purpose of this section is to point out these reactions even though they do not show any striking differences in their reactivity from stable iminium salts. Such intermediates arise from a-chloroamines (133-135), isomerization of oxazolidines (136), reduction of a-aminoketones by the Clemmensen method (137-139), reductive alkylation by the Leuckart-Wallach (140-141) or Clarke-Eschweiler reaction (142), mercuric acetate oxidation of amines (46,93), and in reactions such as ketene with enamines (143). 

In context with the formation of peraminosubstituted 1,4,5,8-tetraazaful-valenes of type 85 it must be mentioned that the bis-vinylogous compounds 94 can be easily prepared by reaction of acetamidine with bisimidoylchlo-rides derived from oxalic acid (96S1302). In the course of a complex reaction a cyclic ketene aminal was produced it immediately underwent an oxidative dimerization to yield deeply colored TAFs. Tlieir high chemical stability can be compared with that of indigoid dyes and manifests itself, for example, by the fact that they are soluble in hot concentrated sulfuric acid without decomposition. Tire same type of fulvalene is also available by cy-... 

The use of ethyl ethylthiomethyl sulphoxide in this reaction leads to the desired addition products in much better yields (95-97%). These products were then converted into ketene dithioacetal monoxide derivatives 430 by a sequence of reactions (equation 258)505. Reaction of 2-lithio-l,3-dithiane-l-oxide with benzophenone affords a mixture of the diastereoisomeric tertiary alcohols 431 in a ratio which is temperature dependent (cis trans changes from 3 1 at — 78 °C to 1 1 at room temperature)268. 

Quantitative yields of allenes were obtained from keten and the stable phosphoranes (48). Addition of similar phosphoranes occurred at the j3-position of the allenic ketones (49) to give the phosphoranes (50). The compound (50 = COPh) eliminated phosphine oxide under the... 

The main synthetic application of the Wolff rearrangement is for the one-carbon homologation of carboxylic acids.242 In this procedure, a diazomethyl ketone is synthesized from an acyl chloride. The rearrangement is then carried out in a nucleophilic solvent that traps the ketene to form a carboxylic acid (in water) or an ester (in alcohols). Silver oxide is often used as a catalyst, since it seems to promote the rearrangement over carbene formation.243... 

Other non-traditional preparations of 1,2,3-triazoles have been reported. The rearrangement in dioxane/water of (Z)-arylhydrazones of 5-amino-3-benzoyl-l,2,4-oxadiazole into (2-aryl-5-phenyl-27/-l,2,3-triazol-4-yl)ureas was investigated mechanistically in terms of substituents on different pathways <06JOC5616>. A general and efficient method for the preparation of 2,4-diary 1-1,2,3-triazoles 140 from a-hydroxyacetophenones 139 and arylhydrazines is reported <06SC2461>. 5-Alkylamino-] //-], 2,3-triazoles were obtained by base-mediated cleavage of cycloadducts of azides to cyclic ketene acetals <06S1943>. Oxidation of N-... 

---