Ketene acetals 3+2 cycloaddition reactions

Scheeren et al. reported the first enantioselective metal-catalyzed 1,3-dipolar cycloaddition reaction of nitrones with alkenes in 1994 [26]. Their approach involved C,N-diphenylnitrone la and ketene acetals 2, in the presence of the amino acid-derived oxazaborolidinones 3 as the catalyst (Scheme 6.8). This type of boron catalyst has been used successfully for asymmetric Diels-Alder reactions [27, 28]. In this reaction the nitrone is activated, according to the inverse electron-demand, for a 1,3-dipolar cycloaddition with the electron-rich alkene. The reaction is thus controlled by the LUMO inone-HOMOaikene interaction. They found that coordination of the nitrone to the boron Lewis acid strongly accelerated the 1,3-dipolar cycloaddition reaction with ketene acetals. The reactions of la with 2a,b, catalyzed by 20 mol% of oxazaborolidinones such as 3a,b were carried out at -78 °C. In some reactions fair enantioselectivities were induced by the catalysts, thus, 4a was obtained with an optical purity of 74% ee, however, in a low yield. The reaction involving 2b gave the C-3, C-4-cis isomer 4b as the only diastereomer of the product with 62% ee. 

Diels-Alder reactions [31] and 1,3-dipolar cycloadditions [32, 33] have been performed by use of this methodology. For example, Diaz-Ortiz described the hetero-Diels-Alder and 1,3-dipolar cycloaddition reactions of ketene acetals. The reactions were improved and products were isolated directly from the crude reaction mixture without polymerization of the ketene acetals [34],... 

Bis-trifluoromethylthioketene 21 undergoes [2+2] cycloaddition reactions with olefins, vinyl ethers, vinyl thioethers and ketene acetals The reaction always proceeds across the C=S bond to give the thiethane derivatives 22. Some of the the cycloadducts are listed in Table 4.16. 

In 1959 Carboni and Lindsay first reported the cycloaddition reaction between 1,2,4,5-tetrazines and alkynes or alkenes (59JA4342) and this reaction type has become a useful synthetic approach to pyridazines. In general, the reaction proceeds between 1,2,4,5-tetrazines with strongly electrophilic substituents at positions 3 and 6 (alkoxycarbonyl, carboxamido, trifluoromethyl, aryl, heteroaryl, etc.) and a variety of alkenes and alkynes, enol ethers, ketene acetals, enol esters, enamines (78HC(33)1073) or even with aldehydes and ketones (79JOC629). With alkenes 1,4-dihydropyridazines (172) are first formed, which in most cases are not isolated but are oxidized further to pyridazines (173). These are obtained directly from alkynes which are, however, less reactive in these cycloaddition reactions. In general, the overall reaction which is presented in Scheme 96 is strongly... 

The hetero Diels-Alder [4+2] cycloaddition (HDA reaction) is a very efficient methodology to perform pyrimidine-to-pyridine transformations. Normal (NHDA) and Inverse (IHDA) cycloaddition reactions, intramolecular as well as intermolecular, are reported, although the IHDA cycloadditions are more frequently observed. The NHDA reactions require an electron-rich heterocycle, which reacts with an electron-poor dienophile, while in the IHDA cycloadditions a n-electron-deficient heterocycle reacts with electron-rich dienophiles, such as 0,0- and 0,S-ketene acetals, S,S-ketene thioacetals, N,N-ketene acetals, enamines, enol ethers, ynamines, etc. 

A quite different type of titanium catalyst has been used in an inverse electron-demand 1,3-dipolar cycloaddition. Bosnich et al. applied the chiral titanocene-(OTf)2 complex 32 for the 1,3-dipolar cycloaddition between the cyclic nitrone 14a and the ketene acetal 2c (Scheme 6.25). The reaction only proceeded in the presence of the catalyst and a good cis/trans ratio of 8 92 was obtained using catalyst 32, however, only 14% ee was observed for the major isomer [70]. 

The 2+2 cycloadditions of benzyne to cis- and trani-propenyl ether gave cis- and fran -benzocyclobntanes as the main products, respectively [ 117,118], Stereospecific [2+2] cycloaddition reactions were observed between the benzyne species generated by the halogen-Uthium exchange reaction of ort/io-haloaryl triflates and the ketene silyl acetals (Scheme 23) [119],... 

As expected, other enol ethers work well in these procedures. For example, Jones and Selenski find that implementation of method F, which occurs by addition of MeMgBr to benzaldehyde 5 in the presence of dihydropyran (DHP) at 78 °C affords a 66% yield of the corresponding tricyclic ketal 59 with better than 50 1 endo diastereoselectivity (Fig. 4.31).27 On the contrary, Lindsey reports use of method H with the benzyl alcohol 35 and diethylketene acetal. The cycloaddition reaction occurs almost instantaneously upon deprotonation of the benzyl alcohol 35 by f-butyl-magnesium bromide in the presence of the ketene acetal and yields the corresponding benzopyran ortho ester 60 in a 67% yield.29... 

Likewise, an efficient one-pot multicomponent synthesis of annelated 2-amino pyridines (e.g., 17) utilizing [4+2] cycloadditions has been described <06JOC3494>. The process involves the in situ generation of 1-aza-1,3-butadiene from a palladium-catalyzed coupling-isomerization reaction of aryl halides (e.g., 18) with propargyl V-tosylamines (e.g., 19). The resulting butadiene then undergoes cycloadditions with V.S -ketene acetals (e.g., 20) to form annelated pyridines (e.g., 17). 

The rather complex reactivity exhibited by cyclopropenones on interaction with enamines (see p. 74) is not re-found in the reactions of triafulvenes with enamines and ketene acetals. Instead of a (3 + 3) cycloaddition of enamine C=C—N sequence to the CI(2)/C3 bond of triafulvene (as represented by ylide 51 J) the addition of the enamine double bond to triafulvene C /C2 bond (operating with cyclopropenones only as a minor side-reaction) predominates in all reactions hitherto investigated. 

When the enantiomerically pure ketene acetal 16 was used, cycloaddition with N,a-diphenylnitrone (11) or chalcone (12) was achieved within 3 min in 98 and 96% yield, respectively. Under the same reaction conditions the use of classical heating in the absence of solvent at 120-124 °C for 3 min caused the yields to decrease to 3-4%. These results suggest that the excellent yields achieved by use of microwave irradiation are perhaps not entirely a result of the rapid heating of the reaction mass (Scheme 9.3). 

Theoretical calculations at DFT level agree that the reactions of nitrones with silyl ketene acetal proceeds via 1,3-dipolar cycloaddition followed by the transfer of the silyl group, yielding an open-chain product (641). 

The inverse-electron-demand Diels-Alder reaction of 3,6-dichloro[l,2,4,5]tetrazine with alkenes and alkynes provides the synthesis of highly functionalized pyridazines. ° Also, the 4 + 2-cycloaddition reactions of the parent [l,2,4,5]tetrazine with donor-substituted alkynes, alkenes, donor-substituted and unsubstituted cycloalkenes, ketene acetals, and aminals have been investigated. ... 

The structure of the a-methylenecyclopropanone ketal 185 is reminiscent of the addition mode of the corresponding TMM to C=0 [196]. The ester 186 is probably the product of silica-gel-catalyzed hydrolysis of the ketene acetal 187 (Figure 4.8), which is the expected product in the reaction ofTMM with electron-deficient olefins [197]. At higher temperatures 185 isomerizes into 187 [195], NMR spectroscopic investigations of these adducts reveal that the cycloadditions occur at the [6,6] double bonds. Analogous products to 185-187 have been observed for the reaction of the... 

Substituent groups can also participate in cyclization reactions, as shown by the [47t- -27t] cycloaddition between l,3-dimethyluracil-5-carboxaldehyde 487 and the ketene acetal 488 (Ar =/i-tolyl) <2003T341>. 

Among the most commonly applied chiral moiety for nitrones (2) is the N-a-methylbenzyl substituent (Scheme 12.6) (18-25). The nitrones 8 with this substituent are available from 1 -phenethylamine, and the substituent has the advantage that it can be removed from the resulting isoxazolidine products 9 by hydrogeno-lysis. This type of 1,3-dipole has been applied in numerous 1,3-dipolar cycloadditions with alkenes such as styrenes (21,23), allyl alcohol (24), vinyl acetate (20), crotonates (22,25), and in a recent report with ketene acetals (26) for the synthesis of natural products. Reviewing these reactions shows that the a-methylbenzyl group... 

Diels-Alder reactions have featured heavily during the period of review. Ar-Vinyl-2-oxazolidinone has been reported as a dienophile for the first time, including the preparation of various tetrahydro-277,77/-pyrano[4,3-. ]pyrans <2002SL952>. The heterodiene cycloaddition reaction of 3-formylchromone with a series of ketene acetals formed from C2-symmetric l,2-diarylethane-l,2-diols is completely diastereoselective (Scheme 40) <1995J(P1)2293>. 

One of the most reactive electrophilic alkenes is l,l-dicyano-2,2-bis(trifluoromethyl)ethene which undergoes cycloadditions with enol ethers, thioenol ethers, ketene acetals and thioacetals even at temperatures as low as — 78 °C. The cyclobutancs are formed as the sole products of the reaction.37-38 The reactions arc regiospecific and highly stereoselective even though evidence for zwitterionic intermediates have been obtained. 

Reactions of ketenes with electron-rich alkenes proceed more readily than with nonactivated alkenes and in the case of enol ethers, enol sulfides and ketene acetals, the cycloaddition is regiospecific (see Table 6). With tetraalkoxyethene, cycloaddition with the relatively inert ketene can be carried out 124 however, with less activated alkenes the use of metal catalysts such as zinc(ll) chloride is required for cycloaddition of the parent ketene.115... 

No reaction occurs with vinyl ethers, silyl enol ethers, or ketene silyl acetals, usually used in thermal [2 + 2]cycloaddition reactions, but the present case is the first example of the preparation of a chiral cyclobutanone by a cycloaddition route. 

Reaction of acrylonitrile with ketene acetals.3 Depending on the zinc salt and the solvent, ketene silyl acetals undergo [2+2]cycloaddition or a Michael-type addition with acrylonitrile. The former reaction occurs in CCU with ZnBr2, the latter in CH2C12 with Znl2, with no interconversion. 2-Chloroacrylonitrile can also be used in this way, but substituted acrylonitriles are inactive. 

---