Isomer solvents

Molecule Isomer Solvent aerated) (deaera ted) (deaera ted/aerated) IS0... 

A soln. of 2-carbomethoxy-2-cyclohexenone in chloroform added during 25 min to a mixture of startg. p-ketoester and 0.47 eqs. CS2CO3 in the same solvent at room temp., 2.5 h later CS2CO3 removed, and the crude product refluxed with / -TsOH in benzene product. Y 70% (99.5% cis-cis isomer). Solvent effects and reaction mechanisms s. P. Deslongchamps, J.-F. Lavallee, Tetrahedron Letters 29, 5117-8 (1988) 14a-hydroxysteroids by sequential Michael addition-intramolecular aldol condensation s. ibid. 6033-6. 

Startg. m. added dropwise at 0-5° during 10 min. to a stirred mixture of coned. H2SO4 and hexane, stirring continued 0.5 hr. at the same temp. 5,5,9-tri-methyl-2-decalone. Y 65% 93% trans- and 7% cw-isomer. Solvent effect on stereospecificity s. G. Ohloff et al., Helv. 56, 1414 (1973). 

The composition of the products from the isomerization of an unsaturated compound under the influence of a catalytic amount of a base is governed by the relative thermodynamic stabilities of the starting compound and the product. Of particular synthetic interest are isomerizations in which there is an accumulation of an isomer in the isomerization sequence. Isolation of the desired intermediate in a reasonable state of purity is often a matter of careful selection of the base and the solvent. The following reactions are representative examples ... 

Enone formation-aromatization has been used for the synthesis of 7-hydro-xyalkavinone (716)[456]. The isotlavone 717 was prepared by the elimina-tion[457]. The unsaturated 5-keto allyl esters 718 and 719, obtained in two steps from myreene. were subjected to enone formation. The reaction can be carried out even at room temperature using dinitriles such as adiponitrile (720) or 1,6-dicyanohexane as a solvent and a weak ligand to give the pseudo-ionone isomers 721 and 722 without giving an allylated product(458]. 

These methods are now obsolete in comparison with spectroscopic methods. Werbel has shown that the structures of these isomers are easily determined by NMR (125) (see also Table VI-5). Furthermore. 2-imino-4-thiazoline derivatives are characterized by their stretching C=N vibration at 1580 cm , absent in their 2-aminothiazole isomers, and by the stretching NH vibration that appears in the range of 3250 to 3310 cm for the former and between 3250 to 3340 cm" for the latter (131). Ultraviolet spectroscopy also differentiates these isomers (200). They can be separated by boiling in ethanol the thiazoline isomer is usually far less soluble in this solvent (131),... 

In the intermediate complexe of free radical arylation, it is necessary to oxidize the reaction intermediate to avoid dimerization and disporportio-nation (190-193, 346) In this case isomer yield and reactivity will be highest with radical sources producing very oxidative radicals or in solvents playing the role of oxidants in the reaction. The results are summarized in Tables III-29 and III-30. 

Bromination in polar solvents usually gives /n j -3,4-dibromo-2-methyl-3-buten-2-ol in nonpolar solvents, with incandescent light, the cis isomer is the principal product (194). Chlorine adds readily up to the tetrachloro stage, but yields are low because of side reactions (195). 

Unique adsorption selectivities are employed in the separation of Cg aromatic isomers, a classical problem that caimot be easily solved by distillation, crystallisation, or solvent extraction (10). Although -xylene [106-42-3] can be separated by crystallisation, its recovery is limited because of the formation of eutectic with / -xylene [108-58-3]. However, either -xylene, / -xylene, (9-xylene [95-47-6] or ethylbensene [100-41-4] can be extracted selectively by suitable modification of seoUtic adsorbents. 

Extraction of C-8 Aromatics. The Japan Gas Chemical Co. developed an extraction process for the separation of -xylene [106-42-3] from its isomers using HF—BF as an extraction solvent and isomerization catalyst (235). The highly reactive solvent imposes its own restrictions but this approach is claimed to be economically superior to mote conventional separation processes (see Xylenes and ethylbenzene). 

Fractional extraction has been used in many processes for the purification and isolation of antibiotics from antibiotic complexes or isomers. A 2-propanol—chloroform mixture and an aqueous disodium phosphate buffet solution are the solvents (243). A reciprocating-plate column is employed for the extraction process (154). 

Terpolymers from dimethy]-a.-methy]styrene (3,4-isomer preferred)—a-methylstyrene—styrene blends in a 1 1 1 weight ratio have been shown to be useful in adhesive appHcations. The use of ring-alkylated styrenes aids in the solubiHty of the polymer in less polar solvents and polymeric systems (75). Monomer concentrations of no greater than 20% and temperatures of less than —20° C are necessary to achieve the desired properties. 

---