Isocratic linear development

Isocratic linear development is the most popular mode of chromatogram development in analytical and preparative planar chromatography. It can be easily performed in horizontal chambers of all types. The mobile phase in the reservoir is brought into contact with the adsorbent layer, and then the movement of the eluent front takes place. Chromatogram development is stopped when the mobile phase front reaches the desired position. Usually 20 X 20 cm and 10 X 20 cm plates are applied for preparative separations, and this makes the migration distance equal to about 18 cm. Due to the fact that the migration distance varies with time according to the equation Z, = (Z, c, and t are the distance of the solvent front traveled, constant,... 

A simple and rapid RP-HPLC method was developed for the determination of retinoid in galenicals. Commercial preparations were diluted, filered and used for separation. Measurements were carried out in an ODS column (150 X 4.6 mm i.d. particle size 3 /xm). Solvents A and B were methanol-10 mM ammonium acetate (75 25, v/v) and methanol-THF (84 16, v/v), respectively. The flow rate was 0.8ml/min. Gradient conditions were 0-25 min, 0 per cent B 35 min, 100 per cent B, isocratic for 10 min. Typical chromatograms are shown in Fig. 2.37. The repeatability of peak area ranged between 0.48 -3.2 per cent for UV-DAD and 0.57 - 3.1 per cent for fluorescence detection. The reproducibility varied between 0.26 - 4.6 per cent. It was found that the method is precise, selective, sensitive and linear, therefore, it can be employed for the routine quality control of this class of drags [85],... 

Zarghi et al. [76] developed an HPLC method, using a monolithic column, for quantification of omeprazole in plasma. The method is specific and sensitive with a quantification limit of 10 ng/ml. Sample preparation involves simple, one-step extraction procedure, and analytical recovery was complete. The separation was carried out in reversed-phase conditions using a Chromolith Performance (RP-18e, 100 x 4.6 mm) column with an isocratic mobile phase consisting of 0.01 mol/1 disodium hydrogen phosphate buffer-acetonitrile (73 27) adjusted to pH 7.1. The wavelength was set at 302 nm. The calibration curve was linear over the concentration range 20-1500 ng/ml. The coefficients of variation for intra- and interday assay were found to be less than 7%. 

Sultana et al. [88] developed a reversed-phase HPLC method for the simultaneous determination of omeprazole in Risek capsules. Omeprazole and the internal standard, diazepam, were separated by Shim-pack CLC-ODS (0.4 x 25 cm, 5 m) column. The mobile phase was methanol-water (80 20), pumped isocratically at ambient temperature. Analysis was run at a flow-rate of 1 ml/min at a detection wavelength of 302 nm. The method was specific and sensitive with a detection limit of 3.5 ng/ml at a signal-to-noise ratio of 4 1. The limit of quantification was set at 6.25 ng/ml. The calibration curve was linear over a concentration range of 6.25—1280 ng/ml. Precision and accuracy, demonstrated by within-day, between-day assay, and interoperator assays were lower than 10%. 

An isocratic HPLC method for screening plasma samples for sixteen different non-steroidal anti-inflammatory drugs (including etodolac) has been developed [29]. The extraction efficiency from plasma was 98%. Plasma samples (100-500 pL) were spiked with internal standard (benzoyl-4-phenyl)-2-butyric acid and 1 M HC1 and were extracted with diethyl ether. The organic phase was separated, evaporated, the dry residue reconstituted in mobile phase (acetonitrile-0.3% acetic acid-tetrahydrofuran, in a 36 63.1 0,9 v/v ratio), and injected on a reverse-phase ODS 300 x 3.9 mm i.d. column heated to 40°C. A flow rate of 1 mL/min was used, and UV detection at 254 nm was used for quantitation. The retention time of etodolac was 30.0 minutes. The assay was found to be linear over the range of 0.2 to 100 pg/mL, with a limit of detection of 0.1 pg/mL. The coefficients of variation for precision and reproducibility were 2.9% and 6.0%, respectively. Less than 1% variability for intra-day, and less than 5% for inter-day, in retention times was obtained. The effect of various factors, such as, different organic solvents for extraction, pH of mobile phase, proportion of acetonitrile and THF in mobile phase, column temperature, and different detection wavelengths on the extraction and separation of analytes was studied. 

An HPLC method for the analysis of etodolac and its metabolites in equine serum and urine was developed [32]. Serum (1 mL) or urine (0.5 mL) samples were extracted with iso-octane/isopropanol (95 5, v/v) after addition of ibuprofen as internal standard, diluting with 1 or 2 mL of distilled water, and adjusting the pH to 1 with 1 M HC1. The organic layer was evaporated under a stream of nitrogen, the residue dissolved in 100 pL of mobile phase, and a 20 pL aliquot injected on to the HPLC system. The HPLC system consisted of a pre-column, a 250 x 4 mm (7 pm particles) LiChrosorb RP-18 column at 25°C, isocratic elution with 1% acetic acid/acetonitrile (50 50, v/v) at a flow rate of 1.3 mL/min, and UV detector at 227 nm. The retention time of etodolac was 8.5 minutes. The method was linear over the range of 0.1-20 pg/mL in serum, and in 0.5-800 pg/mL range in urine. The limits of quantitation were 40 ng/mL in... 

Reverse phase liquid chromatography has typically been used for the separation of PFCs, employing either Cg or Cig columns [96], although the use of perfluoroalkyl columns has also been reported [115]. Mobile phases are typically mixtures of methanol-water or acetonitrile-water and are often modified with ammonium acetate to improve chromatographic separation and MS sensitivity. Both isocratic and gradient elution methodologies have been employed [96]. LC-MS/MS methods [116, 117] have also been developed for the separation of PFSA and PFCA isomers and generally employ linear perfluorooctyl stationary phases and acidified mobile phases. 

Zhang et al. [43] developed and validated a stability indicating HPLC method for the determination of lornoxicam in pharmaceutical formulation. The isocratic procedure was performed in Shimadzu ODS (4.6 mm x 15 cm, 5 pm) column maintained at 25 °C. The mobile phase was degassed mixture of sodium acetate (0.05 mol/L, pH 5.8) and methanol (55 45). The flow rate was 1 ml/min and detection at 290 nm. Selectivity, specificity, linearity, precision, accuracy, and robustness were evaluated to validate the analytical method. Forced degradation studies were performed to provide an indication of the stability-indicating capacity. The stability indicating method for lornoxicam in the injectable dosage was developed and validated. The method can be considered for routine analysis and quality control of lornoxicam in injectable formulation. 

In theory, it is possible to derive the optimal conditions for gradient elution using a sodium hydroxide solution as the eluent from the representation of log(Fms-Vd)/Kd as a function of log R. However, as mentioned, this applies only to simple linear gradients with an initial eluent ion concentration of zero, which is rarely used for practical purposes. Much shorter analysis times are obtained when the gradient run starts at a higher eluent ion concentration. Furthermore, gradient programs with different ramps, sometimes combined with isocratic periods, have to be developed to obtain optimal selectivity and speed of analysis. A mathematical description of the retention is impossible... 

---